2023 GMC Sierra 1500

My 2023 GNC Sierra 1500 has experienced a recurring electrical and safety-related malfunction on multiple occasions while driving. The dashboard and warning lights intermittently flash on, and off and numerous warning messages appear simultaneously. During previous occurrences, warnings included power steering service, safety restraint system, check engine and transmission related messages, including a message instructing me to pull over and shut the vehicle off. During one occurrence, the electric power steering assist stopped working while I was driving. The vehicle was taken to an authorized GMC dealership multiple times while under the factory warranty. The dealer replaced the Brake System Control Module and performed vehicle-wide software/programming updates. When the problem continued, the dealer contacted GM Technical Assistance. The Dealer subsequently diagnosed an intermittent open circuit involving the electric power steering rack-and-pinion/steering gear assembly and replaced the complete steering gear assembly. Despite these repairs, the malfunction has occurred again, during another occurrence while driving on the freeway, the dashboard flashed on and off and multiple warning lights and messages repeatedly appeared, similar to the condition that occurred before the steering gear was replaced. The vehicle currently has approximately 55,000 miles. The condition remains intermittent despite multiple repair attempts. I am concerned that this recuring electrical or vehicle communication failure could again cause loss of power steering assistance or affect other safety-related vehicle systems while driving.

The vehicle has suffered repeated systemic electrical failures all while being under 8,000 miles. What component/system failed? Power distribution/fuse block, starter, fuel pump control module, horn circuit, body control module, instrument cluster, and charging system. Error codes documented include P0627 (Fuel Pump Control Circuit), U0100 (Lost Comm ECM/PCM), B1325 (Control Module Power Low), U0140 (Lost Comm BCM), and B1000 (ECM fault). All repairs are documented by the dealer, and the truck remains available for inspection. How was safety at risk? The truck lost propulsion at speed, emitted smoke from the engine bay, and became disabled in traffic, placing my family, including my toddler, in immediate danger of collision and fire. Electrical defects also disabled horn and instrument cluster, removing critical warning and signaling functions. These electrical issues have been ongoing for months and GM refuses to replace and can't seem to fix it. Has it been confirmed? Yes. Each failure was diagnosed and confirmed by an authorized GM dealer. Components replaced include fuse block, starter, fuel system computer, horn assembly, and cluster. Despite repairs, issues recur. Inspected by others? GM corporate case managers are aware and have acknowledged defects, though they have refused to issue written determinations. Insurance has not yet been involved, but records are available. The dealer has attempted to repaid more than 4 times with no success. Warning lamps/messages? Yes. Prior to and during failures, vehicle displayed repeated “Service Electrical System,” “Low Voltage,” and communication fault codes. Cluster intermittently blacked out. Smoke in engine bay indicated immediate fire hazard. Cumulative out-of-service days exceeding 20. The failures pose unacceptable risk of fire, sudden propulsion loss, and loss of critical safety functions. I have ALL calls with GM recorded and transcribed as I am in SC (single party recording state) and can provide those.

I just left the gas station from getting a beverage, I got onto the interstate and had gone roughly about 3 miles before setting super cruise a few minutes after that the interstate takes a turn to the left with an exit on the right. Slightly right as I was just getting into the turn my engine shutoff and or died making my truck uncontrollable causing me to drive off the interstate into some small trees between the exit and the interstate. I was not injured and no other vehicles were involved. My truck is currently at the insurances storage yard and they care claiming it to be totaled. I have contacted GM and filled a claim however they are saying they aren’t responsible because the insurance company has my truck. I feel like regardless of who has my vehicle the manufacturer should be responsible if the issue pertains to a specific recall that has already been issued 2 weeks after my accident. I have contacted several lawyers but since I wasn’t injured they aren’t interested in taking my case. My concern is I’m getting screwed over financially because my truck was only a year old and now my insurance is going to be crazy expensive when the manufacturer should be the one taking responsibility for this and not myself.

What component or system failed or malfunctioned, and is it available for inspection upon request? Rubbing noise when turning the steering wheel. Truck has 8800 miles on it. How was your safety or the safety of others put at risk? Wasn’t able to fix on day diagnosed need to order parts. Only vehicle I have. When asked if I can continue to drive I was told if a problem arises to stop?!? Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. They confirm there is a steering gear issue. Parts in order. Was told it’s a big deal and will need it for several days to fix. 8800 miles on truck! Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others?no Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No warning lamps. Noticed it when turning into my garage at lower speeds.

Subject: Safety Complaint Regarding Steering Airbag Trim and Steering Axle Issues Dear National Highway Traffic Safety Administration (NHTSA), I am writing to formally file a complaint regarding serious safety issues with my GMC vehicle. Specifically: 1.The steering airbag trim has begun to crack, which raises concerns about its structural integrity and potential interference with airbag deployment in the event of a collision. 2.The steering axle is making unusual noises due to loose bolts and worn bushings, posing a potential risk to steering control and overall vehicle safety. I recently took the vehicle to an authorized GMC dealership for inspection and repair. However, the dealership refused to address these issues despite their clear impact on safety and their apparent connection to manufacturing defects. Given the critical nature of these problems, I urge the National Highway Traffic Safety Administration (NHTSA) to investigate this matter thoroughly. These defects not only compromise the safety of the vehicle but also endanger the lives of the driver, passengers, and others on the road. Thank you for your attention to this matter. I am happy to provide any additional information or documentation required for your investigation.

While at highways speeds, the steering will not return to center while going/coming out of a curve. It acts as if the power steering system is failing or low on fluid but that is not the case. I’m aware of a current recall with the Sierra but my VIN does not fall into the recall. The recall is for a software fix. GMC will not look into without charging me. This is a safety issue while driving. It holds the steering wheel in the turning position and I have to pull it to center.

Pulled up to a stop sign and attempt to make a right turn as I was in the turn the steering wheel locked up in the turn which almost caused and accident . I had to get the vehicle towed to Wyatt Johnson GMC dealership in Clarksville TN. I purchased this truck in Jan 2024 from Romain Cross Pointe Auto Park in Evansville ,Indiana at 7600 E Division St, Evansville, IN 47715 it had 13k miles. I'm the second owner I only put 2k miles since ownership. I was able to obtain a vehicle history report which shows this has been an on going problem among other issues DTC code U0131 Lost communication with Power steering Module shows at least 9 times that Romain GMC try to fix the problem. This is extremely dangerous to drive and the steering goes out this has been a known problem.. See attachments

We drove our Truck from Hartwell Georgia to Coloma Wisconsin on [XXX]. En route we drove through heavy rain. We got to Coloma on [XXX]. The truck sat outside overnight in cold weather. Temps were in the low 20's to high teens. On [XXX] I went out to drive the truck to town on errands. After starting it the steering would not move. Had the truck towed to Wheelers Chevrolet of Coloma. Weather had warmed up and the steering was working. The dealer kept the truck and let it sit outside overnight. The next morning they started it and the steering would not move. The brought the truck into the heated garage and after a hour or so the steering worked. They decided to keep it inside and dry it out. It sat in a heated garage till noon on the [XXX] at which time I took the truck to my wife's brother house and put it in a heated garage till we left on the morning of the [XXX] to head back home. Temps all day were below zero. We pulled off the road after about two hours and the steering began to bind up. Rotating the wheel got it loosened up and we elected to continue. About 15 minutes later on [XXX] at highway speed the steering began to lock up. I managed to get it to the side of the road. . Again rotating the wheel side to side for about 5 minutes got it to free up. We continued and made it home. Clearly there is water somewhere in the steering. Pretty scary having locked steering at speed. No problems in warm weather. I will be going to my GMC dealer today. Richard Kay superstore in Anderson SC. My service techs name at Wheelers Chevy was David Borre. Phone number 715-600-3358 INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)