THE 5 BOLTS THAT CONNECT THE BELT PULLEY TO THE REAR WHEEL SHEARED OFF COMPLETELY. I WAS DRIVING DOWN A CITY STREET. I HAD JUST TAKEN OFF FROM A STOP LIGHT, SHIFTED FROM 3RD TO 4TH GEAR AND NOTHING HAPPENED. THE BIKE WOULD NOT GRAB AND GO FORWARD. I TRIED TO SHIFT DOWN AND GIVE GAS AGAIN AND NOTHING. I WAS GOING BETWEEN 40-50MPH…
Read full complaint
THE 5 BOLTS THAT CONNECT THE BELT PULLEY TO THE REAR WHEEL SHEARED OFF COMPLETELY. I WAS DRIVING DOWN A CITY STREET. I HAD JUST TAKEN OFF FROM A STOP LIGHT, SHIFTED FROM 3RD TO 4TH GEAR AND NOTHING HAPPENED. THE BIKE WOULD NOT GRAB AND GO FORWARD. I TRIED TO SHIFT DOWN AND GIVE GAS AGAIN AND NOTHING. I WAS GOING BETWEEN 40-50MPH. LUCKILY I WAS ABLE TO COAST TO THE SHOULDER OF THE ROAD UNHARMED. I GOT OFF MY BIKE AND BEGAN TO INSPECT IT WHEN I SAW A LARGE BOLT ON THE GROUND. I PICKED IT UP AND REALIZED IT WAS HOT SO IT MUST HAVE COME OFF MY BIKE. A FELLOW MOTORCYCLE RIDER PULLED OVER TO MAKE SURE I WAS OK AND HELPED ME DETERMINE WHERE THE BOLTS CAME FROM AND WHY I COULD NOT GET MY BIKE INTO GEAR. THIS IS WHEN I REALIZED THEY WERE ALL GONE. THE REAR WHEEL, PULLEY AND SWING ARM WHERE DAMAGED IN THE PROCESS. THIS CAUSES A CATASTROPHIC FAILURE IN THE ENTIRE DRIVE SYSTEM OF THE MOTORCYCLE. THERE IS A KNOWN ISSUE WITH THE POWDER COATING ON THE PULLEY CAUSING THIS TO HAPPEN HOWEVER VICTORY HAS TAKEN NO STEPS TO FIX THIS ISSUE. LUCKILY FOR ME I DID NOT WRECK OR DIE DUE TO THIS ISSUE. HOWEVER I HAVE TALKED WITH OVER 20 PEOPLE ON A FORUM THAT HAVE HAD THE SAME EXACT CATASTROPHIC FAILURE TO THEIR BIKES. IT IS NOT LIMITED TO ONE MODEL OR YEAR. VICTORY IS TAKING NO RESPONSIBILITY IN THIS ISSUE AND THE COST IS FALLING TO THE CONSUMER. MUST NEED TO BE ABLE TO PROVE SOMEONE HAS DIED BEFORE THEY WILL TAKE ACTION.
Polaris is recalling certain model year 2012-2013 Victory motorcycles manufactured from January 3, 2012, through August 15, 2012. A torqueing procedure may have been missed on some throttle cable retention nuts. On certain motorcycles, the throttle cable retention nuts for either the pull or push throttle cable may have not been torqued correctly.
Consequence & remedy
Consequence: If the torqueing is missed and the retention nuts are loose, the retention nuts closest to the throttle body can become dislodged and interfere with the throttle function, increasing the risk of a crash.
Remedy: Victory will notify owners and dealers will correctly torque the fasteners free of charge. The safety recall began on October 4, 2012. Owners may contact Victory consumer service department by calling 1-888-704-5290.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2013 Victory Judge Problems, Complaints & Recalls | Skip That Year