Owner reports · Recalls · Investigations
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →Owner complaints by model year
Compare all Coe years →Counts vary with age, sales and reporting. They are not failure rates.
No component reports in this snapshot.
Tap a category to read its complaints. One report may name several components.
Mileage at the reported incident
Limited mileage data: 0 of 0 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
NHTSA owner reports · September 18, 2026 snapshot.
No matching complaints in this snapshot.
Jul 24, 1989
THE STEERING GEAR MOUNTING BRACKET WELDS MAY CRACK UNDER CERTAIN STEERING LOAD CONDITIONS.
Consequence: STEERING CONTROL WOULD BE ADVERSELY AFFECTED WITHPOTENTIAL FOR LOSS OF TRUCK CONTROL AND AN ACCIDENT.
Remedy: REPLACE STEERING GEAR MOUNTING BRACKET WITH A REDESIGNED BRACKET.
Jun 5, 1989
CORROSION OF THE GRABHANDLE AT ITS MOUNTING SURFACE MAY LEAD TO CRACKING OR LOSS OF STRENGTH.
Consequence: FAILURE OF GRABHANDLE DURING USE COULD RESULT INPERSONAL INJURY.
Remedy: REPLACE GRABHANDLE AND ITS FASTENER WITH IMPROVED GRABHANDLE; ALSO, INSTALL GASKET BETWEEN THE HANDLE AND AIR STARTER RESERVOIR.
Aug 16, 1988
THE HEATER/AIR CONDITIONER BLOWER MOTOR SPEED CONTROL RESISTORS CAN UNDER CERTAIN CONDITIONS OVERHEAT AND STALL.
Consequence: THIS COULD RESULT IN LOW AIR FLOW ACROSS THE RESISTORNETWORK AND HIGH AMPERAGE, ALLOWING THE AIR DUCT TO REACH ELEVATED TEMPERATURESWITH THE POSSIBILITY OF A FIRE.
Remedy: INSTALL A THERMO CUTOFF DEVICE IN THE HEATER/AIR CONDITIONER SYSTEM AND/OR REPLACE THE BLOWER MOTOR SWITCH.
Aug 26, 1986
THE HANDHOLD MOUNTING SYSTEM, WHICH CONSISTS OF A TUBULAR HANDLE HELD IN THREE PLACES BY CAST ALUMINUM BRACKETS AND ATTACHED TO THE ENGINE EXHAUST MUFFLER HEAT SHIELD. VIBRATION FROM THIS SYSTEM CAUSES THE HANDHOLD PARTS TO WEAR. CONSEQUENCE OF DEFECT: IF THE PARTS WEAR THIN THE POSSIBILITY EXISTS THAT THE HANDHOLD MIGHT GIVE WAY UNDER THE WEIGHT OF A DRIVER. THIS COULD RESULT IN PERSONAL INJURY.
Consequence: Not supplied
Remedy: REPLACE THE END BRACKETS WITH A MODIFIED DESIGN UTILIZING A RUBBER ISOLATER. ALSO, ADD A PLASTIC SLEEVE TO THE CENTER BRACKET FOR ISOLATION.
Jun 11, 1985
CRACKS CAN DEVELOP IN THE OIL FILTER MOUNTING BRACKETS NEAR THE BOLTS THAT ATTACH THE BRACKETS TO THE FRAME SIDE MEMBER. CONSEQUENCE OF DEFECT: IF CRACKS PROGRESS TO THE POINT OF FAILURE, THE FILTER ASSEMBLY COULD FALL OUT AND POSSIBLY BE STRUCK BY OTHER VEHICLES CREATING A POTENTIAL FOR AN ACCIDENT.
Consequence: Not supplied
Remedy: BRACKETS WILL BE REPLACED WITH IMPROVED DESIGN BRACKETS.
Mar 2, 1984
THE TUBES PROVIDED AS HANDHOLDS MAY CRACK OR FRACTURE WHERE THE STEPS AND ATTACHING BRACKETS ARE JOINED.
Consequence: Not supplied
Remedy: COMPLETE STEP AND HANDHOLD SYSTEMS WILL BE REPLACED WITHOUT CHARGE.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
No exact-year investigations in this snapshot.
Illustration