IllustrationVEHICLE PULLS WHEN BRAKES APPLIED DUE TO MISALIGNMENT.
1985 Oldsmobile Cutlass
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Cutlass years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 1 of 18 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Engine And Engine Cooling. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Vehicle Speed Control. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
3 crash reports2 fire reports2 injury reports
Suspension complaints
2 reportsFRONT SUSPENSION BOLTS RUSTED, ALLOWING THEM TO PULL THROUGH THE RETAINERS, RESULTING IN LOSS OF STEERING..
Official recalls
389V102000 · Vehicle Speed Control
Jun 16, 1989
A SMALL NYLON BUSHING IN THE CRUISE CONTROL SERVO BAIL MAY SLIP OUT OF PLACE, CAUSING INTERMITTENT AND UNEXPECTED INCREASES IN ENGINE SPEED OR DIESELING (ENGINE RUN ON WITH IGNITION OFF).
Consequence & remedy
Consequence: SERVO ROD ASSEMBLY COULD CATCH ON ENGINE COMPONENTS ANDRESULT IN A STUCK THROTTLE WITH POTENTIAL FOR A VEHICLE CRASH.
Remedy: INSTALL A NEW BUSHING IN CRUISE CONTROL SERVO BAIL.
84V154000 · Seat Belts:front:retractor
Nov 27, 1984
THE VEHICLES WERE ASSEMBLED WITH FRONT SEAT BELT RETRACTORS WHICH MAY NOT PERFORM ADEQUATELY DURING A COLLISION.
Consequence & remedy
Consequence: Not supplied
Remedy: THE DEALER WILL REPLACE THE LEFT AND RIGHT FRONT SEAT BELT RETRACTORS FREE OF CHARGE.
84V124000 · Steering:linkages:tie Rod Assembly
Oct 10, 1984
THE TIE RODS ARE PART OF THE STEERING LINKAGE AND TRANSMIT TURNING MOVEMENTS TO THE WHEELS. THE BOLTS THAT FASTEN THE TIE RODS TO THEIR ADJUSTERS MAY NOT BE TIGHT ENOUGH. THIS COULD ALLOW THE TIE ROD TO LOOSEN AND DETACH ITSELF FROM THE ADJUSTER.
Consequence & remedy
Consequence: Not supplied
Remedy: THE TIE ROD END BOLTS WILL BE TIGHTENED WITHOUT COST TO THE OWNER.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
6PE89145 · Parking Brake Cable
Opened Jul 21, 1989 · Closed Sep 22, 1989
Status: closed (inferred from source dates) · Parking Brake
===
PE89104 · Jammed Steering Mechanism
Opened Mar 17, 1989 · Closed May 12, 1989
Status: closed (inferred from source dates) · Steering
SUMMARY: THE OIL FILL TUBE MAY BECOME LOOSE, CAUSING IT TO FALL ANDPOSSIBLY BECOME LODGED NEAR THE STEERING GEAR.THIS MAY CAUSE THESTEERING MECHANISM TO BECOME JAMMED, RESULTING IN A LOSS OF VEHICLECONTROL.===
C89001 · Throttle NON-RETURN
Opened Mar 6, 1989 · Closed Jan 16, 1990
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
There is no summary currently available
EA88023 · Throttle Linkage Sticking
Opened Feb 2, 1988 · Closed Mar 6, 1989
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
===
DP87021 · Cutlass Supreme Brake Lockup
Opened Jul 1, 1987 · Closed Jul 17, 1987
Status: closed (inferred from source dates) · Service Brakes, Hydraulic
CUTLASS SUPREME BRAKE LOCKUP
EA86025 · Windshield Wipers
Opened Aug 25, 1986 · Closed Mar 2, 1988
Status: closed (inferred from source dates) · Visibility
SUMMARY:GM BELIEVES THE PROBLEM HAS BEEN CORRECTED THROUGH ITS PUBLI-CATION OF 7 SERVICE BULLETINS CONCERNING THIS MATTER. IN ADDITION, GMDOES NOT BELIEVE WINDSHIELD WIPER FAILURE REPRESENTS A SAFETY HAZARD.ANALYSIS: THREE FAILURE MODES HAVE BEEN IDENTIFIED; INSULATING FILM MAYBUILD UP BETWEEN THE BRUSH FACE AND THE COMMUTATOR OF THE WIPER MOTOR,CORROSION MAY FORM IN THE WIPER MOTOR BRUSH AND DISENGAGEMENT OF THEWIPER ARMS MAY OCCUR. IN VIEW OF THE EXISTING LEGAL PRECEDENT, THE LARGENUMBER OF WARRANTY CLAIMS CONCERNING WIPER MOTOR FAILURES (114,000) ANDTHE HIGH WIPER MOTOR AND MOTOR KIT PART SALES (251,000), IT IS IMPERATIVETHAT THIS MATTER RECEIVE MANAGEMENT SUPPORT.STATUS: GM RESPONSE DATED 2/23/87. ANALYZING AS TIME PERMITS.EA CLOSED 3/2/88.=== D@