TL* THE CONTACT OWNS A 2000 NISSAN QUEST. THE CONTACT STATED THAT WHILE DRIVING AT APPROXIMATELY 65 MPH, THE STEERING WHEEL STARTED TO VIBRATE. THE CONTACT MENTIONED THAT THE VEHICLE WAS TAKEN TO A TIRE CENTER WHERE THE TIRES WERE ROTATED AND AN ALIGNMENT WAS PERFORMED. HOWEVER, THE REMEDY FAILED TO REPAIR THE FAILURE. THE APPRO…
Read full complaint
TL* THE CONTACT OWNS A 2000 NISSAN QUEST. THE CONTACT STATED THAT WHILE DRIVING AT APPROXIMATELY 65 MPH, THE STEERING WHEEL STARTED TO VIBRATE. THE CONTACT MENTIONED THAT THE VEHICLE WAS TAKEN TO A TIRE CENTER WHERE THE TIRES WERE ROTATED AND AN ALIGNMENT WAS PERFORMED. HOWEVER, THE REMEDY FAILED TO REPAIR THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 127,000.
NHTSA ODI #10614938
Mileage unknown · Apr 20, 2004
Engine And Engine CoolingExterior LightingSteering
I HAVE HAD TO CHANGE MY HEADLIGHTS REPEATEDLY (GOING ON 3RD TIME) AND MY TAIL LIGHT (1 TIME). IN ADDITION, I HAVE PROBLEMS WITH MY ACCELERATOR PEDAL; IT SEEMS TO STICK, UNTIL I APPLY ENOUGH PRESSURE THEN IT TAKES OFF ABRUPTLY FAST, HAD THESE SAME PROBLEMS (WITH REPLACING HEAD AND TAIL LIGHTS AND ACCELERATOR) WHEN I HAD MY 1993 …
Read full complaint
I HAVE HAD TO CHANGE MY HEADLIGHTS REPEATEDLY (GOING ON 3RD TIME) AND MY TAIL LIGHT (1 TIME). IN ADDITION, I HAVE PROBLEMS WITH MY ACCELERATOR PEDAL; IT SEEMS TO STICK, UNTIL I APPLY ENOUGH PRESSURE THEN IT TAKES OFF ABRUPTLY FAST, HAD THESE SAME PROBLEMS (WITH REPLACING HEAD AND TAIL LIGHTS AND ACCELERATOR) WHEN I HAD MY 1993 NISSAN QUEST, BUT DISMISSED THEM. NOW I SEE A CORRELATION WITH THE 2000 QUEST I HAVE NOW. THE LOW PROFILE OF MY QUEST CAUSED MY TRANSMISSION PAN TO LEAK FLUID, BECAUSE OF A DIP IN THE ROAD. CONSTANT PROBLEMS WHEN PARKING DUE TO THE FRONT END OF MY QUEST BEING TOO LOW AND SCRAPING THE CURB. PROBLEM WITH HEATING SYSTEM IN THE REAR, ONLY BLOWS OUT COLD AIR REGARDLESS OF SETTING IT TO HEAT. THERE IS A VERY STRONG GAS SMELL WHEN MY CAR IS RUNNING (THIS WAS ALSO EXPERIENCED IN MY 1993 QUEST) ONLY COMPACT INCIDENT WAS WHEN MY TRANMISSION PAN CRACKED GOING DOWN THE STREET AND GOING DOWN A DIP IN THE ROAD (NOT A POT HOLE). OTHER THAN THESE THINGS I HAVE BEEN VERY PLEASED WITH MY PURCHASES, VERY RELIABLE BUT THESE ARE A FEW THINGS I'VE NOTICED AND HOPE THAT YOU WILL CONSIDER MY CONCERNS TO FURTHER BE INVESTIGATED.
NHTSA ODI #10066522
Mileage unknown · Mar 28, 2002
Service Brakes, HydraulicSteeringUnknown Or Other
CONSUMER STATES WHEN PRESSING THE GAS PEDAL THERE IS A MAJOR DELAY IN ACCELERATION. CONSUMER STATES CAR WILL SUDDENLY LURCH FORWARD. NLM CONSUMER ALSO STATES BRAKE PEDAL SQUEAKS, THE STEERING WHEEL WHINES AND THE FRONT DRINK CUP HOLDER WOULD NOT WORK. *YH
NHTSA ODI #8006601
Mileage unknown · Dec 20, 2000
Steering
WHEN MAKING A LEFT OR RIGHT TURN A LOUD NOISE COMES FROM STEERING ASSEMBLY, CAUSE UNKNOWN. PLEASE GIVE ANY FURTHER DETAILS. *AK
VEHICLE DESCRIPTION: MINI VANS. ONE OR MORE OF THE FIVE BOLTS THAT MOUNT THE RACK AND PINION STEERING GEAR TO THE VEHICLE MAY HAVE BEEN INCORRECTLY TIGHTENED.
Consequence & remedy
Consequence: THERE COULD BE A LOOSENESS IN THE STEERING, WHICH MAY BE ACCOMPANIED BY NOISE OR VIBRATION.
Remedy: DEALERS WILL INSPECT THE VEHICLES AND, IF THE BOLTS ARE MISSING, WILL REPLACE THE STEERING GEAR MOUNTING BOLTS. ALL BOLTS WILL BE TIGHTENED TO THE SPECIFIED TORQUE.
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."
Consequence & remedy
Consequence: IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANT MAY NOT BE PROPERLY RESTRAINED.
Remedy: DEALERS WILL INSPECT THE DATE CODE ON CERTAIN SEAT BELT BUCKLES OF YOUR VEHICLE AND REPLACE ALL SEAT BELT BUCKLES THAT FALL WITHIN THE SUSPECT DATE CODE RANGE.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
PE04020 · Failing Headlights
Opened Feb 26, 2004 · Closed Jun 24, 2004
Status: closed (inferred from source dates) · Exterior Lighting:headlights
NISSAN AND FORD FOUND THAT THE ORIGINAL EQUIPMENT HEADLIGHT STAINLESS STEEL BULB TERMINALS MAY OVER TIME CAUSE ELEVATED CONTACT RESISTANCE AND OVERHEAT THE ELECTRICAL CONNECTOR HOUSING.THIS CAN RESULT IN A HEADLIGHT FLICKERING, BULB OUTAGE AND HEAT DEFORMATION TO THE HEADLIGHT CONNECTOR.IN APRIL 1999, THE SUPPLIER OF THE HEADLIGHT FOR NISSAN AND FORD CHANGED TO A BULB USING THE STAINLESS STEEL TERMINALS THAT DID NOT MEET ORIGINAL SPECIFICATIONS.ON JULY 17, 2000, THE SUPPLIER BEGAN USING A BULB MEETING THE VEHICLE MANUFACTURER'S SPECIFICATIONS.THIS PROBLEM CAN AFFECT INDEPENDENTLY EITHER HEADLIGHT BUT DOES NOT CAUSE SIMULTANEOUS FAILURE OF BOTH HEADLIGHTS. THE PROBLEM ALSO DOES NOT AFFECT FRONT PARKING LAMPS.AS A RESULT, THE COMPLAINTS TYPICAL REPORT SINGLE FAILURE OF ONE HEADLIGHT.THERE ARE NO CRASHES OR LOSS OF VEHICLE CONTROL REPORTED.A SAFETY-RELATED DEFECT TREND HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
2000 Nissan Quest Problems, Complaints & Recalls | Skip That Year
Illustration