IllustrationUNSATISFACTORY SERVICING OF RECALL WORK ON THE 2003 HONDA GOLDWING. *MR THE CONSUMER REQUESTED REIMBURSEMENT IN THE FORM OF A GIFT CERTIFICATE FOR THE INCONVENIENCE AND WRONGFUL DELAY. *SC *JB
2003 Honda GL1800A
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all GL1800A years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 13 of 16 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Structure. Review the 10 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
What owners actually said
16 reportsTHE DEALERSHIP INDICATED THAT THE MOTORCYCLE'S FRAME WAS NOT REPAIRABLE. THE FRAME CRACKED MORE THAT THE FRAME WELD RECALL STATED (03V350000). *AK *NM
CONSUMER HAD PROBLEMS GETTING RECALL WORK PERFORMED ON THE MOTORCYCLE. *PH THE DEALER REFUSE TO PROVE RECALL SERVICE FOR THE CONSUMER MOTORCYCLE BECAUSE IT WAS NOT PURCHASED AT THAT LOCATION. *NM
UPON REINFORCING THE WELDS ON THE FRAME AS STATED IN RECALL 03V350000 FOR THE FRAME WELD DEALERSHIP NOTICED LARGE CRACK IN THE FRAME. MANUFACTURER INSTRUCTED THE DEALERSHIP TO STUFF CRACKS WITH METAL INSTEAD OF REPLACING THE FRAME. THIS WAS A TEMPORARY FIX, AND THE FRAME COULD CRACK AGAIN AT ANYTIME.*AK
I HAVE A PROBLEM WITH THE RECALL BEING DONE BY AMERICAN HONDA CORP. (AHC) ON THEIR GOLD WING GL1800 TO REPAIR POSSIBLE FRAME AND WELD DAMAGE. MY MOTORCYCLE WAS PURCHASED 4/24/03. IT IS LESS THAN 7 MONTHS OLD. MY MOTORCYCLE WAS REJECTED FOR THEIR 'NORMAL' RECALLS SERVICE BECAUSE THE FRAME WAS TOO HEAVILY DAMAGED FOR IT TO BE …
Read full complaint
I HAVE A PROBLEM WITH THE RECALL BEING DONE BY AMERICAN HONDA CORP. (AHC) ON THEIR GOLD WING GL1800 TO REPAIR POSSIBLE FRAME AND WELD DAMAGE. MY MOTORCYCLE WAS PURCHASED 4/24/03. IT IS LESS THAN 7 MONTHS OLD. MY MOTORCYCLE WAS REJECTED FOR THEIR 'NORMAL' RECALLS SERVICE BECAUSE THE FRAME WAS TOO HEAVILY DAMAGED FOR IT TO BE REPAIRED IN THE FIELD. AHC WANTS TO SHIP THE BIKE BACK TO THE FACTORY IN OHIO (FROM NJ) AND EITHER REPAIR THE CRACKS THEY DISCOVERED OR REPLACE THE FRAME ON THE BIKE. THEY ARE GIVING ME NO CHOICES EXCEPT TO ALLOW THEM TO DO THAT. MY PROBLEM WITH THEM FIXING IT AT THE FACTORY, IS TWO FOLD: 1. THE PEOPLE AT THE FACTORY ARE USED TO PUTTING A BIKE TOGETHER FROM SCRATCH, ON AN ASSEMBLY LINE, ACCORDING TO STRICT ENGINEERING GUIDELINES, BUT PROBABLY HAVE NEVER TAKEN ONE APART BEFORE AND PUT IT BACK TOGETHER. I, DO NOT WISH TO BE THE "GUINEA PIG". 2. I HAVE OVER $5000 IN ADDED ACCESSORIES ON MY MOTORCYCLE AND THEIR SOLE REPRESENTATIVE (A "STEVE" WHO WILL NOT PROVIDE HIS LAST NAME BUT GIVES HIS ID AS MT56: A. REFUSES TO GIVE ME ANY WRITTEN ASSURANCE THAT ALL MY ACCESSORIES WILL WORK WHEN I GET THE BIKE BACK. B. INSISTS THAT THE ONLY WAY I MAY GET THAT INSURANCE IN WRITING IS TO HAVE A LAWYER CONTACT HIS COMPANIES LEGAL DEPT. C. WILL NOT GIVE ME A NAME TO CONTACT. D. THREATENED ME THAT IF I DID NOT HAVE THEM DO IT NOW, THAT IT "MAY TAKE THEM A LOT LONGER TO DO IT LATER." E. ADMITTED THAT MANY OTHER BIKES HAD DAMAGE TO THE FRAME WAS MUCH WORSE THAN THEY EXPECTED AND ARE FINDING THAT MANY BIKES WILL HAVE TO BE SHIPPED BACK TO THE FACTORY TO BE REPAIRED. THIS "STEVE-MT56" (WHOEVER HE IS) WILL ONLY GIVE ME 'HIS' WORD THAT EVERYTHING WILL BE HANDLED CORRECTLY AND THAT I MUST CHECK OUT THE BIKE FULLY BEFORE I PICK IT UP AFTER THE REPAIR, TO HAVE DAMAGE THEY DO, COVERED BY AMERICAN HONDA. I AM QUITE UPSET BY THEIR TAKE IT OR LEAVE IT ATTITUDE AND LACK OF WRITTEN ASSURANCE. DO I HAVE ANY RECOURSE IN THIS MATTER? *LA
THE GL1800 OVERHEATS TO THE POINT OF SPILLING COOLANT. THE COOLANT OVERFLOW HOSE IS IN FRONT OF THE REAR TIRE. HONDA HAS IDENTIFIED THE PROBLEM AND ATTEMPTED A FIX BY INSTALLING A NEW ECM, HOWEVER THE PROBLEM STILL EXISTS. *LA
Official recalls
415V700000 · Service Brakes, Hydraulic:foundation Components:master Cylinder
Oct 23, 2015
American Honda Motor Co., Inc. (Honda) is recalling certain model year 2001-2010 and 2012-2015 GL1800, 2001-2005 GL1800A and 2013-2015 GL1800B motorcycles. The rear brakes of the affected motorcycles may drag after the brakes are released.
Consequence & remedy
Consequence: A rear brake that drags may increase the risk of a vehicle crash. Additionally, extended riding with the rear brake dragging could generate enough heat to result in a fire.
Remedy: Honda will notify owners, and dealers will replace the secondary brake master cylinder and the rear brake master cylinder, and flush the brake fluid, free of charge. The recall began on December 7, 2015. Owners may contact Honda customer service at 1-866-784-1870. Honda's number for this recall is JV6. Note: This recall supercedes recall 14V-472.
05V027000 · Structure:frame And Members
Jan 31, 2005
ON SOME MOTORCYCLES, CERTAIN FRAME WELDS DO NOT MEET MANUFACTURING SPECIFICATIONS. HIGH LOADS CREATED WHEN RIDING ON ROUGH ROAD SURFACES OR THROUGH POTHOLES CAN CAUSE THE AFFECTED WELDS TO CRACK.
Consequence & remedy
Consequence: THE WELDED AREA COULD BREAK, RESULTING IN REAR SUSPENSION COLLAPSE OR LOWER CROSS MEMBER SEPARATION, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT AND, IF NECESSARY, REINFORCE THE WELDS ON 2001-2002 MOTORCYCLES FREE OF CHARGE. ON 2003-2004 MOTORCYCLES, THE UNITS WILL BE REPAIRED, NO INSPECTION WILL BE NECESSARY. THE RECALL BEGAN ON FEBRUARY 9, 2005. OWNERS MAY CONTACT HONDA AT 1-866-784-1870.
05V010000 · Service Brakes, Hydraulic
Jan 24, 2005
CERTAIN MOTORCYCLES EQUIPPED WITH COMBINED-BRAKE SYSTEMS HAVE A PROPORTIONING CONTROL VALVE (PCV) THAT MECHANICALLY PROPORTIONS BRAKE FORCE WHEN THE REAR BRAKE IS APPLIED. A SEAL IN SOME PCVS IS IMPROPERLY SHAPED, AND BRAKE FLUID LEAKAGE MAY OCCUR.
Consequence & remedy
Consequence: IF THE MOTORCYCLE CONTINUES TO BE USED AFTER A LEAK OCCURS, THE REAR BRAKE WOULD EVENTUALLY BECOME INOPERATIVE. A LOSS OF REAR BRAKE FORCE COULD INCREASE THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT THE REAR BRAKE FORLEAKAGE. IF LEAKAGE IS CONFIRMED, THE DEALER WILL REPLACE THE PCV FREE OF CHARGE. THE RECALL BEGAN ON JANUARY 31, 2005. OWNERS MAY CONTACT HONDA AT 866-784-1870.
03V350000 · Structure:frame And Members:underbody Shields
Sep 26, 2003
ON SOME MOTORCYCLES, CERTAIN FRAME WELDS DO NOT MEET MANUFACTURING SPECIFICATIONS. HIGH LOADS CREATED WHEN RIDING ON ROUGH ROAD SURFACES OR THROUGH POTHOLES CAN CAUSE THE AFFECTED WELDS TO CRACK.
Consequence & remedy
Consequence: THE WELDED AREA COULD BREAK, RESULTING IN REAR SUSPENSION COLLAPSE OR LOWER CROSS MEMBER SEPARATION, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT AND REINFORCE THE WELDS ON ALL FRAMES. OWNER NOTIFICATION BEGAN DURING OCTOBER 2003. OWNERS SHOULD CONTACT HONDA AT 1-866-784-1870.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.