IllustrationFIRESTONE, P245/75R16, DOT UNKNOWN. ORIGINAL EQUIPMENT ON A 1998, ROADTREK CONVERSION VAN WITH 32000 MILES. WHILE DRIVING 55 MPH, VEHICLE WAS HARD TO CONTROL, PULLED OVER AND NOTICED TREAD SEPARATION ON RIGHT FRONT TIRE. *AK *SLC
1998 Home And Park Roadtrek
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Roadtrek years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 4 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Tires. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Fuel System, Gasoline. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
What owners actually said
4 reportsPE 00 020/TIRE TREAD SEPARATION: ON TWO DIFFERENT INCIDENTS VEHICLE EXPERIENCED A TREAD SEPARATION WHILE TRAVELING; FIRST, AT 22,700 MILES, LEFT REAR TIRE AT 60-65 MPH, AND SECOND, AT 25,300 MILES, RIGHT REAR TIRE AT 70 MPH. ALL ORIGINAL EQUIPMENT ON A 1998, HOME AND PARK, ROADTREK 200, TIRE SIZE LT245/75R16 AND DOT# UNAVAI…
Read full complaint
PE 00 020/TIRE TREAD SEPARATION: ON TWO DIFFERENT INCIDENTS VEHICLE EXPERIENCED A TREAD SEPARATION WHILE TRAVELING; FIRST, AT 22,700 MILES, LEFT REAR TIRE AT 60-65 MPH, AND SECOND, AT 25,300 MILES, RIGHT REAR TIRE AT 70 MPH. ALL ORIGINAL EQUIPMENT ON A 1998, HOME AND PARK, ROADTREK 200, TIRE SIZE LT245/75R16 AND DOT# UNAVAILABLE. FIRESTONE CENTER NOTIFIED AND PORATED THE EXCHANGE TIRES. *AK
CONSUMER PURCHASED VEHICLE WITHOUT KNOWLEDGE OF RECALL (99V-335), CONSUMER FEELS THAT THE RECALL REPAIR SHOULD HAVE BEEN COMPLETED BY THE DEALERSHIP PRIOR TO DELIVERY. *MJS
TRANSMISSION MALFUNCTIONS. YH
Official recalls
299V335000 · Fuel System, Gasoline:storage:tank Assembly:filler Pipe And Cap
Nov 26, 1999
VEHICLE DESCRIPTION: CLASS B MOTOR HOMES BUILT ON DODGE 3500 OR 2500 VAN CHASSIS. THE GENERATOR FUEL PICKUP FITTING WAS SELF TAPPED INTO A DRILLED HOLE BESIDE THE FUEL SENDING UNIT ON TOP OF THE PLASTIC FUEL TANK. SEALANT WAS USED ON THE THREAD BEFORE THE FITTING WAS SCREWED INTO THE TANK. ON SOME VEHICLES, THE FUEL PICKUP FITTING WAS NOT SEALED PROPERLY AGAINST THE TANK WALL, AND WHEN THE TANK IS FULL, FUEL OR FUEL VAPORS CAN LEAK OUT.
Consequence & remedy
Consequence: IN A CRASH, FUEL OR FUEL VAPORS CAN LEAK WHEN THE TANK IS FULL, INCREASING THE RISK OF A FIRE.
Remedy: DEALERS WILL REPLACE THE SELF TAPPING FUEL PICKUP WITH A NEW ONE WITH REGULAR THREAD FITTING SECURED TO THE TANK WITH A LOCK NUT INSIDE THE TANK.
98V136000 · Fuel System, Gasoline:storage:tank Assembly:filler Pipe And Cap
Jun 22, 1998
VEHICLE DESCRIPTION: CLASS 'B' MOTOR HOMES BUILT ON DODGE 1500, 2500 AND 3500 VAN CHASSIS. THE FUELVENT HOSE FROM THE FUEL TANK TO THE FUEL FILL ENTRY MAY NOT BE VAPOR TIGHT DUE TO OVER TIGHTENING OF THE GEAR CLAMP AT THE CONNECTION OF THE PLASTIC VENT TANK OUTAGE TO THE RUBBER VENT HOSE. THIS CAN RESULT IN FUEL OR FUEL VAPOR LEAKING.
Consequence & remedy
Consequence: THIS CONDITION CAN CAUSE FUEL OR FUEL VAPOR LEAKING RESULTING IN A POTENTIAL FIRE HAZARD. ALSO THE ENGINE COULD STALL FROM LACK OF FUEL, RESULTING IN LOSS OF POWER BRAKING AND POWER STEERING CONTROL.
Remedy: DEALERS WILL REMOVE THE GEAR CLAMP SECURING THE RUBBER VENT HOSE TO THE PLASTIC VENT TUBE, INSTALL A RIGID INSERT TUBE INTO THE PLASTIC VENT TUBE, AND REATTACH THE HOSE AND CLAMP. THE RIBERGLASS COVER IN THE RUNNING BOARD STORAGE COMPARTMENT MUST FIRST BE REMOVED FOR ACCESS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.