I pulled into the driveway (at about 5 mph) of my passenger's home, when a very loud, metallic pop occurred somewhere inside my vehicle. I could not discern the problem by visually inspecting the car. Upon returning to my home, I arranged for the dealership to inspect the car's suspension. They found that both rear springs ha…
Read full complaint
I pulled into the driveway (at about 5 mph) of my passenger's home, when a very loud, metallic pop occurred somewhere inside my vehicle. I could not discern the problem by visually inspecting the car. Upon returning to my home, I arranged for the dealership to inspect the car's suspension. They found that both rear springs had snapped off from their lower vehicle attachment points. At the time of the incident, my car was less than 6 years old and had approximately 62500 total miles. I had the dealership replace both rear springs and associated attachment hardware. Prior to this failure, the dealership had routinely inspected the suspension of my vehicle as part of PA annual inspections. I experienced NO warning symptoms prior to the suspension failure.
NHTSA ODI #11700190
Mileage unknown · Nov 16, 2025
SteeringSuspension
TSB 02-003/24 Car front suspension bolts corroded and making metal on metal sounds during turning and braking
Mazda North American Operations (Mazda) is recalling certain 2020 CX-30 and Mazda3 vehicles. The front brake caliper mounting bolts may not have been tightened properly during assembly, possibly allowing the calipers to loosen.
Consequence & remedy
Consequence: Loose brake calipers can reduce braking performance or interfere with wheel rotation, affecting vehicle handling. Either of these scenarios can increase the risk of a crash.
Remedy: Mazda will notify owners, and dealers will inspect the front brake caliper bolts, tightening them as necessary. If bolts are missing, the affected brake caliper will be replaced. Repairs will be performed free of charge. The recall began July 24, 2020. Owners may contact Mazda customer service at 1-800-222-5500, Option 4. Mazda's number for this recall is 4420F.
Mazda North American Operations (Mazda) is recalling certain 2019-2020 Mazda3 vehicles. The Smart Brake System (SBS) can falsely detect an obstacle while driving, activating the automatic emergency braking system and suddenly stopping the vehicle.
Consequence & remedy
Consequence: Stopping the vehicle unexpectedly increases the risk of a crash.
Remedy: Mazda will notify owners, and dealers will update the SBS software. In addition, vehicles with certain production dates will receive an instrument cluster software update or replacement and a replacement owner's manual. These repairs will be performed free of charge. The recall began February 14, 2020. Owners may contact Mazda customer service at 1-800-222-5500, Option 4. Mazda's number for this recall is 4219L.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2020 Mazda MAZDA3 Problems, Complaints & Recalls | Skip That Year
Illustration