2001 Jeep Wrangler

THE DASH BLOWER CONTROL WAS NOT WORKING. WHEN THE MECHANIC CHECK IT AND THE SYSTEM, IT WAS DISCOVERED THAT THE BLOWER HAD OVER HEATED THE PIGTAIL CONNECTORS AND MELTED THEM. THE BLOWER CONTROL WAS VISIBLY MELTED AND MULTIPLE SIGNS OF OVERHEATING WERE APPARENT. THE BLOWER CONTROL, ALL PIGTAIL CONNECTORS AND THE BLOWER HAD TO BE REPLACED. THIS WAS CAUGHT JUST SHORT OF ME HAVING TO DEAL WITH A FIRE BEING CAUSED BY THIS OVER HEATING OF THE ELECTRICAL PARTS OF THE A/C-HEATER SYSTEM. THIS IS THE SAME SITUATION AS REPORTED IN OTHER COMPLAINTS. REFER TO ODI ID NUMBERS: 10364281, 10283272, 10181912 AND 10145512. *TR

THIS IS ONE MORE CONSUMER COMPLAINT REGARDING THE HEATER/FAN/BLOWER WIRING DESIGN FAILURE FOR THE 2001 MODEL OF THE JEEP WRANGLER. I UNDERSTAND THAT THIS CONTINUES TO OCCUR IN OTHER TJ MODEL YEARS AS WELL SO I THINK IT IS A SYSTEMIC DESIGN PROBLEM THAT IF NOT CORRECTED BY THE MANUFACTURER WILL EVENTUALLY CAUSE A SERIOUS INJURY OR DEATH. MY CASE IS TYPICAL OF THE FAILURES DESCRIBED BY OTHER 2001 WRANGLER OWNERS IN THAT THE HEATER BLOWER FAN SWITCH BEGAN TO DROP SPEEDS UNTIL ONLY THE HIGHEST SPEED WAS LEFT OPERATIONAL [WHICH I UNDERSTAND IS HOW THE UNDERLYING ELECTRONICS SPECIFICALLY A RESISTOR BANK FAIL IN THIS MODEL]. RECENTLY, THIS 4TH SPEED HAS FAILED AND I AM NOT DRIVING THE VEHICLE UNTIL I CAN RECEIVE SOME ASSURANCE THAT THE HEATER BLOWER WILL NOT CONTINUE TO HEAT UP UNTIL IT CATCHES FIRE AS HAS BEEN REPORTED IN OTHER INSTANCES. AS I WRITE THIS COMPLAINT, IT IS ABOUT 25 DEGREES OUTSIDE, SO DRIVING MY 2001 WRANGLER WITHOUT HEAT IS NOT AN OPTION. I GUESS I AM LUCKY THAT (A) IT FAILED COMPLETELY IN COLD WEATHER FORCING ME TO (B) RESEARCH THE ISSUE LEARNING THAT (C) THIS OBVIOUS VEHICLE DEFECT CAN RESULT IN THE WRANGLER CATCHING FIRE WHICH HAS FORCED ME TO (D) GO WITHOUT THE USE OF THE WRANGLER UNTIL A FACTORY DESIGNED AND SPONSORED FIX IS ENGINEERED AND INSTALLED. SO, IN SUMMARY, 2001 WRANGLER ' FAILED HEATER/FAN/BLOWER SWITCH ' MANY OTHER CASES FOR THIS MODEL YEAR AND SURROUNDING MODEL YEARS ' HAS A HISTORY OF CAUSING VEHICLE FIRES ' THIS NEEDS TO BE A FACTORY SPONSORED RE-ENGINEER AND RECALL, AND NEEDS TO BE DONE NOW BEFORE A FIRE SITUATION CAUSES A SERIOUS ACCIDENT OR INJURY OR DEATH ! *TR

THERE IS A SERIOUS PRODUCT DEFECT IN THE FAN MOTOR-SWITCH-RESISTER ASSEMBLY IN MY 2001 JEEP WRANGLER. THIS CONDITION HAS BEEN REPAIRED SEVEN TIMES, SIX TIMES UNSUCCESSFULLY (THE FIRST TIME WAS IN 2004, THE YEAR I BOUGHT MY JEEP FROM A DEALERSHIP) AND THE LAST ONE ACCOMPLISHED AUGUST 20, 2009 AND WHO KNOWS HOW LONG THIS WILL LAST. THE PROBLEM IS THAT THE FAN SWITCH SUDDENLY FAILS TO OPERATE AND WHEN THE MATTER IS INVESTIGATED THE MECHANIC FINDS THAT THE BLOWER MOTOR, RELAY AND SWITCH HAVE MELTED. THERE IS SOME SORT OF ELECTRICAL PROBLEM OR SURGE WHICH SIX REPAIRS HAVE FAILED TO CORRECT AND MY FEAR IS MY JEEP WILL CATCH ON FIRE AS HAS BEEN REPORTED IN A NUMBER OF CASES. *TR

REFER TO ODI ID NUMBER : 10185714; AIRBAG WARNING LIGHT NOW STAYS ON CONSTANTLY; HORN NO LONGER WORKS; DEALERSHIP WHERE PRUCHASED NOTIFIED; SERVICE SCHEDULED; APPEARS TO BE COMMON PROBLEM WITH THE AIR BAGS FRONTAL SENSOR/CONTROL MODULE WHERE WATER AND/OR ROAD SALT IN THE PROXIMITY OF THE AIR BAG CONTROL MODULE COULD LEAD TO CORROSION ,AND SUCH CORROSION CAN LEAD TO ILLUMINATION OF THE AIR BAG WARNING LIGHT OR COULD ALLOW INADVERTENT DEPLOYMENT OF THE AIR BAGS. *AK

A/C HEATER BLOWER WIRING CAUSES FIRE AT CENTER OF DASHBOARD. WHEN A/C OR HEATER IS PLACED IN HIGH BLOWER SWITCHS ARE SELECTOR WIRING OVER LOADS AND CAUSES BURNING. THIS IS NOT AN ISOLATED CASE. NOTED AT SALVAGE AUCTIONS MANY 2000 AND UP JEEP WRANGLERS CATCH FIRE IN THIS AREA AND BURN COMPLETE. HARD TO FIGURE AFTER FIRE WHAT HAS HAPPEN. IM SURE INSURANCE COMPANYS WOULD BE INTERESTED IN THIS DEFECT. DO NOT KNOW HOW MANY INJURYS, BUT IM SURE THERE HAS BEEN SOME. I HAVE DICONNECTED THE HIGH POSITION WIRE SO THAT OVERLOAD WOULD NOT ACCURE TILL I COULD FIGURE A FIX OR JEEP WILL ADMIT TO A PROBLEM AND A FIX. *NM