Latches/locks/linkages. Review the 15 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Seat Belts. Review the 15 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Structure. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

6 crash reports1 fire reports8 injury reports

What owners actually said

50 reports

71,800 miles · Jul 12, 2004

Seats

WHILE GETTING INTO THE VEHICLE DRIVER'S SEAT RECLINED. DEALER WAS NOT NOTIFIED. *AK

NHTSA ODI #10081701

Mileage unknown · May 22, 2003

Seat BeltsCrashInjury

THE VEHICLE WAS INVOLVED IN A SINGLE CAR COLLISION WHERE BOTH THE DRIVER AND PASSENGER SEAT BELTS BECAME UN-BUCKLED, WHICH RESULTED IN THE PASSENGER BEING EJECTED FROM THE VEHICLE AND KILLED. RELATED RECALL 95V103007, MANUFACTURER ADVISED THE CONSUMER'S VEHICLE IDENTIFICATION NUMBER WAS NOT INCLUDED. *JB

NHTSA ODI #10020385

Mileage unknown · Oct 28, 2002

Structure

CONSUMERS HUSBAND WAS IN MOTION WHEN THERE WAS A POPPING SOUND, FOLLOWED BY LOST OF CONTROL OF THE VEHICLE. ALL BRAKING AND STEERING POWER WAS LOST. THE VEHICLE WAS TOWED TO A MECHANIC WHO INFORMED CONSUMER THAT THE UNISTRUT FRAME ON THE VEHICLE HAD BROKEN. CHEVROLET DETERMINED THAT THE CAUSE OF THE FAILURE WAS ENVIRONMENTAL …

Read full complaint

NHTSA ODI #567807

Mileage unknown · Apr 9, 2001

Fuel System, Gasoline

GUARDS THAT COVER FUEL LINES UNDERNEATH VEHICLE FELL OFF WHILE DRIVING. *AK *SLC

NHTSA ODI #885396

Mileage unknown · Apr 9, 2001

StructureSuspensionWheels

WHILE DRIVING VEHICLE FELT LIKE IT HAD A FLAT, VEERING TO RIGHT. ALSO GRINDING NOISE. WHEEL ASSEMBLY WAS TORN AND RUBBED ON WHEEL WELL FRAME. *AK CONSUMER STATES THAT THE FRAME WHERE CONTROL ARM ATTACHES FAILED DUE TO EXTENSIVE CORROSION. *SLC

NHTSA ODI #885377

Mileage unknown · Jan 30, 2001

Latches/locks/linkages

Read full complaint

RESEARCHED THE NHTSA WEBSITE AND SHOWED A RECALL ON THE HOOD STRIKER ASSEMBLY UNIT! MY HOOD FLUNG OPEN IN THE MIDDLE OF THE INSTERSTATE, CAUSING THE HOOD TO HIT THE MAIN WINSHIELD AND CRACK! LUCKILY THE WINDSHIELD ITSELF DID NOT IMPLODE AND CAUSE SERIOUS DAMAGE OR DEATH TO ME! AND LUCKILY THE INTERSTATE WAS NOT BUSY, TO HAVE CAUSED A MAJOR ACCIDENT! I DID VIEWED MY VEHICLE. THE LATCH ITSELF IS NOT WORKING PROPERLY! ACCORDING TO THE RECALL, GM DEALER WILL REPLACE THE "BOLTS" TO PREVENT THE HOOD TO FLY OPEN. HOWEVER, THE PROBLEM IS THE WITHIN THE HOOD LATCH "ASSEMBLY" UNIT, THE LATCH ITSELF IS DEFECTIVE. IT DOES NOT "CATCH" ONTO THE "PRIMARY" LOCK OF THE HOOD LATCH. I BELIEVE IT IS ACTUALLY THE ENTIRE "HOOD LATCH" UNIT THAT NEEDS RECALL/REPLACEMENT. I AM GETTING THE IMPRESSION, CHEVROLET IS NOT WILLING TO TAKE RESPONSIBILITY FOR THIS DEFECT, STATING THAT PERHAPS IT WAS DUE TO A RECENT OIL CHANGE THAT THE HOOD WAS NOT PROPERLY SHUT. I HAVE HAD THE CAR FOR CLOSE TO 10 YEARS AND HAVE CHANGED THE OIL MYSELF AND OTHERS, MANY TIMES. I KNOW THAT CAR INSIDE AND OUT, AND INFACT TOOK THE CAR ON THE INTERSTATE THE NIGHT PRIOR TO THE HOOD FLYING OPEN (1/24/01). I BELIEVE THE DEFECT IS IN THE HOOD LATCH ITSELF, BECAUSE IT IS PART OF THE HOOD LATCH ASSEMBLY UNIT!*AK

NHTSA ODI #740144

Mileage unknown · Aug 3, 2000

Seat BeltsCrash

DRIVER'S SEATBELT MALFUNCTIONED. IN A CRASH DRIVER WAS SEATBELTED, BUT SHOULDER BELT DID NOT RETRACT, WHICH CAUSED THE DRIVER TO HIT THE WINDSHIELD. PRIOR TO THE CRASH, DEALER HAD FIXED THE DEFECTIVE DRIVER'S SHOULDER BELT FOR THE RETRACTOR. PLEASE PROVIDE FURTHER INFORMATION. *AK

NHTSA ODI #866701

Mileage unknown · Dec 22, 1999

Air Bags

VEHICLE WAS INVOLED IN AN ACCIDENT IN WHICH THE ANOTHER VEHICLE STRUCK CONSUMER'S VEHICLE ON DRIVER'S SIDE . SPEED WAS UNDETERMINED AT THE TIME. UPON IMPACT, DRIVER'S AIR BAG FAILED TO DEPLOY. DEALER/MANUFACTURER WERE NOT CONTACTED AT THIS TIME. *AK

NHTSA ODI #854331

Mileage unknown · Nov 18, 1999

Fuel System, Gasoline

THERE IS A FUEL LEAK IN THE VEHICLE DUE TO THE LOCATION/POSITIONING OF THE FUEL FILLER NECK. CONSUMER HAS CONTACTED THE DEALER. RUBBER COATING ON THE FILLER TUBE FAILED, ALLOWING SALT FROM THE ROAD TO COME IN DIRECT CONTACT WITH METAL FILLER TUBE. TUBE IS LESS THAN 6 INCHES FROM LEFT REAR WHEEL IN PERFECT SPOT FOR ROAD SPR…

Read full complaint

NHTSA ODI #851969

Mileage unknown · Oct 31, 1999

Structure

WE WERE NOT AWARE THAT THIS PROBLEM HAD BEEN SUBJECTED TO RECALL EARLIER AND OUR DEALER REFUSED TO REPAIR THE LATCH OR OFFER TO REPLACE THE WINDSHIELD BROKEN DUE TO THE HOOD FLYING UP AS OF 10/30/1999

NHTSA ODI #714128

Official recalls

95V103007 · Seat Belts:front:buckle Assembly

May 24, 1995

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence & remedy

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

93V189001 · Latches/locks/linkages:hood:latch

Nov 23, 1993

MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.

Consequence & remedy

Consequence: AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.

Remedy: GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗