2024 Toyota Crown

When vehicles comes to a stop, sometimes there is a hesitation in vehicle acceleration. Vehicle will jerk, then accelerate 3-4 seconds after pressing down throttle. Car does not provide or show error codes. There is currently a Toyota Service Bulletin for the exact same issue for the Toyota highlander (TSB-0017-24) which address the issue "Hesitation felt while accelerating at low speeds." And the fix involves a software update for the engine control unit. Since there is no official documentation for the Toyota crown platinum which shares the same engine configuration, Toyota refuses to provide a resolution. This puts vehicles occupants at risk of a crash, as if you are expecting to accelerate and the vehicle refuses, another driver might not anticipate this and put you at risk of a crash due to the inability to accelerate properly and safely.

Our 2024 Toyota Crown Platinum has been experiencing random loss of power or torque when merging into traffic from a complete stop. The vehicle will be working fine; then, while attempting to accelerate from a complete stop, there is no torque or ability to accelerate up to posted speed. Not sure if it is an engine or transmission issue…but it represents a significant safety concern when it happens if pulling out from a stop to merge into oncoming traffic. The driver of the vehicle judges if it is safe to make a right turn on red (for example) and when the car does not perform as expected and there is a loss of torque or acceleration, this creates an opportunity for other drivers to rear end you as your vehicle is moving at a very slow rate of speed and not accelerating to appropriate traffic conditions.

2024 Crown Hybrid system keeps popping up on dash saying warm lamp came on twice: third time Warning lamp turned. Vehicle has been serviced twice at same dealer and then taken to another for same problem. The problem has not been resolved. Dealership indicates cannot duplicate problem. I have even shown the dealership from photo and not able to resolve.

The main instrument panel on numerous occasions remains locked on “Experience Drive Connect”, usually when starting the vehicles, but occasionally when the vehicle is being driven. Sometimes when we can turn off the car and restart, the screen will begin normal functions. Yesterday the screen remained locked after 5 shut-downs and we had to drive with a locked screen. This causes the loss of some critical functions. The fact that there remains no remedy places drivers at greater risk and should not be acceptable to the FTC nor affected Toyota drivers. We should not have to trade a higher end 2024 vehicle with 10K miles for another brand to remedy this issue. Additionally, the vehicle may lose trade value with a pending recall that prevents dealers from certifying the auto.

Intermittently as I press on the brake, the engine loses power, engine feels like it is going to die and the charge meter on the dash display drops to no charge. Right before the engine dies the engine regains charge on the dash display charge meter and the engine returns to normal. So far the engine has never totally died on me yet.

The contact owns a 2024 Toyota Crown. The contact stated that while attempting to accelerate from a stop, the vehicle hesitated while accelerating. There was no warning light illuminated. The vehicle was taken to a local dealer where the vehicle was diagnosed, and the contact was informed that no cause for the failure was found with the vehicle. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 7,000.