THE REAR LEFT WHEEL OF THE VEHICLE BROKE OFF FROM THE SUB FRAME MOUNTING POINT WHILE I WAS BACKING UP THE VEHICLE ON MY DRIVEWAY. THE MOUNTING POINT ON THE REAR SUB FRAME WHERE THE LOWER CONTROL ARM IS ATTACHED SEPARATED FROM THE SUB FRAME STRUCTURE. IT APPEARS THAT THE STRUCTURAL FAILURE IS CAUSED BY INTERNAL CORROSION THAT C…
Read full complaint
THE REAR LEFT WHEEL OF THE VEHICLE BROKE OFF FROM THE SUB FRAME MOUNTING POINT WHILE I WAS BACKING UP THE VEHICLE ON MY DRIVEWAY. THE MOUNTING POINT ON THE REAR SUB FRAME WHERE THE LOWER CONTROL ARM IS ATTACHED SEPARATED FROM THE SUB FRAME STRUCTURE. IT APPEARS THAT THE STRUCTURAL FAILURE IS CAUSED BY INTERNAL CORROSION THAT CAN NOT BE SEEN BY EXTERNAL INSPECTION. THE REAR SUB FRAME ON MY VEHICLE IS ORIGINAL AND WAS NEVER DAMAGED. I BELIEVE THE PROBLEM IS POTENTIALLY VERY DANGEROUS FOR OWNER OF THIS VEHICLE MODEL AND OTHERS THAT TRAVEL IN OR NEAR IT. I CONSIDER MY SELF VERY LUCKY IN THAT THE WHEEL DID NOT BROKE OFF WHILE I WAS DRIVING ON A HIGHWAY OR ROAD.*AK
NHTSA ODI #725562
Mileage unknown · Sep 30, 1999
Structure
REAR BEAM WHICH SUPPORTS BOTH LEFT AND RIGHT REAR "A" FRAMES IS RUSTED MORE THAN 3/4 THROUGH CAUSING BEAM TO BEND IN THE CENTER CAUSING REAR WHEELS TO COME OUT OF ALIGNMENT, ALSO WHEN THE PART TOTALLY FAILS BOTH OF MY REAR WHEELS WILL COLLAPSE. I HAD A SIMILAR PROBLEM WITH A HONDA EXCEPT IT WAS THE FRONT BEAM THAT RUSTED THROUGH…
Read full complaint
REAR BEAM WHICH SUPPORTS BOTH LEFT AND RIGHT REAR "A" FRAMES IS RUSTED MORE THAN 3/4 THROUGH CAUSING BEAM TO BEND IN THE CENTER CAUSING REAR WHEELS TO COME OUT OF ALIGNMENT, ALSO WHEN THE PART TOTALLY FAILS BOTH OF MY REAR WHEELS WILL COLLAPSE. I HAD A SIMILAR PROBLEM WITH A HONDA EXCEPT IT WAS THE FRONT BEAM THAT RUSTED THROUGH. I LIVE IN THE NORTHEAST WHERE WE USE SALT IN THE WINTER. CAN I GET THE DEALER TO FIX THIS SAFETY PROBLEM?
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence & remedy
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES. CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. CHECK THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUG ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, THEN PRESS THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS ANY SIGN OF BREAKAGE OR CRACKING, OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, PROMPTLY CONTACT YOUR AUTHORIZED HONDA/ACURA DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT THE FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Illustration