2020 Jeep Cherokee

The power transfer unit failed, requiring a replacement of the power transfer case. It is still on the vehicle and has not been replaced yet. The 4WD on the car is unavailable, which puts my family and I at risk when driving in snowy conditions as are common in the area I live in. Additionally, the dealership stated that there are no replacement parts available since the part is “under development”, likely due to a flaw. I have taken the vehicle to two Chrysler, Dodge, Jeep, Ram dealerships who have both reported the same issue. The component has not been inspected besides the inspections done at the car dealerships. There were no symptoms of failure besides the “Service 4WD” warning light coming on, as well as warnings every time the car is turns on, indicating that 4WD is unavailable.

1. This is not a safety issue. This is a cosmetic issue. 2. Not applicable to warning lights. 3. General Issue: Bottom portion of drivers seat, reported to be leather, is peeling. This peeling is discoloring the seat and shows signs that it will continue over the entire seat. Never before have I seen this issue with leather seats (in many previous vehicles), including other Jeep vehicles. The issue was confirmed by an authorized Jeep dealer and they provided me an estimate including labor to be more than $1000. This peeling is of course, a cosmetic issue, but it looks awful and should not happen on a Jeep that is only 4 years old and has been gently taken care of. I realize this is a "wear and tear" issue, however there is no over-use - only usual getting in and out of the car. Leather should wear much longer and should not peel over time.

The contact owns a 2020 Jeep Cherokee. The contact stated while driving 60 MPH, the transmission failed without warning and the RPM became extremely elevated; however, the vehicle failed to respond while depressing the accelerator pedal. Despite the failure, the contact was able to coast the vehicle off to the shoulder of the highway. Due to the failure, the vehicle was towed to the residence where it remained. The dealer was notified of the failure and the contact was informed that the vehicle needed to be towed to the dealer for a diagnostic test. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 65,000.

The contact owned a 2020 Jeep Cherokee. The contact stated that while driving at an undisclosed speed, the four-wheel drive overheated warning light illuminated. The contact reduced the speed, and the vehicle was driven to the shoulder of the road. The contact stated that a nearby driver pulled over and informed the contact that the vehicle was on fire. The nearby driver also assisted the contact out of the vehicle. The contact stated that there were several explosions. The contact stated that the vehicle was burned to the ground. The fire department and the local police arrived on the scene. There were no injuries sustained. A Fire report was filed. The vehicle was towed to a local tow yard. The vehicle was condemned to total loss. The manufacturer was made aware of the failure and a case was filed. In addition, the case is currently under investigation. The failure mileage was approximately 26, 900.

The contact owns a 2020 Jeep Cherokee. The contact stated that the vehicle was taken to an independent mechanic for a routine service; however, while being serviced, the mechanic discovered that the lug nuts on all four wheels had swollen and that the factory lug tool could not be used to remove the lug nuts. The cause of the failure was unknown. The vehicle was then taken to another independent mechanic where a special tool was used to remove the lug nuts. The contact notified the manufacturer of the failure; and the manufacturer acknowledged that there was a failure with certain lug nuts; however, there were no recalls on the VIN. The vehicle was repaired. The failure mileage was 23,500.

The contact owns a 2020 Jeep Cherokee. The contact stated that while the vehicle was parked the driver attempted to accelerate forward and the vehicle erroneously made a sharp left turn and crashed into a construction zone causing damage to the vehicle and the construction site materials. No further information was available. During the incident, no injuries were reported and no police report was filed. The vehicle was later towed to the local dealer who diagnosed that the steering rack gear had fractured. The steering rack gear was replaced and the failure was remedied. The manufacturer was notified of the failure but no assistance was offered. The contact was later informed that the VIN was not included in the NHTSA Campaign Number: 19V637000(Steering). The contact indicated that the vehicle had experienced that same failure listed in the recall. The failure mileage was 22,000.

On Feb. 9th I was driving my 2020 Jeep Cherokee when the steering locked,I was unable to control the Jeep. Warning lights popped on the dash. Service power steering, four-wheel-drive system temporarily unavailable, Blindspot alert temporary unavailable, Service electric stability Control, stop start not ready. By the grace of God, somehow I was able to stop the car. I called AAA to have me towed to the dealership Autoland Springfield New Jersey. My car was in the service department from From February 9 to March 1 After checking my Jeep they called in a master mechanic and it was determined that the rack and pinion steering needed to be replaced.