← New search

1993 Mazda MX-6

Owner reports · Recalls · Investigations

Limited comparison data

There is not enough comparable history to draw a useful model-year comparison.

About this comparison →

How this year compares

Owner complaints by model year

Other model years Selected year
Compare all MX-6 years →

Counts vary with age, sales and reporting. They are not failure rates.

What owners reported most

All reported categories

Tap a category to read its complaints. One report may name several components.

When problems were reported

Mileage at the reported incident

Limited mileage data: 9 of 54 reports include usable mileage. There isn’t enough coverage to show a useful chart.

NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.

What to inspect

Issues worth paying extra attention to based on owner reports.

  • Service Brakes, Hydraulic. Review the 11 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Engine And Engine Cooling. Review the 9 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Steering. Review the 6 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

4 crash reports0 fire reports4 injury reports

Parking Brake complaints

3 reports
Clear category filter
112,125 miles · May 10, 2007
Parking Brake

ON THE MODELS WITH REAR DISC BRAKES: AFTER APPLYING, AND THEN RELEASING THE PARKING BRAKE IN A NORMAL MANNER THE PARKING BRAKE ACTUATOR PIVOTING PIN BEARING ON ONE OF THE REAR CALIPERS SEIZED, CAUSING IT NOT RELEASE OR TO NOT FULLY RELEASE. THIS COULD CAUSE A HANDLING/BRAKING INSTABILITY ISSUE, NOT TO MENTION PREMATURE BRAKE PA…

Read full complaint

ON THE MODELS WITH REAR DISC BRAKES: AFTER APPLYING, AND THEN RELEASING THE PARKING BRAKE IN A NORMAL MANNER THE PARKING BRAKE ACTUATOR PIVOTING PIN BEARING ON ONE OF THE REAR CALIPERS SEIZED, CAUSING IT NOT RELEASE OR TO NOT FULLY RELEASE. THIS COULD CAUSE A HANDLING/BRAKING INSTABILITY ISSUE, NOT TO MENTION PREMATURE BRAKE PAD WEAR/FAILURE. AN IMPROPERLY DESIGNED CALIPER INVOLVING THE SEAL AROUND THE PARKING BRAKE ACTUATOR PIVOTING PIN AND BEARING WAS THE CAUSE OF THE FAILURES.*AK

NHTSA ODI #10190419

112,435 miles · Jan 17, 2005
Parking Brake

APPLIED PARKING BRAKE. REAR BRAKE CALIPER PARKING BRAKE MECHANISM DESIGN FAILURE CAUSED THE REAR CALIPER TO NOT RELEASE AFTER RELEASING THE PARKING BRAKE HANDLE. HAD TO MANUALLY (FROM UNDERNEATH THE CAR) FORCE THE ACTUATOR LEVER BACK. *JB

NHTSA ODI #10106502

Mileage unknown · Jan 10, 2000
Parking BrakeService Brakes, Hydraulic

AFTER THE CALIPERS FAILED ON THE REAR, THE PARKING BRAKE WAS LOCKED IN PLACE AND WOULD NOT RELEASE MAZDA OF KNOXVILLE AND BILL GATTON MAZDA OF JOHNSON CITY WERE CONTACTED, AND BOTH DENIED ANY KNOWLEDGE OF THE PROBLEM AND REFUSED TO REPAIR DAMAGES TO CALIPERS PADS AND ROTORS. I WAS INFORMED TO COMPLAIN TO THIS ORGANIZATION IF MA…

Read full complaint

AFTER THE CALIPERS FAILED ON THE REAR, THE PARKING BRAKE WAS LOCKED IN PLACE AND WOULD NOT RELEASE MAZDA OF KNOXVILLE AND BILL GATTON MAZDA OF JOHNSON CITY WERE CONTACTED, AND BOTH DENIED ANY KNOWLEDGE OF THE PROBLEM AND REFUSED TO REPAIR DAMAGES TO CALIPERS PADS AND ROTORS. I WAS INFORMED TO COMPLAIN TO THIS ORGANIZATION IF MAZDA REFUSED TO REPLACE THE FAILED COMPONENTS THANK YOU JOE GEMMELL. *AK

NHTSA ODI #717160

Official recalls

2

15V674000 · Electrical System:ignition:switch

Oct 19, 2015

Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.

Consequence & remedy

Consequence: If the ignition switch overheats there would be an increased risk of a fire.

Remedy: Mazda will notify owners, and dealers will replace the ignition switch, free of charge. The recall began on December 17, 2015. Owners may contact Mazda Customer Experience Center at 1-800-222-5500, option#6. Mazda's number for this recall is 8715J.

92V045000 · Suspension:front:control Arm

Apr 2, 1992

THE LOWER ARM BALL JOINTS ON BOTH SIDES OF THE FRONT SUSPENSION MAY NOT HAVE BEEN TORQUED TO SPECIFICATION.

Consequence & remedy

Consequence: THE INSUFFICIENT TORQUE OF THE LOWER BALL JOINTRETAINING BOLT CAN RESULT IN THE SUSPENSION FAILING WHILE THE CAR IS IN MOTIONAND SUBSEQUENT LOSS OF STEERING CONTROL WITHOUT WARNING, WHICH CAN RESULT IN ANACCIDENT.

Remedy: INSPECT THE LOWER BALL JOINT RETAINING BOLTS AND TIGHTEN LOOSE BOLTS TO THE CORRECT TORQUE.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

1

RQ99022 · Headlight Failure

Opened Dec 20, 1999 · Closed Aug 30, 2000

Status: closed (inferred from source dates) · Exterior Lighting

OBTAINED RECALL 99V-358