2025 Jeep Grand Cherokee L

My vehicle is experiencing multiple dangerous electrical and drivetrain failures that occur intermittently and without warning. The issues began the day of purchase purchase and continue to worsen. Documented defects include: Vehicle randomly will not start Vehicle randomly will not turn off Dashboard/electronic systems reset intermittently (gauges go blank or restart, Bluetooth disconnects, warning indicators reset) Fuel gauge does not update while driving Sometimes vehicle will start but will not move (forward) when shifted into Drive or when in drive and brake pedal has been depressed. Vehicle sometimes fails to move when placed into Reverse Vehicle must be shut off and restarted to regain ability to move Key fob is not recognized by the doors or proximity sensors Driver’s seat creaks and feels unstable during acceleration Tire pressure sensor malfunction All systems intermittently disconnect/reset at the same time (suggesting a body control module or CAN-bus failure) Safety Concerns: The vehicle has refused to move in traffic, including while sitting in a drive-through line. The vehicle has failed to start in multiple public locations. The vehicle has failed to turn OFF, requiring multiple attempts. Loss of instrument cluster information could be very dangerous and matches symptoms currently under federal investigation for similar Jeep models (instrument panel cluster failures). These failures clearly impair the vehicle’s use, value, and safety, and appear to be part of a widespread electrical defect affecting Jeep products. A Jeep dealership confirms the issues and has scheduled service, but the problems continue to multiply. There are currently no open recalls for my VIN, although the symptoms match the national Jeep cluster/electrical investigation. I am submitting this complaint because these failures pose a serious danger to myself and other drivers + won't start. Please investigate this as a potential electrical/BCM/IPC/CAN-bus defect.

Within weeks of purchasing my brand-new 2025 Jeep Grand Cherokee, this past Thursday when leaving for my workday the steering wheel on my vehicle became completely immovable when I attempted to leave. I started the vehicle and tried to turn the wheel, but it would not move at all. There were no warning lights or alerts. I had no ability to steer or maneuver the vehicle, and it was completely undriveable. The vehicle had to be towed from my workplace to the dealership because the steering would not turn. After diagnosis, the dealer informed me that the entire power steering rack had failed and required full replacement. A power steering rack is a critical safety component, and a failure of this magnitude on a brand-new, very low-mileage vehicle is extremely concerning. If this defect had occurred while driving, it could have led to a total loss of steering control and a serious crash. I no longer feel safe operating this vehicle. I am requesting that NHTSA record this incident as a safety-critical steering system failure and investigate whether similar power-steering or steering-rack failures may be occurring in other 2025 Jeep Grand Cherokees.

Vehicle shuts off intermittently without warning. Random dash warning lights will flash, but not stay on. Air suspension will engage on its own while vehicle is not turned on, and electrical panels and lights will turn on and flash while vehicle is parked in garage, hours or days after last driven. Transmission will struggle to shift gears from low speeds, but then quickly “catch up” causing unpredictable acceleration. This vehicle has been to the dealership 5 times with batteries replaced, and software resets done, but no conclusion to what the source of the issue is. A camera was installed in our garage after the vehicle was sent home with us without being repaired due to being unable to replicate the issue. The camera captured 4 incidents of the vehicle electronics turning on, and air suspension raising up and down over a span of 5 days. We were advised to park the vehicle outside of our garage for fear of potential electrical fire, or it starting on its own. The vehicle is currently still in the dealership service department as they try to find the source of the issue. The vehicles electrical malfunctions have caused it to shut off on the highway, and while backing out of our driveway on multiple occasions. This puts both driver, occupants, and other drivers on the road at risk of being involved in a collision. The issues with the vehicle struggling to shift gears, and then “catching up” like a computer glitch, and accelerating unpredictably has been dangerous during merging into traffic.

Updates to the case#11679471. Since my initial report, Jeep arranged for an independent technician to retrieve and review the Event Data Recorder (EDR) from our vehicle. While Jeep has not shared the expert’s conclusions with us, we obtained a copy of the raw EDR data file from the same tech (attached). Based on the EDR data: 1. The brake pedal was fully applied approximately 0.4 seconds before impact and remained depressed. 2. The vehicle’s deceleration was only ~0.5 g, significantly below the expected ~0.8–1.0 g for dry asphalt conditions. 3. The ABS did not engage, indicating that hydraulic brake pressure was not reaching the level required to approach wheel lock. 4. The Automatic Emergency Braking (AEB) system was “On” but did not engage. 4. The Advanced Brake Assist (ABA) activated only ~0.3 seconds before impact, too late to reduce the stopping distance. 5. No DTC (diagnostic trouble codes) were recorded at the time of the event. These EDR findings indicate that the driver executed proper emergency braking, but the brake-by-wire system did not deliver sufficient hydraulic pressure to achieve normal deceleration. This may suggest a potential electronic or hydraulic brake system defect. The vehicle remains undrivable, and we have been declined by two separate Jeep dealerships to obtain an effective inspection or repair. Given the direct connection to FMVSS 105 (Hydraulic and Electric Brake Systems) requirements for service brake performance, we respectfully request that NHTSA treat this case as an urgent safety concern.

Was driving in normal weather conditions, no rain, no hail, no snow, no inclement weather whatsoever. During daylight hours, plenty of visibility. Was driving with no other vehicles around and my windshield cracked. Nothing hit it, no spider webbing, no point of impact. It made a loud cracking sound. The crack is roughly 80% of the with of my windshield. From setting behind the driver's seat, the crack starts around the steering wheel, goes up about midway, goes over to the passenger side and then goes up towards the roof. The crack makes a large N shape. The main horizontal of the crack is about center of the windshield. Had the vehicle less than two months at the time of the cracking.

The backup camera screen shows a blue screen when the gear is placed in reverse. It is difficult to see pedestrians, or other objects not viewable on the rearview mirror. This has occurred on numerous occasions. I contacted the manufacturer and the manufacturer told me to contact the dealership. I contacted the dealership and took a day off work to bring the vehicle to the dealership, but I was told that they couldn't fix the issue because they did not have a loaner vehicle available. I believe this is a safety issue causing me to backup into someone without my knowledge.

This complaint is an update to my previous complaint #11679471 submitted on August 8, 2025. Please consider this as additional information to the original case. Since my initial submission: Second Dealership Refusal: I attempted to bring the vehicle to a second authorized Jeep dealership for inspection and diagnosis. They refused any service, stating they would not inspect or repair the vehicle. This is now the second dealership to reject the vehicle after the incident. Obtained Diagnostic Printouts: Despite refusing service, the second dealership was convinced to provide printed codes from the vehicle. These codes show multiple system errors recorded at a very low vehicle mileage, including communication failures with the ABS control module, brake system internal failure, and CAN bus errors. These indicate potential electronic or computer system faults that could have occurred immediately before or during the brake failure. Manufacturer Warranty Issue: Immediately after the incident, Jeep opened a warranty case #93917003 for the vehicle. However, during subsequent communication, I was informed that this brand-new vehicle has no manufacturer's warranty at all. This is extremely concerning, as the vehicle was purchased new with only minimal mileage and no prior damage or modifications. Vehicle Condition: The vehicle remains undrivable and unsafe to operate. Jeep or its authorized dealers have performed no corrective action. Given that this was a brand-new vehicle with extremely low mileage purchased solely for personal family travel, and that both authorized dealerships have refused to address a major safety defect, I am requesting that NHTSA treat this as an urgent safety matter. The refusal to investigate by Jeep dealerships, combined with the unexpected claim that there is no manufacturer warranty, leaves this defect unresolved and poses an ongoing safety risk if similar failures occur in other vehicles.

While driving on the Belt Parkway towards Coney Island in stop-and-go traffic at approximately 25–35 mph, the vehicle in front slowed and came to a stop. The distance to the vehicle ahead was more than two car lengths. The brake pedal was fully depressed, but the vehicle did not decelerate adequately to come to a complete stop. The driver's record is clear of any car accident All forward collision warning alerts were sounding, but the ABS and automatic emergency braking (AEB) did not activate. There was no tire screech or pulsation from the brakes. The vehicle slowed but continued to move forward, resulting in a low-speed frontal collision. After the collision, the vehicle refused to move until the engine had been turned off for several minutes. Airbags did not deploy. This incident happened on a brand-new vehicle with only 318 miles on the odometer. We immediately contacted Jeep Corporate and opened a safety case. However, the first authorized dealer we visited, as was told by the Jeep advisor at 111 58th St., Brooklyn, NY 11220, refused to inspect the brake, ABS, or AEB systems under warranty, after we said that we have case number from Jeep and we need to read the computer while it still has information about the acident in the memory. Also were refused to provide a written denial, and directed us to a collision center instead, which repairs only the body but doesn't have equipment to read the car's faults. Due to this refusal, Jeep Corporate initially closed our case without resolution or notification; we had to insist on having it reopened, as the issue wasn't investigated. We are aware that Jeep models from 2024–2025 (though not exactly this trim) have had recalls for ABS, brake module, and electronic stability control issues, and these systems share similar or identical computer modules across model lines. Given these known issues and the seriousness of a complete brake system failure on a new vehicle, I believe this warrants immediate investigation by NHTSA.

Vehicle claims it is supposed to get a combined 22 mpg. However after having it for over three months now. We have yet to get vehicle to get above 17.5 mpg. most of the time it is at 16 on average. This a 3.6 V6 engine. My former 19 Jepp grand Cherokee with a HEMI 5.7 got an average of 19-20mpg. My driving habits have not changed between both vehicles or destinations. No warning lights or messages, no symptoms other than it does smell like it is running rich at times. I have asked the dealership several times about it, and they have said there is nothing that can be done. I have been also reading where there are quite a few of these same issues that owners of these Jeeps are complaining of the same issues. from 2023-2025. maybe a software update could be done? Vehicle now has 7400 miles on it.