OFFICIAL NHTSA RECALL
92V127000
Service Brakes, Hydraulic:power Assist
Reported Sep 3, 1992 · GENERAL MOTORS CORP.
Summary
THE BRAKE PEDAL ASSEMBLY HAS A PUSHROD PIN THAT IS TOO SMALL AND IT IS INSTALLED IN THE WRONG POSITION, CAUSING AN INCREASED BRAKE PEDAL RATIO AND A DECREASED MASTER CYLINDER STROKE.
Consequence
THE REDUCED MASTER CYLINDER STROKE RESULTS IN FAILURE TOMEET THE PARTIAL SYSTEM FAILURE REQUIREMENTS OF FMVSS 105, "HYDRAULIC BRAKESYSTEMS". A FURTHER REDUCTION IN BRAKING ABILITY AT A TIME WHEN PARTIAL SYSTEMFAILURE HAS OCCURRED COULD RESULT IN A VEHICLE CRASH.
Remedy
REPLACE THE BRAKE ASSEMBLY.
Notes
SYSTEM: BRAKES: BRAKE PEDAL ASSEMBLY; FMVSS 105.VEHICLE DESCRIPTION: VANS EQUIPPED WITH VACUUM POWER BRAKES.NOTE: FMVSS 105 REQUIRES THAT HYDRAULIC BRAKE SYSTEMS HAVE AN EMERGENCY FEATUREWHICH STOPS THE VEHICLE UNDER SPECIFIED CONDITIONS. ALL HYDRAULIC BRAKE SYSTEMSARE DESIGNED WITH A SPLIT SYSTEM. EACH SPLIT WORKS INDEPENDENTLY FROM THE OTHER.THE PARTIAL SYSTEM FAILURE TEST OF THE FMVSS IS PERFORMED WITH ONE OF THE SPLITSYSTEMS INOPERATIVE.
This campaign page uses the representative official campaign record. Applicability-specific source variants appear on the linked vehicle pages. Recall counts refer to campaigns, not affected vehicles.
Vehicle entries in this campaign
This is model-level recall history. It does not confirm whether a particular VIN is affected or has received the repair. Check with NHTSA ↗