OFFICIAL NHTSA RECALL
79V238000
Power Train:clutch Assembly:pedal/hand Lever(motorcycle)
Reported Oct 29, 1979 · AMERICAN SUZUKI MOTOR CORP.
Summary
IF THE CLUTCH CABLE WAS FORCEFULLY PULLED OR PUSHED UPON DURING THE CRATING PROCESS AT THE FACTORY, THE CLUTCH CABLE MAY HAVE BECOME DISLODGED FROM ITS CABLE RETAINER. IT MAY CONTACT THE CARBURETOR THROTTLE SHAFT CONNECTOR AND PREVENT THE THROTTLE PLATES FROM RETURNING TO IDLE.
Consequence
Not supplied in the source record.
Remedy
DEALER WILL INSTALL AN ADDITIONAL CLUTCH CABLE RETAINER TO PREVENT DISLODGEMENT AT NO COST TO OWNER.
Notes
VEHICLE DESCRIPTION: MOTORCYCLES.SYSTEM: POWER TRAIN; CLUTCH ASSEMBLY, LINKAGE.CONSEQUENCES OF DEFECT: AS A RESULT, VEHICLE MAY NOT DECELERATE PROPERLY WHENACCELERATOR PEDAL IS RELEASED. THIS COULD CAUSE A LOSS OF VEHICLE CONTROL ANDAN ACCIDENT.NOTE: IF FAILURE OCCURS, OPERATOR SHOULD ACTIVATE THE EMERGENCY "ENGINE OFF"SWITCH, AND DISENGAGE THE CLUTCH, APPLY THE BRAKES, AND TURN THE IGNITION KEYOFF.
This campaign page uses the representative official campaign record. Applicability-specific source variants appear on the linked vehicle pages. Recall counts refer to campaigns, not affected vehicles.
Vehicle entries in this campaign
This is model-level recall history. It does not confirm whether a particular VIN is affected or has received the repair. Check with NHTSA ↗