PACCAR Incorporated (PACCAR) is recalling certain 2009-2021 Kenworth C500, 2012-2021 Kenworth T440, 2009-2015 Kenworth T660, 2015-2024 Kenworth T680, 2009-2024 Kenworth T800, 2009-2020 Kenworth T370, 2014-2023 Kenworth T880, 2011-2016 Kenworth T470, 2023 Kenworth T480, and 2009-2019 Kenworth W900 vehicles. The air tanks have an insufficient volume of air for the brake system. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 121, "Air Brake Systems."

Consequence & remedy

Consequence: Insufficient air volume can reduce braking performance and increase the risk of a crash.

Remedy: Dealers will install the correct volume air tanks, free of charge. Owner notification letters were mailed August 12, 2024. Additional owner notification letters were mailed October 27, 2025. Owners may contact PACCAR customer service at 1-425-828-5888. PACCAR's number for this recall is 24KWD.

16V803000 · Tires

Nov 4, 2016

PACCAR Incorporated (PACCAR) is recalling certain model year 2017 Kenworth K370, T270, T370, T440, T660, T800 trucks manufactured February 2, 2016, to October 13, 2016, and Peterbilt 330, 337, 348, 367, 389, 567, and 579 trucks manufactured March 7, 2016, to October 5, 2016. The affected vehicles are equipped with certain Goodyear LHS Load Range G tires, size 295/75R22.5 G399A, that due to incomplete adhesion, have a tire tread that may partially separate.

Consequence & remedy

Consequence: A partial tread separation may increase the risk of a crash.

Remedy: Goodyear will notify the owners of the affected Peterbilt and Kenworth vehicles and Goodyear dealers will replace the affected tires, free of charge. The recall began on December 14, 2016. To find a Goodyear dealer, owners should contact Goodyear Consumer Relations at 1-800-592-3267. Consumers may also contact Kenworth customer service at 1-425-828-5000 and Peterbilt customer service at 1-940-591-4000. PACCAR's number for this recall is 1016G (PB) (Peterbilt), and 16KWC (Kenworth).

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE20015 · Quarter Fender Failures

Opened Sep 21, 2020 · Closed Oct 14, 2021

Status: closed (inferred from source dates) · Structure:frame And Members:underbody Shields

The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE21-015) based on one Vehicle Owner Questionnaire (VOQ) and supporting fleet reports. The reports indicated that the subject quarter fenders were prone to cracking and/or separation.After a comprehensive review of the data related to the quarter fender failures on the subject vehicles, ODI did not identify the existence of a safety-related defect trend. Quarter fender failures resulted in a warranty claim rate less than one percent (<1%) of the total vehicle population. All separations, including those due to tread separations, road hazards, etc., accounted for less than point one percent (<0.1%) of the total vehicle population.ODI discovered that the minimum recommended gap between the top of the quarter fender and the bottom of the trailer was not known or being followed. The optional quarter fenders were supplied by Fontaine Spray Systems (FSS), who recommended a two inch (2) gap. ODI analyzed the claim data using a calculated gap. A calculated gap using the top of the quarter fender flap and assuming the trailer is level with the top of the fifth wheel hitch was necessary, as PACCAR doesn't know specifically what trailer a purchaser will couple to the tractor. It is safe to assume no trailers on the market extend below the upper fifth wheel plate, but many do provide additional clearance over the wheels where the quarter fenders are located. ODI determined that 94 percent of warranty claims and 84 percent of separations violated FSS' recommendation.ODI confirmed that the VOQ vehicle and the fleet report vehicles also violated FSS' recommended gap. In one fleet the gap was negative point three inches (-0.3).PACCAR has updated its vehicle specification process and issued a customer advisory notice to existing owners. In light of the low rate of reported failures and separations, further use of agency resources does not appear to be warranted. The closing of this investigation does not constitute a finding by NHTSA that no safety-related defect exists. The agency reserves the right to take further action if warranted by the circumstances.