Tires. Review the 35 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Engine And Engine Cooling. Review the 28 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Power Train. Review the 19 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

10 crash reports25 fire reports2 injury reports

Steering complaints

17 reports

Clear category filter

300,000 miles · Dec 25, 2014

Steering

THIS IS NOT A COMPLAINT BUT TO LET EVERYONE KNOW WHAT I HAVE FOUND TO BE PART OF THE PROBLEM ON THE STEERING NOT RETURNING AFTER A TURN. THE STEERING COLUMN BEARING IN THE TOP OF THE COLUMN IS BAD. I HAVE HAD TO REPLACE AT LEAST 20 OF THESE FOR THIS COMPLAINT AND FIXED THE PROBLEM. THE LOCKING OF THE STEERING WHEN BREAKING IS A …

Read full complaint

NHTSA ODI #10668218

77,600 miles · May 4, 2011

Steering

TL*THE CONTACT OWNS A 1996 FORD F250 DIESEL. THE CONTACT STATED THE STEERING COLUMN BECAME VERY LOOSE WHILE DRIVING. THE VEHICLE WAS NOT TAKEN TO THE DEALER FOR DIAGNOSTIC TESTING. THE FAILURE MILEAGE WAS 77,600.

NHTSA ODI #10399114

263,000 miles · Mar 9, 2011

Steering

Read full complaint

TL* THE CONTACT OWNS A 1996 FORD F250 DIESEL. THE CONTACT WAS ENTERING A RESIDENTIAL PARKING GARAGE WHEN THE STEERING WHEEL COMPLETELY FRACTURED FROM THE VEHICLE. THE CONTACT WAS ABLE TO MAINTAIN CONTROL OF THE VEHICLE AND ENGAGED THE EMERGENCY BRAKE TO BRING IT TO A STOP. THE VEHICLE WAS TOWED TO A LOCAL REPAIR SHOP WHERE THE MECHANIC DIAGNOSED THE FAILURE AS A WEAK STEERING COLUMN WHICH WOULD REQUIRE REPLACING. THE MANUFACTURER WAS CONTACTED AND OFFERED NO ASSISTANCE. THE VEHICLE WAS REPAIRED. THE FAILURE AND CURRENT MILEAGE WAS 263,000.

NHTSA ODI #10386991

80,280 miles · Nov 18, 2010

Steering

1996 FORD, F250, 7.3 LITER DIESEL: HIGH PRESSURE POWER STEERING HOSE FAILED AT CONNECTION TO THE POWER STEERING PUMP. THE FAILURE OCCURRED WHEN BACKING OUT OF A PARKING SPACE. THE CAUSE OF THE FAILURE IS DUE TO FAILURE OF AN INTERNAL PLASTIC COMPONENT THAT CONNECTS THE TUBING TO THE CONNECTING NUT/FITTING. REPLACED WITH A FABRIC…

Read full complaint

NHTSA ODI #10366654

Mileage unknown · Oct 6, 2003

Steering

VEHICLE WAS TAKEN TO A SERVICE TECHNICIAN BECAUSE THE STEERING WHEEL WAS VERY LOOSE. TECHNICIAN REPLACED SEVERAL PARTS WITHIN THE STEERING COLUMN. *AK

NHTSA ODI #10042400

Mileage unknown · Aug 26, 2002

SteeringCrash

WHILE DRIVING STRAIGHT VEHICLE SUDDENLY MADE A 45% TURN AND REAR ENDED ANOTHER CAR. STEERING COLUMN SPLIT IN HALF. CONSUMER LOST CONTROL OF VEHICLE, WENT INTO ONCOMING TRAFFIC BEFORE SLAMMING ON BRAKES. PLEASE PROVIDE ANY FURTHER INFORMATION.*AK

NHTSA ODI #8017152

Mileage unknown · Jun 4, 2001

Steering

WHILE DRIVING ABOUT 10 MPH POWER STEERING WENT OUT, MECHANIC FOUND RETAINING RING THAT HOLDS THE PRESSURE SIDE OF THE POWER STEERING FLUID HOSE IN PLACE HAD SNAPPED. HE CHANGED A COUPLE OF THEM PER WEEK. VEHICLE HAS STANDARD POWER BOOSTER.*AK *SLC

NHTSA ODI #889655

Mileage unknown · Oct 18, 2000

Electrical SystemEngine And Engine CoolingEquipment

Read full complaint

VEHICLE WOULD NOT START. CONSUMER HAD CAR TOWED TO DEALER, AND THEY SAID VEHICLE NEEDED A TUNE UP AND COIL PACK REPLACE. DEALER SAID THAT PLUGS WOULD NOT COME OUT BECAUSE THEY WERE STUCK. SO CONSUMER WAS NOT ABLE TO DRIVE VEHICLE BECAUSE THE PLUGS WON'T COME OUT. DEALER CHARGED A $1000 TO TAKE THEM OUT.*AK THE LIGHT AT THE REAR OF THE VEHICLE FAILED. THE STARTER FAILED THREE TIMES. A/C FAILED. THE GEAR SHIFTER FAILED. THE EXHAUST SYSTEM FAILED. BRAKE CALIPER AND ROTOR FAILED. WIRES UNDERHOOD RUST OUT. POWER STEERING HOSE FAILED. *YH

NHTSA ODI #873293

Mileage unknown · Sep 13, 1999

Engine And Engine CoolingSteering

BOLT THAT HOLDS THE POWER STEERING SNAPPED IN HALF. AFTER SNAPPING IN HALF, VIBRATED OUT TOWARDS POWER STEERING PUMP PULLEY, CAUSING THE PULLEY TO LOCK UP, AND BREAKING THE POWER STEERING PUMP BRACKET. THI S CAUSED THE MAIN DRIVE BELT TO COME OFF, LEAVING CONSUMER WITHOUT BRAKES OR STEERING. *AK

NHTSA ODI #847585

Mileage unknown · Dec 7, 1998

Steering

BEARING FAILED ON BELT TENSIONER CAUSING ME TO LOSE THE SERPENTINE BELT WHICH CONTROLS POWER STEERING,COOLING,CHARGING,AND BASICALLY EVERYTHING.ENGINE DID OVERHEAT,BUT I WAS LUCKY ENOUGH TO CLOSE TO AN EXIT IN WEST VIRGINIA.AFTER I TALKED TO SOME PEOPLE I FOUND THAT AT LEAST 6 OTHER PEOPLE HAVE HAD SIMILAR PROBLEMS.I CONTACTED F…

Read full complaint

NHTSA ODI #701158

Official recalls

06V286000 · Vehicle Speed Control

Aug 1, 2006

ON CERTAIN TRUCKS EQUIPPED WITH SPEED CONTROL, GASOLINE OR NATURAL GAS ENGINES, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT.

Consequence & remedy

Consequence: OVERHEATING COULD RESULT IN SMOKE OR BURN AND AN UNDERHOOD FIRE.

Remedy: DEALERS WILL INSTALL A FUSED WIRING HARNESS INTO THE SPEED CONTROL SYSTEM FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 7, 2006. OWNERS MAY CONTACT FORD AT 1-866-436-7332. (NOTE: ALSO SEE RECALLS 05V017 AND 05V388)

05V388000 · Vehicle Speed Control

Sep 7, 2005

ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH SPEED CONTROL, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT, SMOKE, OR BURN.

Consequence & remedy

Consequence: A FIRE AT THE SWITCH COULD OCCUR.

Remedy: BY LETTER DATED SEPTEMBER 12, 2005, OWNERS WERE INSTRUCTED TO RETURN THEIR VEHICLES TO THEIR DEALERS TO HAVE THE SPEED CONTROL DEACTIVATION SWITCH DISCONNECTED. OWNERS WHO HAVE HAD THEIR SPEED CONTROL DEACTIVATED ARE BEING NOTIFIED THAT PARTS WILL BE AVAILABLE AND ADVISED TO MAKE AN APPOINTMENT TO RECONNECT THE SPEED CONTROL BEGINNING IN FEBRUARY 2006. OWNERS WHO DID NOT HAVE THEIR SPEED CONTROL DEACTIVATED ARE BEING NOTIFIED TO HAVE THEIR SYSTEM REMEDIED BEGINNING IN FEBRUARY 2006. OWNERS ARE URGED TO AVAIL THEMSELVES OF THE FREE DISCONNECT SERVICE AS SOON AS POSSIBLE BECAUSE OF THE SIGNIFICANT RISK OF FIRE. OWNERS MAY CONTACT FORD AT 1-800-392-3673. (NOTE: ALSO SEE RECALLS 05V017 AND 06V286)

96V161000 · Equipment:other:labels

Aug 29, 1996

THE CERTIFICATION LABELS ON THE INVOLVED VEHICLES HAS INCORRECT REAR TIRE INFLATION PRESSURE DESIGNATIONS. THIS DOES NOT COMPLY WITH FMVSS NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS."

Consequence & remedy

Consequence: INCORRECT INFLATION PRESSURES COULD CAUSE PREMATURE WEAR OF THE REAR TIRES. .

Remedy: OWNERS WILL BE PROVIDED WITH CORRECT CERTIFICATION LABELS AND INSTRUCTIONS FOR INSTALLING THESE LABELS. DEALERS CAN INSTALL THIS LABEL IF THE OWNER SO DESIRES.

96V146000 · Structure:frame And Members

Aug 1, 1996

THE CROSSMEMBER FRAME GUSSETS WERE INSTALLED WITH UNDERSIZED THREADED FASTENERS FOLLOWING A BREAKDOWN OF THE PRODUCTION RIVET GUN THAT IS GENERALLY USED. THIS GUSSET IS THE ATTACHMENT POINT FOR THE REAR STRAP OF THE MID-SHIP FUEL TANK.

Consequence & remedy

Consequence: THE SUBJECT FASTENERS CAN SEPARATE CAUSING IN THE REAR STRAP OF THE AFFECTED FUEL TANK TO BECOME DISCONNECTED. A LOOSE OR DISCONNECTED REAR STRAP ALLOWS THE FUEL TANK TO POSSIBLY CONTACT THE ROAD SURFACE INCREASING THE RISK OF A VEHICLE FIRE.

Remedy: DEALERS WILL REPLACE THE CROSSMEMBER GUSSET FASTENERS WITH THE SPECIFIED ALTERNATIVE FASTENERS (BOLTS).

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

EA05005 · Engine Compartment Fires

Opened Mar 22, 2005 · Closed Aug 2, 2006

Status: closed (inferred from source dates) · Electrical System; Electrical System:wiring:front Underhood; Vehicle Speed Control:cruise Control

EA05-005 IS CLOSED WITH FORD?S ACTIONS IN RECALLS 05V-017, 05V-388, AND 06V-286, RECALLING APPROXIMATELY 6.7 MILLION VEHICLES EQUIPPED WITH TEXAS INSTRUMENTS SPEED CONTROL DEACTIVATION SWITCHES (SCDS).THE BRAKE SYSTEMS IN THESE RECALLED VEHICLES GENERATE A VACUUM THAT CAN POTENTIALLY CAUSE THE SCDS TO FAIL AND, IN CERTAIN SWITCH INSTALLATION ORIENTATIONS, CATCH FIRE.FORD IS ALSO INCLUDING THE ENTIRE POPULATION OF 1998 EXPLORERS.FORD HAS INFORMED ODI THAT TESTING TO DETERMINE THE CAUSE OF FAILURES IN THE 1998 EXPLORERS WILL CONTINUE AFTER THIS INVESTIGATION IS CLOSED.ODI BELIEVES THAT THE VEHICLES EXHIBITING THE FACTORS CAUSING SCDS FAILURE DESCRIBED IN THIS REPORT CORRELATE WELL WITH THE OBSERVED FAILURE RATES ON THESE VEHICLES BY MODEL AND MODEL YEAR.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT A SAFETY-RELATED DEFECT DOES NOT EXIST IN THE NON-RECALLED VEHICLES MANUFACTURED WITH SCDS THAT ARE NOT INCLUDED IN FORD?S RECALLS.ODI WILL CONTINUE TO MONITOR THE NON-RECALLED POPULATION FOR INCIDENCE OF ENGINE COMPARTMENT FIRES.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.SEE ATTACHED CLOSING REPORT FOR DETAILS.

Additional source detail variants (21)

Electrical System

Electrical System:wiring:front Underhood

Vehicle Speed Control:cruise Control

PE96052 · Separated Front Suspension

Opened Aug 23, 1996 · Closed Jan 27, 1997

Status: closed (inferred from source dates) · Suspension

CONSUMER COMPLAINTS REPORT THAT BOLTS WHICH RETAIN THE AXLE PIVOT BRACKET TO THE FRAME CROSS MEMBER CAN LOOSEN OR FAIL, CAUSING THE INBOARD END OR THE AXLE TO BECOME DETACHED FROM THE VEHICLE.OWNERS ALLEGE THAT THIS COULD RESULT IN LOSS OF STEERING CONTROL, HOWEVER THE COMPLAINT DATA SHOWS ONLY ONE INCIDENT WHERE THE VEHICLE LEFT THE ROADWAY FOLLOWING AXLE SEPARATION, WITH NO DAMAGE TO THE VEHICLE.IN ADDITION TO THE 225 CONSUMER COMPLAINTS, THERE WERE 4,315 WARRANTY CLAIMS RELATED TO THE FRONT SUSPENSION AND MEMBERS, AND 22 VEHICLES WERE REPLACED FOR GOODWILL.DOCUMENTS SUBMITTED BY FORD, UNDER REQUEST FOR CONFIDENTIAL TREATMENT INDICATE THAT THE BOLTS WERE INADEQUATE FOR THE DURABILITY REQUIREMENTS OF THE VEHICLE.ALSO, BOLTS WERE FOUND TO HAVE BEEN INADEQUATELY TORQUED AT ONE OR MORE ASSEMBLY PLANTS.OTHER FACTORS, SUCH AS WAX TREATMENT OF THE FRAME, CONTRIBUTED TO THE PROBLEM.INCREASED BOLT DIAMETER AND INCREASED TORQUE APPARENTLY CORRECTED THE PROBLEM.A SERVICE BULLETIN, 96-20-13, WAS ISSUED TO ADVISE DEALERS OF THIS CORRECTIVE ACTION.IN THESE DOCUMENTS, FORD ALSO REPORTED THAT A VEHICLE, EQUIPPED FOR SIMULTANEOUS CATASTROPHIC FAILURE OF ALL PIVOT BRACKET FASTENERS, WAS EVALUATED RESULTING IN A SLIGHT VEHICLE PULL TO ONE SIDE WITH NO LOSS OF VEHICLE CONTROL.ODI HAS NOT REPLICATED FORD'S VEHICLE TESTING, HOWEVER ANALYSIS OF THE DESIGN OF THE FRONT SUSPENSION INDICATES THAT EVEN IF THE INBOARD END OF THEAXLE BECAME DISCONNECTED FROM THE FRAME, THE OUTBOARD END WOULD REMAIN FIRMLY ATTACHED TO THE LEAF SPRING WITH TWO U-BOLTS.THIS WOULD RETAIN THE WHEEL IN ITS APPROXIMATE POSITION, ALTHOUGH THE WHEEL ALIGNMENT WOULD BE GREATLY IN ERROR.THEREFORE IT IS UNLIKELY THAT CONTROL OF THE VEHICLE WOULD BE LOST.OWNERS REPROT MANY SIGNIFICANT NOISES IN THE SUSPENSION, SUCH AS CREAKING, GROANING, CLUNKING, AND SQUEAKING, PRIOR TO NOTICING ANY SEPARATION OF THE AXLE.THIS PROVIDES WARNING OF THE LOOSENING OF THE BOLTS TO THE DRIVER, AND SHOULD NOT BE IGNORED.FORD HAS STATED THAT REPAIRS WILL BE COVERED UNDER THE VEHICLE'S BUMPER WARRANTY.COMPLAINTS ABOUT WARRANTY COVERAGE BY A FORD DEALER SHOULD BE ADDRESSED TO FORD, OR TO APPROPRIATE STATE AND LOCAL AGENCIES.A SAFETY-RELATED DEFECT TREND HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.