2018 Ford Fusion

On 11/17, I received a shift system failure alert. The car would not go into park and I could not start the vehicle. We contacted the dealer to have the car towed. The dealer indicated there was a current recall for the same issue however this car was not included. There is a known issue with other ford fusions. As a result I am having to pay out of pocket for the fix. The recall should be expanded to include 2017-2018

The contact owns a 2018 Ford Fusion. The contact stated while driving approximately 40 MPH, the transmission inadvertently shifted into a lower gear. The contact stated that the gear shifter failed to shift. The vehicle was towed to an independent mechanic where it was diagnosed that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 72,000.

I was driving and all of the sudden engine overheated and car could not drive over 10MPH during an extremely bad storm at night on the highway putting me in extreme danger if someone were to have been behind me. There were no engine lights on or warning signs of this happening and just happened out of nowhere car was driving fine before it happened. Issue happened on September 26th, 2023. This is the second engine problem I have had since getting the car in 2021. Last issue was with the top half of the engine CAC/intake manifold and luckily was under warranty or would have been over $6,000. Had vehicle towed to Ford dealership and there verified a check engine light fault. P0303 active in PCM. Upon diagnosing the concern found that the head gasket is leaking into cylinder 2 and 3 due to a failed cylinder block assembly. Need to replace the short block assembly with an updated design. Was quoted $8,700 to fix the issue. I can't afford to pull that kind of money out to fix a car that isn't even 5 years old. Car is no longer under warranty.

The contact owns a 2018 Ford Fusion. The contact stated that the vehicle was hesitating while driving uphill. There was no warning light illuminated. The failure persisted and the vehicle entered LIMP Mode and jerked while depressing the accelerator pedal. The contact also stated that the gear shifter dial became firm and made it difficult to shift the vehicle out of park(P). An unknown dealer and the manufacturer were notified of the failure and informed the contact there was no recall associated with the failure. The vehicle had yet to be repaired. The failure mileage was approximately 100,000.

The contact owns a 2018 Ford Fusion. The contact stated that she initially received a notice in the mail about a Customer Satisfaction Program-19B37. The contact took the vehicle to the dealer and was informed that the program was cleared off the vehicle. The contact then stated that while driving at various speeds, the vehicle would hesitate upon depression of the accelerator pedal as the "Service Engine" warning light appeared on the instrument panel. In addition, the vehicle would fail to start upon refueling. The contact used a code reader which determined that the purge valve was defective, and the part was replaced. Once the purge valve was replaced, the vehicle was restarted, and the code reader then showed a misfire in cylinder #2. The contact replaced the spark plugs and engine coils but then noticed moisture in the engine block. The vehicle was taken to the dealer for a diagnostic test where the mechanic confirmed coolant intrusion in the engine block. The contact was informed that the engine needed to be replaced. The dealer reached out to the manufacturer and was informed by text that manufacturer would not assist with the repair of the vehicle. Upon investigation, the contact linked the failure to Customer Satisfaction Program: 19B37. The contact called the manufacturer herself and the manufacturer denied the program. The vehicle was not repaired. The failure mileage was approximately 78,000.

The contact owns a 2018 Ford Fusion. The contact stated while driving 40 MPH, the vehicle suddenly stalled. The message " Shift Sys Fault. Service Required" was displayed. The contact was unable to pull to the side of the road. The contact stated that she turned off and restarted the vehicle, but the vehicle failed to respond as needed. A bystander assisted the contact in manually moving the transmission shifter cable bushing back into position. The contact stated vehicle then responded as needed; however, the failure recurred while driving and hitting a pothole. The transmission shifter cable bushing was manually moved back into position. The vehicle was taken to the dealer, who determined that the failure was related to the transmission shifter cable bushing; however, the vehicle was not diagnosed nor repaired. The contact purchased the part from the dealer, and the vehicle was taken to an independent mechanic, who replaced the part. The mechanic informed the contact that the repair was temporary, and that she would need to take the vehicle to dealer for an adequate repair. The dealer was contacted and stated that the earliest availability was in 3 weeks. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA hotline for assistance. The failure mileage was approximately 75,000.

The contact owns a 2018 Ford Fusion. The contact stated that upon starting the vehicle, the shift system fault message was displayed on the instrument panel and the vehicle failed to shift out of park. After several attempts, the contact was able to drive the vehicle to the dealer. The contact was informed that the shifter cable bushing was missing and needed to be replaced. The manufacturer was not notified of the failure. The vehicle was repaired. The failure mileage was approximately 99,000.

The contact owns a 2018 Ford Fusion. The contact stated when the vehicle was started, the contact turned the shifter knob to drive (D) however, the knob would not turn and appeared to be frozen in park (P). The contact stated no warning light was illuminated. The contact had the vehicle towed to an independent mechanic who retrieved DTC codes indicating that the transmission needed to be serviced by a dealer. The vehicle had not been repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 148,000.

The contact owns a 2018 Ford Fusion. The contact stated that after starting the vehicle, it was discovered that the rotary knob transmission selector had become stuck in park, and the vehicle could not be driven. Additionally, on several occasions after switching the transmission selector knob to park and turning the vehicle off, the selector had erroneously shifted from park and the vehicle could not be immediately restarted. The cause of the failures was not yet determined. The manufacturer was notified of the failure, but no assistance was offered. The failure mileage was 50,000.

The contact owns a 2018 Ford Focus. The contact stated that while the vehicle was parked, the contact became aware that the gear shift indicator erroneously showed that the vehicle was in reverse(R). The gear shifter warning light was illuminated. The vehicle was towed back to the residence. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and confirmed that the VIN was not under recall. The failure mileage was unknown.