2024 GMC Sierra 3500

The control arm bearing appears to have failed without warning causing loss of steering control. This occurred at low speed on a street in [XXX] last night near a gas station, so the driver was able to drive to a safe location easily without risk to life. Had the failure happened at speed a possibly fatal collision would have been likely. The vehicle has been used for the past 8 months to drive to work and has not been subject to any stress. It has not been modified. The tow truck driver said he has seen a number of other control arm failures recently, not necessarily in the same vehicle type. It may be due to bad pot holes this year in [XXX] , they are bigger and deeper than normal. This information is based on assessment by tow truck driver last night. Vehicle is at Jim Shorkey in Murrysville for repairs INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

since new there is a violent vibration in the steering wheel and floor boards. steering wheel oscillates side to side at speed from 38mph to very bad at 65mph. Dealer has had it 5 times and still cant fix it. they state the front hub extensions are out of round and have tried 3 sets without any success. this truck is not safe to drive as it will put your hands to sleep due to the vibration. Also it will cause premature system component failure. the GM forum and Duramax forum is showing many cases nation wide with this symptom. Also there is NO provision with the current 18 inch wheel to index concentrically with the mating hubs on all four wheel locations This is mainly affection the Dually wheel Denali or high-country vehicles

The contact owns a 2024 GMC Sierra 3500 equipped with Michelin Tires, Tire Line: Primacy, Tire Size: LT235/80/R18, DOT Number: (Not Available). The contact stated that while driving at an undisclosed speed, the passenger’s side front tire tread was separating, and the vehicle was vibrating. The contact stated that the inner rim was bent, and additionally, the steering gear box was leaking. The steering wheel was uncontrollable. There were no warning lights illuminated. The vehicle was taken to the local dealer on several occasions and was diagnosed that the steering gear box was leaking and needed to be replaced. The contact also stated that the air bag chip was inoperable. The vehicle was repaired, but the failure recurred. The manufacturer was contacted and opened a case. The contact was seeking a buyback. The tire and vehicle failure mileage was approximately 250.

The vehicle has had steering and alignment issues since the day I purchased the truck. The steering wheel is not centered. The steering wheel is always turned to the left but the vehicle pulls to the right. I have had it at my local dealership five times and they have confirmed what I have described but they are not able to fix the issue fully. They have rotated the tires 3 times and have aligned it all five times. The vehicle will be good for about 100 miles and will go out of alignment again. The dealership explained to me that they are experiencing this with all 2024 Chevy and GMC heavy duty trucks. The vehicle is very difficult to keep straight especially at higher speeds on the interstate. I am part of a 2024 Chevy and GMC owners facebook page and hundreds of consumers are complaining of the same issue.