← New search

1997 Mitsubishi Eclipse Spyder

Owner reports · Recalls · Investigations

Limited comparison data

There is not enough comparable history to draw a useful model-year comparison.

About this comparison →

How this year compares

Owner complaints by model year

Other model years Selected year
Compare all Eclipse Spyder years →

Counts vary with age, sales and reporting. They are not failure rates.

What owners reported most

All reported categories

Tap a category to read its complaints. One report may name several components.

When problems were reported

Mileage at the reported incident

Limited mileage data: 14 of 20 reports include usable mileage. There isn’t enough coverage to show a useful chart.

NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.

What to inspect

Issues worth paying extra attention to based on owner reports.

  • Power Train. Review the 6 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Structure. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Engine And Engine Cooling. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

0 crash reports0 fire reports0 injury reports

Structure complaints

5 reports
Clear category filter
Mileage unknown · Nov 2, 2007
Structure

PAINT JOB DEFECTS. I HAVE OWNED SEVERAL MITSUBISHIS VEHICLES IN MY FAMILY. ALL RESULTING IN PAINT DEFECTS ON THE CAR. ONLY ONE HAS NOT, DEALERSHIP SAID BECAUSE THERE IS A DEFECT AND THAT ONE VEHICLE NOT AFFECTED WAS MADE AND PAINTED IN JAPAN. COST OF REPAINT OF VEHICLE IS $1500 TO $2500 DEPENDING ON WHERE YOU GO. *TR

NHTSA ODI #10207753

42,500 miles · May 2, 2005
Structure

CONVERTIBLE TOP WILL NOT OPEN ALL THE WAY. SUPPORT BRACKET IS BENT AND WILL NOT LET TOP LOWER COMPLETELY INTO HOUSING. THERE IS NO COMPLETE FIX FOR THIS. DEALER SAYS, THIS IS A MANUFACTURE DEFECT, SUPPORT BRACKETS ARE TO THIN FOR THIS TYPE OF TOP.

NHTSA ODI #10119399

47,000 miles · Feb 17, 2005
Structure

ROOF LEAKED & WOULD NOT FULLY RETRACT DUE TO DEFORMATION OF STRUCTURAL ROOF MEMBERS (ROOF PILLARS). REQUIRED REPLACEMENT OF 3 MAJOR ROOF MEMBERS PLUS INSTALLATION OF STRAPS (AS DEFINED IN TECHNICAL SERVICE BULLETIN). THIS WAS A STRUCTURAL FAILURE OF THE ROOF DESIGN KNOWN TO MITSUBISHI, BUT NO RECALL OR CONSUMER ALERT WAS COMMUNI…

Read full complaint

ROOF LEAKED & WOULD NOT FULLY RETRACT DUE TO DEFORMATION OF STRUCTURAL ROOF MEMBERS (ROOF PILLARS). REQUIRED REPLACEMENT OF 3 MAJOR ROOF MEMBERS PLUS INSTALLATION OF STRAPS (AS DEFINED IN TECHNICAL SERVICE BULLETIN). THIS WAS A STRUCTURAL FAILURE OF THE ROOF DESIGN KNOWN TO MITSUBISHI, BUT NO RECALL OR CONSUMER ALERT WAS COMMUNICATED.*JB

NHTSA ODI #10110684

58,000 miles · Jan 17, 2005
Structure

CONVERTIBLE LEAKING BY DRIVER AND PASSENGER AREA WHICH DRIPS ON POWER WINDOW /DOOR LOCK/WINDOW LOCK SWITCH. *JB

NHTSA ODI #10106450

6 miles · Apr 9, 2004
Structure

1997 MITSIBISHI CONVERTIBLE. BRACKETS ON BOTH SIDES OF CONVERTIBLE TOP HAVE BENT PREVENTING TOP FROM OPENING COMPLETELY. IT HAPPENS ON ALL CONVETIBLES OF THIS TYPE AND HAS ALREADY BEEN IDENTIFIED BY MANUFACTURER, HOWEVER, THEY WON'T DO ANYTHING ABOUT IT.*AK

NHTSA ODI #10065841

Official recalls

1

00V421001 · Suspension:front:control Arm:lower Ball Joint

Dec 18, 2000

VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.

Consequence & remedy

Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.

Remedy: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

0

No exact-year investigations in this snapshot.