IllustrationThe airbag cover on the passenger side is peeling off. I feel that if I tried to glue it or modify it in any way, this action could result in the airbag not deploying like it should and cause serious injury incase of an accident.
1997 Mitsubishi Eclipse Spyder
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Eclipse Spyder years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 14 of 20 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Power Train. Review the 6 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Structure. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
What owners actually said
20 reportsMY CAR IS A 1997 ECLIPSE SPYDER AUTOMATIC TRANNY 2.4L . THERE WAS ISSUES WITH THE TRANSMISSION IT WAS ON LEAN MODE, LOCKED ON 2ND GEAR AND IT COULD ONLY GO UP TO 40 MILES PER HR OTHER WISE THE RPM WERE VERY HIGH... *TR
TIRE TREAD SEPARATION ON PASSENGER CAR TIRES. BRAND = KUMHO LINE = ECSTA ASX SIZE = 225/40/R18 DOT # = YOMX YC2F WHILE DRIVING DOWN THE ROAD, MY SON NOTICED RUBBER CHUNKS FLYING FROM THE FRONT END OF HIS CAR. WHEN HE STOPPED TO CHECK THINGS OVER, HE FOUND THAT THE TREAD OF ONE OF THE FRONT…
Read full complaint
TIRE TREAD SEPARATION ON PASSENGER CAR TIRES. BRAND = KUMHO LINE = ECSTA ASX SIZE = 225/40/R18 DOT # = YOMX YC2F WHILE DRIVING DOWN THE ROAD, MY SON NOTICED RUBBER CHUNKS FLYING FROM THE FRONT END OF HIS CAR. WHEN HE STOPPED TO CHECK THINGS OVER, HE FOUND THAT THE TREAD OF ONE OF THE FRONT TIRES WAS SEPARATING RIGHT DOWN TO THE BASE CORDS OF THE TIRE. THE SEPARATION OCCURRED ON JUST ONE EDGE OF THE TREAD AND WAS BEING UN-SPOOLED FROM THE TIRE. I AM REPORTING THIS SO THAT IT MAY BE DOCUMENTED FOR FUTURE REFERENCE IN THE NHTSA DATABASE. *TR
PAINT JOB DEFECTS. I HAVE OWNED SEVERAL MITSUBISHIS VEHICLES IN MY FAMILY. ALL RESULTING IN PAINT DEFECTS ON THE CAR. ONLY ONE HAS NOT, DEALERSHIP SAID BECAUSE THERE IS A DEFECT AND THAT ONE VEHICLE NOT AFFECTED WAS MADE AND PAINTED IN JAPAN. COST OF REPAINT OF VEHICLE IS $1500 TO $2500 DEPENDING ON WHERE YOU GO. *TR
COOLANT TANK CRACKED LEADING TO LOSS OF OVERFLOW COOLANT AND POTENTIAL ENGINE FAILURE FROM OVERHEATING. MITSUBISHI NO LONGER MAKES A REPLACEMENT PART. *JB
SPEED CONTROL ISSUE, GAS PEDAL STICKING, CAR CONSISTENTLY IDLES BETWEEN 1500 TO 3000 RPMS ENGINE REVVING UP AND DOWN WHILE AT A STOP AND WHILE IN PARK. MANUAL SHIFT VERY STIFF. *JB
1997 MITSUBISHI ECLIPSE SPYDER CATASTROPHIC FAILURE OF CLUTCH. THE LINE THAT RUNS FROM THE SLAVE CYLINDER TO THE MASTER CYLINDER HAS WHAT APPEARS TO BE A CUT IN THE LINE 1MM FROM THE CONNECTION TO THE MASTER CYLINDER. I HAVE NOW REPLACED THIS LINE SIX (6) TIMES IN TWO YEARS. FAILURE USUALLY OCCURS AFTER DRIVING THE CAR AT HI…
Read full complaint
1997 MITSUBISHI ECLIPSE SPYDER CATASTROPHIC FAILURE OF CLUTCH. THE LINE THAT RUNS FROM THE SLAVE CYLINDER TO THE MASTER CYLINDER HAS WHAT APPEARS TO BE A CUT IN THE LINE 1MM FROM THE CONNECTION TO THE MASTER CYLINDER. I HAVE NOW REPLACED THIS LINE SIX (6) TIMES IN TWO YEARS. FAILURE USUALLY OCCURS AFTER DRIVING THE CAR AT HIGHWAY SPEEDS FOR 2 OR MORE HOURS. CLUTCH GOES TO THE FLOOR DUE TO LOSS OF FLUID. I HAVE ALSO REPLACED THE MASTER CYLINDER TWICE & THE SLAVE CYLINDER THREE TIMES, THE LAST TIME WAS 2 WEEKS AGO. *NM
CAR FAILS MANDATORY OBD-II SMOG TEST DUE TO NON-CONTINUOUS READINESS MONITORS FAILING TO SET TO COMPLETE DURING NORMAL DRIVING. DEALER MUST USE MUT-II DIAGNOSTIC TOOL TO SET MONITORS TO READY STATE. WHEN DIAGNOSTIC MODE IS EXITED AND IGNITION TURNED OFF MONITORS REVERT TO NOT-READY STATE. PROBLEM COMMON TO 1997 MITSUBISHI ECLIPS…
Read full complaint
CAR FAILS MANDATORY OBD-II SMOG TEST DUE TO NON-CONTINUOUS READINESS MONITORS FAILING TO SET TO COMPLETE DURING NORMAL DRIVING. DEALER MUST USE MUT-II DIAGNOSTIC TOOL TO SET MONITORS TO READY STATE. WHEN DIAGNOSTIC MODE IS EXITED AND IGNITION TURNED OFF MONITORS REVERT TO NOT-READY STATE. PROBLEM COMMON TO 1997 MITSUBISHI ECLIPSE GST ACCORDING TO DEALER. NO REMEDY AVAILABLE. CAR DOES NOT MEET FEDERAL EMISSION REQUIREMENTS.*JB
TRANSMISSION WAS SLIPPING SO I STOP DRIVING IT. WHEN I TESTED IT OUT AGAIN, IT WAS EVEN WORST AND I CAN'T EVEN GO PAST 40 MPH. SO FAR THERE HASN'T BEEN ANY REPAIRS DONE TO THE CAR SINCE I WAS TOLD BY A MECHANIC THAT THERE ARE TRANSMISSION RECALLS ON THE AUTOMATIC 97 GS ECLIPSE AND WAS ADVISE NOT TO DRIVE IT ANYMORE BECAUSE IT …
Read full complaint
TRANSMISSION WAS SLIPPING SO I STOP DRIVING IT. WHEN I TESTED IT OUT AGAIN, IT WAS EVEN WORST AND I CAN'T EVEN GO PAST 40 MPH. SO FAR THERE HASN'T BEEN ANY REPAIRS DONE TO THE CAR SINCE I WAS TOLD BY A MECHANIC THAT THERE ARE TRANSMISSION RECALLS ON THE AUTOMATIC 97 GS ECLIPSE AND WAS ADVISE NOT TO DRIVE IT ANYMORE BECAUSE IT CAN RESULT IN A ACCIDENT. DID A LITTLE RESEARCH ONLINE AND FOUND OUT THAT THIS CAR DOES HAVE A RECALL ON THE AUTOMATIC TRANSMISSION. HTTP://WWW.AUTOSITE.COM/CONTENT/OWN/SERVICE/INDEX.CFM/ACTION/RECALLSVIEW/SERIESID/509. *NM
CONVERTIBLE TOP WILL NOT OPEN ALL THE WAY. SUPPORT BRACKET IS BENT AND WILL NOT LET TOP LOWER COMPLETELY INTO HOUSING. THERE IS NO COMPLETE FIX FOR THIS. DEALER SAYS, THIS IS A MANUFACTURE DEFECT, SUPPORT BRACKETS ARE TO THIN FOR THIS TYPE OF TOP.
Official recalls
100V421001 · Suspension:front:control Arm:lower Ball Joint
Dec 18, 2000
VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.
Consequence & remedy
Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.
Remedy: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.