2016 Toyota Camry

WAS GLIDING INTO MY GARAGE FOOT WAS ON BRAKE, (SO NO SPEED AT ALL) WHEN I HEARD A SUDDEN ENGINE ROAR AND CAR PICKED UP SPEED AND WAS PROPELLING ME TOWARD THE BACK WALL OF THE GARAGE. I IMMEDIATELY JAMMED ON MY BRAKE BUT WAS NOT ABLE TO STOP BEFORE HITTING RACKS AND WALL AT THE BACK OF MY GARAGE. THIS ACCELERATION OF THE CAR RESULTED IN PROPERTY DAMAGE TO CAR AND AND PROPERTY.

The driver door began to rattle when the door was closed or when driving down the road. I took it to my Toyota dealer and when they removed the door panel they found the intrusion bar's weld had failed. They confirmed it was a safety issue and referred me to their body shop. The body shop informed they are not allowed to reweld the bar and the only fix is to replace the door. This car has never been in an accident so my only conclusion is that when the car was manufactured the weld was improperly performed. I cannot afford to replace this door and I'm left to drive a car with no intrusion bar to protect me in an accident. I find this very concerning and this should not be something I should have to repair. In conclusion I believe this is Toyota manufacturing issue and they should be responsible for replacing this door which is endangering my safety as an owner and consumer. Thank you.

Malfunction of connections to radio system. All buttons surrounding radio, including radio control buttons on steering wheel, do not function. The screen still turns on and displays the typical home screen but the screen does not function either leaving the radio system stuck on the home screen. Again , none of the buttons and/or screen functions work connected to the radio. The clock time is still displayed and will change but it is the wrong time but once again, cannot be changed because the functions surrounding the radio do not work.

The contact owns a 2016 Toyota Camry. The contact stated that the seat belts of the driver’s and passenger’s side rear seats failed to retract, causing concerns for the contact. There was no warning light illuminated. The vehicle was taken to a local dealer, where it was diagnosed, and the contact was informed that the seat belt retractors were faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 132,393.

The engine quit running whenever the headlights, turn signals, or wipers were turned on. This was obviously a serious safety problem when driving! It began intermittently on 6/30/25, but it became a consistent problem by 7/7/25, so I took the car to the closest Toyota Dealership for evaluation. I can provide their service report to you if requested. It took them 6 hours and $1000 to diagnose the problem as bad electrical grounding points (high resistance), which were only revealed after they removed the front bumper. In my opinion, it is an unsafe design to have poor grounding for headlights cause the engine to die.