2021 Jayco Precept

This concerns the towing hitch on the Jayco precept. While driving the hitch collapsed and the towing arms started to drag on the ground It tore away where the bends are, that form part of the plate that is bolted onto the precept. This could have resulted in destroying our towed vehicle or if the last inch had separated it would have caused the towed vehicle to no longer be attached to our Jayco. It could have caused serious injury to other vehicles on the road. Fortunately we had just stopped at a light and heard the towing equipment scraping on the ground, so we were able to unhook and travel to find a welder to weld it back in place.

The heat shield above the catalytic converter and associated pipes were not extended far enough which caused the pass through storage and wiring harness covering to melt. This could have been a disaster. There is a recall on 2018 and prior same models for the exact same problem. Jayco is of no help as there is not a recall for this year model. There are other owners with the same problem. This could cause a fatality while driving

The HLM (out of business) trailer hitch tore at the welds on both sides. Manufacturer states you can tow 5,000 lbs./500 tongue. My trailer fully loaded is 4600/380. I took the RV back to the Jayco Service Center, where I purchased it, to be repaired. I was informed HLM(aka pull rite) was contracted to build the hitch and no longer manufacture it. I was also informed that the hitch is mounted on a frame extension. The Ford Chassis ends just past the axles and the bedroom is built on this frame extension. I have several concerns with the safety/quality of this type of manufacturing(during COVID). Not only because this happen to us, but I have learned years other Jayco Class A owners (2020-2022) have experienced the same thing. We could have lost the whole trailer at highway speeds that could have resulted in a huge catastrophe to others!! Very unsafe! The first 3 pictures are of my hitch. The rest of the pictures are from other Jayco RV Owners that could have lost their tow cars/trailers too. I want to emphasize, no one was towing over capacity.

The heat shield on the floor of the passenger side is missing near the exhaust manifold. The shield cable for the batteries and other wiring has melted and shorted some wires. The heat was so hot that it melted the plastic storage compartment also and exposed the vehicle to exhaust gases and heat. This is an extreme safety hazard as the vehicle could catch on fire. I am scared to drive the vehicle.