Fuel/propulsion System. Review the 58 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Engine. Review the 13 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Vehicle Speed Control. Review the 12 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

8 crash reports0 fire reports4 injury reports

Wheels complaints

2 reports

Clear category filter

38,000 miles · Mar 1, 2019

Power TrainWheels

Read full complaint

WHILE AT HIGHWAY SPEED, 65MPH, FRONT BELT PULLEY BOLT BROKE CAUSING PULLEY TO DISLODGE. CAUSES BELT TO WRAP AROUND SHAFT AND JAM LOCKING REAR WHEEL. LUCKILY THE PULLEY DID NOT FALL OFF BELT GUARD AND HIT MYSELF OR ANY OTHER VEHICLES. THIS HAS NOT BEEN ADJUSTED DUE TO NOT NEEDING NEW BELT, AND WAS AT SAME SPECS FROM FACTORY. UPON RESEARCH, FOUND MULTIPLE OWNERS SAME YEAR HAVING SAME FAILURES. SO FAR NO ONE HAS WRECKED OR CAUSED INJURY, HOWEVER HAD I BEEN INEXPERIENCED I LIKELY WOULD HAVE. UPON CONTACTING MY LOCAL DEALER WHERE PURCHASED I WAS TOLD THAT HUMIDITY COULD WEAKEN THE BOLT AND CAUSE FAILURE. THIS WAS FEB 27 @ 1330. WAS TOLD I WOULD HAVE TO PAY FOR DIAGNOSTICS AND REPAIR. I'M SURPRISED THAT HUMIDITY COULD BE BLAMED FOR FAILURE, AND THEN HAVE TO PAY FOR REPAIR. I OPTED TO REMOVE BROKEN BOLT ON OWN WITH BASIC TOOLS PREVIOUSLY . DID NOT WANT TO ASSIST IN WORKING WITH MAIN MANUFACTURER OR INVESTIGATE THE MULTIPLE FAILURES.

NHTSA ODI #11183385

2,356 miles · Aug 20, 2018

SteeringWheels

Read full complaint

WHILE RIDING AT LOW SPEED ON CITY STREETS, THE STEERING FELT UNUSUALLY TIGHT. UPON ARRIVING HOME, I LIFTED THE FRONT WHEEL OFF OF THE GROUND AND CONFIRMED THAT SOMETHING WAS BINDING IN THE STEERING HEAD, CAUSING INCREASED STEERING EFFORT AND A "NOTCHY" FEELING. I DEEMED THE MOTORCYCLE UNSAFE TO RIDE. SEVERAL DAYS LATER, I DISASSEMBLED THE STEERING HEAD ASSEMBLY TO INSPECT THE BEARINGS AND FOUND EVIDENCE OF WATER INTRUSION. I FOUND THE UPPER BEARING SLIGHTLY RUSTED AND THE LOWER BEARING SUBSTANTIALLY RUSTED, AND DETERMINED THE RUSTED BEARINGS TO BE THE CAUSE OF THE BINDING. WHILE DISASSEMBLING THE MOTORCYCLE, I DISCOVERED THAT ONE FRONT WHEEL BEARING FELT ROUGH. UPON REMOVING AND DISASSEMBLING THE DEFECTIVE WHEEL BEARING, I FOUND IT TO BE RUSTED INTERNALLY. THIS MOTORCYCLE IS THREE YEARS OLD AND HAS ONLY 2,356 MILES ON THE ODOMETER, AND IT REQUIRES NEW STEERING HEAD BEARINGS AND FRONT WHEEL BEARINGS.

NHTSA ODI #11121180

Official recalls

15V474000 · Fuel System, Gasoline:delivery:fuel Pump

Jul 29, 2015

Harley-Davidson Motor Company (Harley-Davidson) is recalling certain model year 2015 XG500 motorcycles manufactured January 20, 2014, to July 7, 2015, and XG750 motorcycles manufactured May 12, 2014, to July 7, 2015. The fuel pump modules on these motorcycles have a poor seal at the fuel pump inlet.

Consequence & remedy

Consequence: If there is a poor seal at the fuel pump inlet it can cause interruption to the fuel supply, possibly causing a brief hesitation with the abrupt restoration of power. This abrupt restoration of power can lead to loss of control, increasing the risk of a crash.

Remedy: Harley-Davidson will notify owners, and dealers will install a new fuel pump assembly, free of charge. The recall began on August 21, 2015. Owners may contact Harley-Davidson customer service at 1-414-343-4056. Harley-Davidson's number for this recall is 0167.

15V217000 · Exterior Lighting; Visibility

Apr 13, 2015

Harley-Davidson Motor Company (Harley-Davidson) is recalling certain model year 2015 XG500 motorcycles manufactured January 28, 2014, to March 9, 2015, and 2015 XG750 motorcycles manufactured May 12, 2014, to March 9, 2015. The affected motorcycles may have been manufactured without a rear reflector assembly. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

Consequence & remedy

Consequence: If the motorcycle is missing the rear reflector it can reduce the vehicle's visibility to other drivers, increasing the risk of a crash.

Remedy: Harley-Davidson will notify owners, and dealers will install a rear reflector assembly, free of charge. The recall began on April 29, 2015. Owners may contact Harley-Davidson customer service at 1-800-258-2464. Harley-Davidson's number for this recall is 0620.

Additional source detail variants (2)

Exterior Lighting

Consequence: If the motorcycle is missing the rear reflector it can reduce the vehicle's visibility to other drivers, increasing the risk of a crash.

Remedy: Harley-Davidson will notify owners, and dealers will install a rear reflector assembly, free of charge. The recall began on April 29, 2015. Owners may contact Harley-Davidson customer service at 1-800-258-2464. Harley-Davidson's number for this recall is 0620.

Visibility

Consequence: If the motorcycle is missing the rear reflector it can reduce the vehicle's visibility to other drivers, increasing the risk of a crash.

14V536000 · Fuel System, Gasoline:storage:tank Assembly:filler Pipe And Cap

Sep 5, 2014

Harley-Davidson Motor Company (Harley-Davidson) is recalling certain model year 2015 XG500 and XG750 motorcycles manufactured June 11, 2014, to August 14, 2014. The fuel tank filler neck may be insufficiently flat, preventing the fuel cap from sealing properly.

Consequence & remedy

Consequence: If the fuel cap doesn't properly seal, fuel may leak, increasing the risk of a vehicle fire.

Remedy: Harley-Davidson will notify owners, and dealers will inspect the motorcycle and test to see if fuel can leak from under the fuel cap. Any motorcycle that leaks fuel from under the fuel cap will have its gas tanked replaced, free of charge. The recall began in late September 2014. Owners may contact Harley-Davidson customer service at 1-800-258-2464. Harley-Davidson's number for this recall is 0161.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE15015 · Inconsistent Throttle Response

Opened Apr 20, 2015 · Closed Aug 18, 2015

Status: closed (inferred from source dates) · Fuel System, Gasoline:delivery

This investigation was opened on April 20, 2015 to investigate reports of inconsistent throttle control on all MY 2015 HD XG750 and XG500 motorcycles.At the time, ODI had 14 consumer complaints and no crashes reported.At the time of closing this investigation ODI has 51 reports (6 of which allege a crash occurred). In addition to requesting information from Harley-Davidson (HD), ODI interviewed complainants and dealer service/parts department personnel.ODI staff also test rode one of the crash bikes to experience the alleged condition first-hand.At low fuel levels (typically below .8 gallon), the engine may stumble and/or stall when fuel flow from the pump to engine is interrupted.This is due to a poor seal at the fuel pump inlet. Ultimately, HD decided to recall (15V-474) the affected motorcycles (MY 2015 XG500 and XG750 produced 1-20-14 through 6-24-15) to install a new fuel pump assembly.With the recall, our information request is moot and this PE is closed.