TL* THE CONTACT OWNS A 2013 KENWORTH T600. WHILE ATTEMPTING TO EXIT THE VEHICLE, BOTH THE PASSENGER AND DRIVER DOORS FAILED TO OPEN. EVEN USING THE KEY FAILED TO OPEN THE DOORS. THE VEHICLE WAS TAKEN TO A DEALER WHERE IT WAS DIAGNOSED THAT THE LOCKING MECHANISM IN THE DOOR FAILED AND NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIR…
Read full complaint
TL* THE CONTACT OWNS A 2013 KENWORTH T600. WHILE ATTEMPTING TO EXIT THE VEHICLE, BOTH THE PASSENGER AND DRIVER DOORS FAILED TO OPEN. EVEN USING THE KEY FAILED TO OPEN THE DOORS. THE VEHICLE WAS TAKEN TO A DEALER WHERE IT WAS DIAGNOSED THAT THE LOCKING MECHANISM IN THE DOOR FAILED AND NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED, BUT THE FAILURE RECURRED ON THE PASSENGER SIDE DOOR. ON SEVERAL OCCASIONS, THE CONTACT HAD TO CLIMB THROUGH A WINDOW TO EXIT THE VEHICLE. THE MANUFACTURER WAS NOTIFIED OF THE FAILURES. THE FAILURE MILEAGE WAS APPROXIMATELY 300,000. THE VIN WAS NOT AVAILABLE.
Paccar is recalling certain model year 2013 kenworth T400, T600, T700, T800, and W900 vehicles, manufactured from July 18, 2012, through August 10, 2012. Cap screws securing the main driveline to the forward rear axle and cap screws on the inter-axle driveline may not have been properly torqued.
Consequence & remedy
Consequence: Fasteners which are not properly torqued to specification can result in the driveline separating from the vehicle, disabling the vehicle and increasing the risk of a crash. The separated component could also become a road hazard.
Remedy: Paccar will notify owners, and dealers will inspect and re-torque the each of the affected fasteners, free of charge. The safety recall began on September 7, 2012. Owners may contact Kenworth at 1-425-828-5440.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2013 Kenworth T600 Problems, Complaints & Recalls | Skip That Year