2005 Nissan Altima

TL*THE CONTACT OWNS A 2005 NISSAN ALTIMA. THE CONTACT STATED THAT THE ENGINE VALVE HAS BEEN MAKING A TAPPING NOISE SINCE 2006. HE STATED THAT THE ENGINE TAPPING FAILURE IS A SAFETY ISSUE BECAUSE IT COULD LEAD TO ENGINE SEIZURE. THE VEHICLE WAS TAKEN TO THE DEALER FIVE TIMES FOR THIS FAILURE. AFTER THREE OF THE FIVE VISITS, THE MECHANIC CLAIMED THAT THE FAILURE WAS REPAIRED; HOWEVER, THE TAPPING STILL OCCURS. THE CURRENT MILEAGE WAS 40,000 AND FAILURE MILEAGE WAS 25,000.

I RECENTLY TOOK MY 2005 NISSAN ALTIMA TO A LOCAL DEALERSHIP FOR A TSB. THE CAR WAS STALLING AT LOW SPEED. THE TSB SAID THE CRANK SENSOR WOULD OVERHEAT AND WOULD NOT ALLOW THE ECM TO READ THE SENSOR. THE DEALERSHIP REPROGRAMMED THE ECM, BUT TOLD ME I HAD TO BUY A NEW SENSOR, WHICH I DID. I BELIEVE THE PROBLEM IS CREATED BY THE DESIGN/POSITIONING OF THE SENSOR, CAUSING IT TO OVERHEAT. I FEEL NISSAN IS CHARGING TO MAKE REPAIRS ON A TSB AT THE EXPENSE OF NISSAN OWNERS. *TR

I HAD A RECALL ON A PART ON MY 2005 ALTIMA AND HAD IT 'FIXED' AT THE DEALER IN FEBRUARY. I DROVE IT OUT OF TOWN FOR A HOLIDAY WEEKEND, AND IT PROCEEDED TO DIE ON FIVE (5) OCCASIONS OVER TWO (2) DAYS WHILE I WAS DRIVING IT. THE PROBLEM HAD NO PREDICTED ONSET, AND THE 'SERVICE ENGINE SOON' LIGHT DID NOT COME ON UNTIL AFTER IT DIED THE FIRST TIME. I HAD TO PAY $240 TO GET IT FIXED (WHEN IT SHOULD HAVE ALREADY BEEN FIXED). *TR

TL*THE CONTACT OWNS A 2005 NISSAN ALTIMA. WHILE DRIVING AT VARIOUS SPEEDS, THE VEHICLE SPORADICALLY STALLED WITHOUT WARNING. THE CONTACT TOOK THE VEHICLE TO THE DEALER AND HAD IT REPAIRED ACCORDING TO THE RECALL FOR THE ECM. IMMEDIATELY AFTER THE REPAIR, WHILE DRIVING 65 MPH, THE VEHICLE COMPLETELY STALLED. THE VEHICLE WAS TOWED TO THE DEALER AND THEY REPAIRED THE ENGINE THROTTLE. THE DEALER STILL HAS POSSESSION OF THE VEHICLE BECAUSE THE CONTACT IS AFRAID TO OPERATE THE VEHICLE. THE FAILURE MILEAGE WAS 25,000 AND CURRENT MILEAGE WAS 26,000. UPDATED 07/07/08. *LJ

THE CAR WOULD SUDDENLY STOP WHILE DRIVING ALMOST CAUSING FATAL ACCIDENTS. CAR WAS TAKEN TO NISSAN TO HAVE A RECALL FIXED FOR THIS EXACT PROBLEM. NISSAN STATED THEY WOULD NOT REPROGRAM THE ECM UNDER THE RECALL UNTIL THE CRANKSHAFT POSITION SENSORS WERE REPLACED AND WAS CHARGED 350 DOLLARS FOR PARTS AND LABOR. THE RECALL STATED THE SENSORS COULD OVERHEAT AND CAUSE BRIEF INTERRUPTION TO THE ECM AND CAUSE THE CAR TO STALL. IF THE SENSORS ARE CAUSING THE PROBLEM WHY ARE THEY NOT RECALLED AS WELL? FURTHER REVIEW ONLINE SHOWS THE ORIGINAL SENSORS WERE MADE FROM PLASTIC AND COULD CRACK AND LEAK OIL ONTO THE SENSOR CAUSING THEM TO FAIL AND THE NEW REVISED ONES ARE MADE FROM METAL. *TR

TL*THE CONTACT OWNS A 2005 NISSAN ALTIMA. THE CONTACT RECEIVED A RECALL NOTICE FOR NHTSA CAMPAIGN ID NUMBER 07V527000 (ENGINE AND ENGINE COOLING). HE TOOK THE VEHICLE TO A LOCAL DEALER TO HAVE THE RECALL REMEDIED. THE DEALER STATED THAT DUE TO THE LOCATION OF THE CRANKSHAFT POSITION SENSOR, THE ENTIRE COMPONENT WOULD NEED TO BE REPLACED. THE REPAIR IS NOT COVERED UNDER THE RECALL AND THE CONTACT PAID OUT OF POCKET TO HAVE HIS VEHICLE SERVICED. THE VIN AND POWERTRAIN WERE UNKNOWN. THE CURRENT MILEAGE WAS 37,000 AND FAILURE MILEAGE WAS 36,999.

ON NUMEROUS OCCASIONS IN OCTOBER, 2007 MY 2005 NISSAN ALTIMA WOULD STALL OUT WHILE DRIVING. THIS OCCURRED MAINLY ON THE INTERSTATE CAUSING A INSTANTANEOUS SLOWING DOWN OF THE VEHICLE, WHERE VEHICLES BEHIND ME WOULD COME VERY CLOSE TO HITTING THE REAR OF MY CAR. OTHER TIMES THE CAR WOULD STALL COMPLETELY AT LOW SPEEDS, LOOSING POWER TO THE STEERING AND BRAKES PUTTING MYSELF IN A SITUATION HARMFUL TO THOSE STOPPED IN FRONT OF ME. THE STALL OCCURS WITHOUT WARNING TO MYSELF OR OTHERS AROUND ME, CREATING A SERIOUS SAFETY-RELATED PROBLEM. I RESEARCHED & FOUND SAFETY-RELATED RECALLS FOR THE '02, '03, '04 MODELS BUT NOT 2005. MY VEHICLE HAD 41,000 MILES ON IT WHEN I TOOK IT TO THE DEALERSHIP. THERE WAS NO RECALL YET FOR THE 2005 MODEL ALTHOUGH I EXPERIENCED THE SAME PROBLEMS THE OTHER RECALLS IDENTIFIED. THE SERVICE PERSONNEL CALLED ME AFTER MY CAR WAS LOOKED AT AND ADVISED THAT THE CAM SHAFT POSITION SENSOR AND THE CRANK SHAFT POSITION SENSOR HAD FAILED DUE TO EXPERIENCING HOT CONDITIONS & THE SOLDER HOLDING THEM IN PLACE MELTED (AGAIN CONSISTENT WITH PREVIOUSLY ISSUED TSBS AND RECALLS). I PLEADED, THIS SHOULD BE UNDER A RECALL, BOTH WITH NISSAN CONSUMER AFFAIRS AND WITH VICTORY NISSAN FROM WHOM I PURCHASED THE ALTIMA. I WAS LEFT PAYING THE FEE MYSELF. THE RECALL FOR THE 2005 MODEL WAS ISSUED IN DECEMBER 2007 AND I AM TRYING TO GET A REFUND FOR HAVING TO PAY FOR REPAIRS THAT NISSAN IDENTIFIED AS SAFETY-RELATED. THE RECALL LISTS REPROGRAMMING OF THE ECM, WHICH NEEDED TO BE COMPLETED, SINCE THE ECM WOULD LOOSE COMMUNICATION WITH THE TCM. HOWEVER THE REASON FOR THE FAILURE IN COMMUNICATION STEMMED FROM THE FAILURE OF THE POSITION SENSORS. I FEEL LET DOWN AND UPSET THAT NISSAN CONTINUED TO EXPERIENCE THESE PROBLEMS WITH THEIR 2.5 LITER ENGINES IN YEARS SUBSEQUENT TO ISSUED RECALLS AND FAILED TO NOTIFY CURRENT OWNERS OF THE SAFETY-RELATED PROBLEMS. I AM ALSO UPSET THAT NISSAN DOES NOT ADMIT THE CRANK POSITION AND CAM POSITION SENSORS PLAYED PART IN THE STALLING. *TR