IllustrationENGINE IDLE IS HIGH AFTER STARTING AND REMAINS HIGH AFTER ENGINE WARMS UP. IDLE IS ROUGH AT LOW RPM AND HESITANT UNDER A LOAD. CONSUMES MORE GAS THAN NORMAL, ABOUT 80 MILES A TANK LESS RANGE. MOLDING IS FALLING OFF ON BODY.
1987 Nissan Sentra
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 1987 Nissan Sentra do not stand out strongly from the model-year median of 116.
About this comparison →How this year compares
Owner complaints by model year
Compare all Sentra years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 36 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Seat Belts. Review the 15 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 6 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
2 crash reports2 fire reports2 injury reports
What owners actually said
36 reportsTHE TRANSMISSION WOULD STALL FOR NO REASON. HAD VEHICLE TOWED. HAPPENED 3 YEARS LATER. WAS INFORMED THAT TORQUE CONVERTOR WAS PROBLEM. TRANSMISSION WAS LEAKING FLUID. *AK
WHILE AT CRUISE, THE ENGINE STARTED TO STALL. WHILE ATTEMPTING TO PULL TO A SIDE OF FREEWAY, ENGINE CONTINUED TO LOSE POWER, FIRE ERRUPTED; ALSO REPLACED ELECTRONIC CONTROL MODULE. *AK
FUEL INJECTORS FAILED, RESULTING IN STALLING/RACING OF ENGINE.
INTERMITTENT PROBLEM WHEN PUTTING THE KEY IN THE IGNITION, SOMETIMES WILL START AND SOMETIMES WILL NOT. PLEASE DESCRIBE DETAILS.
BOLT THAT HOLDS TRANSMISSION AND GEAR BOX TO STAY TOGETHER BROKE, CAUSING THEM TO SEPERATE AND DROP TO GROUND. CAUSE UNKNOWN. *AK
REAR PASSENGER DOOR HANDLE INOPERATIVE.
OWNER RECEIVED RECALL NOTICE TO HAVE THE RELEASE BUTTON IN BOTH FRONT SEAT BELT BUCKLES REPLACED, WHETHER OR NOT THEY WERE BROKEN. FOUR DAYS AFTER ASSUMED REPAIR, OWNER RECEIVED A CALL SAYING THAT THE PARTS FOR THE RECALL HAD ARRIVED. NOW THAT THE WORK HAS BEEN PERFORMED THE DRIVER SIDE BELT IS INOPERATIVE AND DOES NOT WORK AT…
Read full complaint
OWNER RECEIVED RECALL NOTICE TO HAVE THE RELEASE BUTTON IN BOTH FRONT SEAT BELT BUCKLES REPLACED, WHETHER OR NOT THEY WERE BROKEN. FOUR DAYS AFTER ASSUMED REPAIR, OWNER RECEIVED A CALL SAYING THAT THE PARTS FOR THE RECALL HAD ARRIVED. NOW THAT THE WORK HAS BEEN PERFORMED THE DRIVER SIDE BELT IS INOPERATIVE AND DOES NOT WORK AT ALL.
ABOUT 3 MONTHS AGO THE CONSUMER WAS TOLD THAT THERE WERE NO PARTS AND THAT THEY WERE GOING TO CONTACT HIM WHEN THE PARTS CAME IN, THE CONSUMER HAS NOT RECEIVED A CALL. PLEASE DESCRIBE DETAILS. *AK
UPON FRONTAL IMPACT OF A HERD OF DEER, NON-MOTORIZED SHOULDER BELT FAILED TO RESTRAIN, ALLOWING DRIVER TO MAKE CONTACT W/STEERING WHEEL. *AK
Official recalls
195V103002 · Seat Belts:front:buckle Assembly
May 24, 1995
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence & remedy
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED FREE OF CHARGE.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1EA95007 · Takata Seat Belt Buckle Failure
Opened Mar 10, 1995 · Closed Aug 2, 1995
Status: closed (inferred from source dates) · Seat Belts:front:buckle Assembly
There is no summary currently available