← New search

1997 Kenworth T2000

Owner reports · Recalls · Investigations

Limited comparison data

There is not enough comparable history to draw a useful model-year comparison.

About this comparison →

How this year compares

Owner complaints by model year

Other model years Selected year
Compare all T2000 years →

Counts vary with age, sales and reporting. They are not failure rates.

What owners reported most

All reported categories

Tap a category to read its complaints. One report may name several components.

When problems were reported

Mileage at the reported incident

Limited mileage data: 0 of 3 reports include usable mileage. There isn’t enough coverage to show a useful chart.

NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.

What to inspect

Issues worth paying extra attention to based on owner reports.

  • Visibility. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Air Bags. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Engine And Engine Cooling. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

0 crash reports0 fire reports0 injury reports

What owners actually said

3 reports
Mileage unknown · Aug 10, 1998
Air BagsEngine And Engine CoolingEquipment

BRAKETS UNDER VEHICLE FAILED. NOT AIR BAG COMPLAINT ( E.G., SEAT BELT, TRAILER SUSPENSION AIR BAG, ETC.) ADDED ON 09-07-1999. *AK

NHTSA ODI #538909

Mileage unknown · May 7, 1998
Exterior LightingLatches/locks/linkagesSuspension

VEHICLE HAS SEVERAL SAFETY DEFECTS INCLUDING PROBLEMS WITH THE FRONT END ALIGNMENT, DOORS, TRANSMISSION, HEADLINER, AND TAIL LIGHTS.

NHTSA ODI #535231

Mileage unknown · Aug 5, 1997
Visibility

THE CURVED WINDSHIELD HAS A FLAT SPOT ON THE DRIVER'S SIDE. MANUFACTURER WAS CONTACTED. *AK

NHTSA ODI #815056

Official recalls

4

01V051000 · Suspension:front:control Arm:lower Arm

Feb 20, 2001

VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH 54" REAR AXLE SPACING CONFIGURATION OF THE AIRGLIDE 200 SUSPENSION WITH THE SERVICE APPLICATION IDENTIFIED AS LOGGER, DUMP TRUCK, OR TANKER. THE REAR SUSPENSION IS REGULARLY SUBJECTED TO EXTREME ARTICULATION, RESULTING IN FLEXING OF THE JOINT.

Consequence & remedy

Consequence: FAILURE OF THE LOWER SWAY ARM ATTACHING BOLTS COULD RESULT IN LOSS OF VEHICLE CONTROL.

Remedy: DEALERS WILL REPLACE THE LOWER SWAY ARM BRACKETS. OWNER NOTIFICATION BEGAN MARCH 27, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT KENWORTH AT 1-425-828-5000.

98V129000 · Electrical System:wiring:front Underhood

Jun 11, 1998

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH CATERPILLAR 3406E ENGINES. THE ROUTING OF THE ELECTRICAL AND FUEL LINES CAN CAUSE CHAFFING OF THE WIRING HARNESS ON THE FUEL LINE.

Consequence & remedy

Consequence: THIS CHAFFING CAN CAUSE FUEL LEAKAGE AND A POTENTIAL FOR A FIRE IN THE ENGINE COMPARTMENT.

Remedy: DEALERS WILL INSPECT, ADJUST, AND REPAIR, IF NECESSARY, THE FUEL LINE AND ELECTRICAL HARNESS.

97V139000 · Suspension:rear

Aug 20, 1997

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH KENWORTH AIRGLIDE 200 REAR SUSPENSION. DUE TO MATERIALS USED IN THE SWAY BAR ARMS AND STUDS AS WELL AS THE STUD PLATING MATERIAL, STRESS CORROSION CRACKING AND BENDING FATIGUE CAN OCCUR IN THE REAR SUSPENSION SWAY BAR ARMS AND STUDS CAUSING THE STUD TO FAIL PREMATURELY.

Consequence & remedy

Consequence: THIS COULD CAUSE A LOSS OF STEERING CONTROL INCREASING THE RISK OF A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE ARM ASSEMBLY MANUFACTURED FROM A DIFFERENT MATERIAL. NEW STUDS WILL BE INSTALLED WITH DIFFERENT THREADS AND DIFFERENT FINISH.

97V085000 · Latches/locks/linkages:doors:latch

May 22, 1997

A SECONDARY BEND OPERATION WAS NOT PERFORMED DURING ASSEMBLY OF THE DOOR LATCH WHICH COULD CAUSE THE DOOR LATCH TO JAM WHEN LOCKED.

Consequence & remedy

Consequence: THE DOOR LATCH WILL NOT RELEASE FROM EITHER THE INSIDE OR THE OUTSIDE OF THE VEHICLE.

Remedy: DEALERS WILL INSPECT THE DOOR LATCHES FOR CERTAIN DATE CODES AND REPLACE SUSPECT LATCHES WITH NEW LATCHES.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

0

No exact-year investigations in this snapshot.