2006 Mitsubishi Lancer

The contact owns a 2006 Mitsubishi Lancer. The contact stated while driving from a complete stop, she heard abnormal loud grinding sounds coming from underneath the front passenger's side of the vehicle. The contact stated that the failure had been reoccurring increasingly while driving. Additionally, the contact stated that her mother had informed her that she had seen an unknown part hanging underneath the front passenger's side of the vehicle. The dealer was notified of the failure and informed the contact that she would need to take the vehicle to their location for recall repair under NHTSA Campaign Number: 16V458000 (Suspension). The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 164,550.

My lancer has very bad rear end chassis rust where the rear subframe is fastened to the monobody. In this area all the suspension components and rear drivetrain are located. Damage occurs due to salt and other corrosive agents that are used for roads in Connecticut to melt snow. These agents rust the car where Mitsubishi failed to properly protect the steel under the rear end of the vehicle. It is widely observed that the 03-06 lancer has from factory a poor to almost no anti rust agent applied to the lower rear chassis area of the car where the subframe crossmember is located that holds suspension components and rear differential. Currently under nhtsa campaign 16V458000, there is a safety recall for the front subframe crossmember due to rust damage. As for the rear of the car there most certainly should be a safety campaign as the rust in this area develops quicker and can cause a catastrophic failure.

The contact owns a 2006 Mitsubishi Lancer. The contact stated while working on the vehicle, the contact noticed that there was a huge hole in the sub-frame due to rust. The contact stated no warning light was illuminated. The vehicle was taken to the local dealer and it was diagnosed that the sub-frame needed to be replaced. The vehicle was not repaired. The contact related the failure to an unknown recall. The manufacturer was not informed of the failure. The failure mileage was approximately 196,000. The VIN was unavailable.

REAR FRAME RAIL RUST. THE CAR STATED TO ACCUMULATE RUST ON THE FRAME RAILS OF THE CAR THAT CONNECTS THE REAR SUBFRAME AND REAR TOE ARM. FAILURE OF THESE AREAS COULD LEAD TO A CRASH. THE MANUFACTURER DID A POOR JOB CORROSION PROOFING THIS AREA ON THIS MODEL YEAR. THE CAR HAD A 7 YEAR/ 100,000 RUST WARRANTY IN WHICH I AM SURE THIS PROBLEM DEVELOPED WITHIN THAT COVERAGE BUT WAS HARD TO NOTICE UNTIL RUST STARTED FORMING ON THE OUTSIDE FRAME WHICH IS HARD TO SEE WITHOUT JACKING UP THE CAR. *TR

TL* THE CONTACT OWNS A 2006 MITSUBISHI LANCER. THE CONTACT STATED THAT HE WAS UNABLE TO USE THE DEFROSTER, WHICH PREVENTED HIM FROM SEEING OUT THE WINDOW. THERE WERE NO WARNING INDICATORS ILLUMINATED. THE VEHICLE WAS TAKEN TO AUTO GALLERY MITSUBISHI-CORONA (LOCATED AT 2550 WARDLOW RD, CORONA, CA 92882, (951) 372-0008) WHERE IT WAS DIAGNOSED THAT THE TEMPERATURE CONTROL UNIT NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED. THE FAILURE MILEAGE WAS 143,000.

REAR CHASSIS MEMBER (A FRAME RAIL) CORRODED CLOSE TO THE POINT WHERE REAR SUBFRAME IS CONNECTED. IT IS NOW A SAFETY CONCERN TO DRIVE THE VEHICLE AS ANY SIGNIFICANT IMPACT MAY CAUSE THE REAR SUSPENSION TO DETACH. THERE WAS ALREADY A RECALL ON RUST OF THE FRONT SUBFRAME HOWEVER IT SEEMS THAT THE PROBLEM IS IN INADEQUATE UNDERCARRIAGE PROTECTION