2001 Jeep Wrangler

THE A/C,HEATER BLOWER SWITCH MOPAR PART 305011214AA OVER HEATS AND THE WIRING START TO MELT,THE SWITCH STARTS TO MELT AND THEN THE SWITCH FAILS. THERE APPEARS TO BE TO MUCH CURRENT DRAW FROM THE BLOWER MOTOR. IT CAUSES THE DARK GREEN POWER LEAD CONNECTED TO THE SWITCH TO OVERHEAT MELTING THE INSULATION ON THE LEAD AND THE CONNECTIONS ON THE SWITCH. THIS HAS OCCURED AGAIN TODAY SEPTEMBER 22,2012. THIS CAUSED THE SAME PROBLEM,WIRES OVERHEAT,CONNECTIONS AND WIRES MELT AND SWITCH HOUSING AT CONNECTIONS START TO SMOLDER UNTIL SWITCH FAILS,WHEN SWITCH FAILS CURRENT CEASSES TO FLOW TO BLOWER MOTOR AND EVERYTHING COOLS DOWN ENOUGH TO PREVENT FURTHER DAMAGE TO SWITCH WIRING. FUSE FOR THE CIRCUIT DOES NOT BLOW OUT. TO REPAIR, SWITCH MUST BE REPLACED AND NEW WIRE CONNECTORS INSALLED,AND THE DARK GREEN WIRE WILL START TO GET HOT ENOUGH TO BE UNCOMFABLE TO THE TOUCH. DEALERSHIP PARTS DEPT. EMPLOYEES HAVE CONFIRMED THAT THESE SWITCH FAIL REGULARLY., *TR

TL* THE CONTACT OWNS A 2001 JEEP WRANGLER SPORT. THE CONTACT STATED THAT THE DRIVER WAS TRAVELING 65 MPH WHEN THE VEHICLE STARTED TO VIBRATE. THE CONTACT ALSO CONFIRMED THE FRAME WAS CORRODED. THE VEHICLE WAS NOT TAKEN TO THE DEALER. THE MANUFACTURER WAS MADE OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE FAILURE AND THE CURRENT MILEAGES WERE 78,105.

THE DASH BLOWER CONTROL WAS NOT WORKING. WHEN THE MECHANIC CHECK IT AND THE SYSTEM, IT WAS DISCOVERED THAT THE BLOWER HAD OVER HEATED THE PIGTAIL CONNECTORS AND MELTED THEM. THE BLOWER CONTROL WAS VISIBLY MELTED AND MULTIPLE SIGNS OF OVERHEATING WERE APPARENT. THE BLOWER CONTROL, ALL PIGTAIL CONNECTORS AND THE BLOWER HAD TO BE REPLACED. THIS WAS CAUGHT JUST SHORT OF ME HAVING TO DEAL WITH A FIRE BEING CAUSED BY THIS OVER HEATING OF THE ELECTRICAL PARTS OF THE A/C-HEATER SYSTEM. THIS IS THE SAME SITUATION AS REPORTED IN OTHER COMPLAINTS. REFER TO ODI ID NUMBERS: 10364281, 10283272, 10181912 AND 10145512. *TR

RE: MAJOR FRAME ROT: WE ARE THE ORIGINAL OWNERS OF THIS VEHICLE AND ALWAYS MAINTAINED IT PER THE SCHEDULE. I BOUGHT THE JEEP TO MY MECHANIC FOR SOME ROUTINE MAINTENANCE. WHEN HE REMOVED THE DRIVERS SIDE REAR WHEEL HE NOTICED SERIOUS FRAME ROT. HE TOLD ME THE JEEP IS NO LONGER SAFE TO DRIVE AND NOT WORTH PUTTING ANY MORE MONEY INTO. WHEN I GOT HOME, I SCRATCHED THE RUST WITH MY FINGERNAIL AND WAS EASILY ABLE TO POKE MY FINGER RIGHT THROUGH THE FRAME. A QUICK INTERNET SEARCH REVEALED THE FRAME ROT IS A VERY COMMON DESIGN FLAW FOR THE WRANGLER TJ SERIES. APPARENTLY MOISTURE, ROAD DEBRIS, ETC. IS ALLOWED TO ENTER THE INTERIOR OF THE FRAME BUT NOTHING IN THE DESIGN ALLOWS FOR ITS EXIT. SINCE THIS CREATES A CONDITION THAT ALLOWS THE FRAME TO ROT FROM THE INSIDE-OUT, BY THE TIME IT IS DISCOVERED IT IS TYPICALLY TOO LATE. MANY COMPANIES NOW MANUFACTURE SPECIAL FRAME PIECES TO REPAIR THE DAMAGE IF YOU ARE ONE OF THE LUCKY ONES WHO ARE MADE AWARE OF WHAT TO LOOK FOR BEFORE TOO MUCH DAMAGE HAS BEEN DONE. I SINCERELY HOPE JEEP WILL TREAT THIS DEFECT THE WAY TOYOTA DID WITH THE TACOMA IN 2008-2009! *JB

TL* THE CONTACT OWNS A 2001 JEEP WRANGLER. THE CONTACT STATED THAT WHILE DRIVING 55 MPH, HE DROVE OVER A BUMP AND THE FRONT END OF THE VEHICLE VIOLENTLY VIBRATED. THE CONTACT HAD TO APPLY THE BRAKES TO STOP THE FAILURE. THE FAILURE RECURRED INTERMITTENTLY WHEN THE CONTACT DROVE OVER BUMPS. THE VEHICLE WAS NOT TAKEN TO HAVE THE FAILURE DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 112,000. THE VIN WAS UNAVAILABLE.

TL* THE CONTACT OWNS A 2001 JEEP WRANGLER. THE CONTACT STATED THAT WHILE DRIVING OVER WATER, THE VEHICLE HYDROPLANED AND CAUSED THE CONTACT TO CRASH INTO A TREE. THE FRAME WAS SEVERELY FRACTURED AND THE VEHICLE WAS CRUMPLED AS A RESULT OF THE SEVERE IMPACT. THE AIR BAGS DID NOT DEPLOY. THE CONTACT SUSTAINED A SEVERE CONCUSSION AT THE LEVEL TWO DEGREE. THE POLICE ARRIVED ON SCENE TO ASSIST AND STATED THAT DUE TO THE SEVERITY AND FORCE OF THE IMPACT, THE AIR BAGS SHOULD HAVE DEPLOYED. THE VEHICLE WAS TOWED TO A LOCAL REPAIR FACILITY WHO ALSO STATED THAT THE AIR BAGS SHOULD HAVE DEPLOYED. THE VEHICLE WAS NOT REPAIRED AND THE VIN WAS NOT AVAILABLE. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE VEHICLE WAS NOT INSPECTED FOR THE CAUSE OF THE HYDROPLANING FAILURE OR THE AIR BAGS FAILURE. THE VIN WAS NOT AVAILABLE. THE FAILURE AND THE CURRENT MILEAGES WERE UNKNOWN.

FRAME IS RUSTED THROUGH AT ALL POINTS WHERE SKIDPLATE ATTACHES TO FRAME!! THE UNDERSIDE OF THE FRAME IS RUSTED THROUGH/GONE AT THE AREA WHERE SKIDPLATE BOLTS TO. AS A RESULT THE SKIDPLATE IS HANGING DOWN AND NOT PROPERLY SUPPORTING TRANSMISSION AND TRANSFER CASE.. BECAUSE OF THIS HANGING IT IS CAUSING MISALIGNMENT OF THE DRIVETRAIN.. DAMAGING COMPONENTS OF THE DRIVETRAIN. I CANNOT IMAGING IF THIS GOES UNDETECTED AND THE FRAME CRACKS AND/OR BREAKS WHILE THE VEHICLE IS IN MOTION, AT WHAT IS THE MIDDLE OF THE FRAME. *JS

TL* THE CONTACT OWNS A 2001 JEEP WRANGLER. WHILE DRIVING APPROXIMATELY 45 MPH, THE ENGINE WARNING INDICATOR ILLUMINATED ON THE INSTRUMENT PANEL. THE VEHICLE WAS MANEUVERED TO A SAFE LOCATION. THE CONTACT NOTICED THE ENGINE OVERHEATED AND THE RADIATOR RESERVOIR WAS EMPTY. THE CONTACT DISPENSED COOLANT INTO THE RESERVOIR. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO REPLACED THE BLOWN HEAD GASKET. ONE WEEK AFTER THE REPAIR WAS PERFORMED THE FAILURE RECURRED. THE VEHICLE WAS NOT FURTHER REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE MALFUNCTION. THE APPROXIMATE FAILURE MILEAGE WAS 90,000.