2016 Hyundai Genesis

The steering rack malfunctions or fails. When driving at high speeds, the steering wheel gets stuck after being turned. It does not return to center and has to be yanked or forced back to center. There are hundreds of people that have mentioned this online about this Genesis model. This is a major safety issue, as jerking the wheel back to center can cause an accident, and if the wheel gets really stuck, it could cause a major accident. The issue has been confirmed by numerous reports and columns online. For my specific car, an independent service center confirmed the issue after test-driving the car. It has not been inspected by the manufacturer. There are no dash warnings, lights, or codes that indicate the issue. Hyundai should be paying to fix this safety issue. People are driving these cars who can't afford to get it fixed, which is putting others in danger as well.

The contact owns a 2016 Hyundai Genesis. The contact stated that after parking the vehicle in a nearby parking lot, upon returning, there was heavy black smoke coming from under the front passenger’s side seat. Upon further inspection, the contact burned his right hand while attempting to check for the source of the fire. The vehicle was taken to a local dealer while the black smoke was present, where it was diagnosed with a possible wiring harness failure and the vehicle remained with the dealer for further investigation. The vehicle was not repaired. In addition, the contact stated that the method of how the smoke was extinguished was unknown. No medical attention was sought. A Police report was not filed. The contact stated that as per the insurance provider, it was unknown if the vehicle was a total loss. The manufacturer was not made aware of the failure. The failure mileage was approximately 70,000.

Oil pressure switch in engine fails to accurately read oil pressure due to a lack of voltage, needing replacement. Causes driver to be unable to read proper oil pressure, leading to a possibility of fire through extreme overheating and friction-induced mechanical failure if the oil pressure is too low and unable to be read. The part has not been inspected by the manufacturer in any capacity, but it is a known issue with the Hyundai 3.8L V6 GDI engine. The oil pressure lamp will display at low RPMs and when at idle. A known fix it replacement of the sensor.

My 2016 Hyundai Genesis started flashing a code stating “Check PSB” only a week after buying the car. PSB means Pre-active Seat Belt. The seat belts somehow interlink with the fuel pump. My car has a faulty fuel pump module, causing the PSB warning to flash, even when the vehicle is in motion. It also causes a loud humming coming from the rear of my car, as I accelerate. I’ve done research, and it says MANY owners of the same vehicle report the faulty fuel pump module as the culprit, causing the Check PSB. As well as many owners online stating their vehicle has done the same as mine. There is active recalls on the newer years for this issue, such as the 2023. When the same issue is reported multiple times on the 2016s too, there should be a recall. This is a common issue, & quite frankly a dangerous one. If the fuel pump module is miscommunicating with the seat belts, that could cause them to not react in a collision. I have my vehicle scheduled to be serviced in a few days.

My car wont start. When I press the start button everything turns on but it wont start. It functions like the car is ready to drive. For example, it says drive to display tire pressure. The start button says the car is on. I can change gears, the radio works, back up camera works but the car didnt start. This happened before when there was a recall to the starter relay switch. Im wondering if its the same thing again. After waiting over 4 hours the car was able to start. Then again today same issue. There are no warning lights or system failure lights coming on to indicate theres any issue.

The contact owns a 2016 Hyundai Genesis. The contact stated that while the vehicle was parked, the passenger’s side rear door failed to open from inside or outside or unlock as needed. The vehicle was taken to a dealer, where it was diagnosed and it was determined that the rear passenger’s door handle actuator was fractured. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 80,100.

The oil pressure light illuminates at low RPMs and turns off under a load or higher RPMs. In checking Hyundai Genesis forums, this is a common failure/fouling of the oil pressure switch. Oil level is fine; it is the switch that fails, giving the owner a false sense of low oil and potential catastrophic engine damage. Unfortunately, the engine design requires a very expensive disassembly of the engine manifold and other parts to access and replace this small switch.