2017 Ford Expedition

The contact owns a 2017 Ford Expedition. The contact received notification of NHTSA Campaign Number: 25V572000 (Back Over Prevention). The contact stated that while shifted into reverse(R), the rear-view camera screen displayed a black and fuzzy image. The vehicle was taken to the dealer, where it was diagnosed, and determined that the rear-view camera needed to be replaced; however, parts were not yet available. The manufacturer was not notified of the failure. The failure mileage was unknown.

The contact owns a 2017 Ford Expedition. The contact received notification of NHTSA Campaign Number: 25V572000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that the rearview camera displayed a distorted or blank image while in reverse(R). The message "Rear Camera Unavailable" message was displayed. The local dealer was contacted and confirmed that parts were not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was 110,000.

We were driving on the highway and suddenly lost all power. Vehicle downshifted so hard I thought someone had hit us. Then it was back to normal, driving fine. But now we had no speedometer and the check engine and wrench light were on. My wife said she had felt something like that before but it was minor and at a lower speed. It had never resulted in a check engine light or loss of speedometer. I told her to exit the highway. She was shaking like crazy because she thought we just got rear ended. I can see how this could cause someone to completely wreck it was so harsh. We towed it home and when we started it up at home all those error lights were off. So I drove it around the block and it drive fine. I had my friend come take a look. He scanned it and it had a P0720 code. He said his F150 had the same issue and the same code as well a few years back and it was covered. It turns out we have the same transmission in our Expedition that he has in his F150. I havent had a chance to call the dealer yet but the paper I read in the recall and extended waranty coverage states only going up to a 2013 vehicle. They say it was a leadframe issue causing this. My Expedition has the same leadframe, and the same issue. This is very much a saftey concern since it changes harshness of downshifting out of no where. It could be even worse next time locking the wheels up or blowing the engine. Knowing its the same transmission and the same leadframe, why isnt my year model under that recall. I was reading in the forums and there are hundreds of similar questions coming from people with Expeditions and F150s that are near to my year and not covered. Can you please let me know if there is something im missing. Thank you.

The contact owns a 2017 Ford Expedition. The contact stated that while driving at an undisclosed speed, the check engine warning light intermittently illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed, and determined that the occupancy sensors and the catalytic converter needed to be replaced. The vehicle was repaired; however, the failure persisted. The vehicle was taken back to the independent mechanic where it was diagnosed and determined that the occupancy sensors and the catalytic converter needed to be replaced. The vehicle was repaired; however, the failure persisted. The failure reoccurred again on two other occasions, and the vehicle was repaired; however, the failure reoccurred. The contact research and was made aware of an unknown recall; however, the VIN was not included. The manufacturer was notified of the failure and confirmed that the VIN was not included in the recall. The failure mileage was approximately 120,000.

The contact owns a 2017 Ford Expedition. The contact received notification of NHTSA Campaign Number: 25V572000 (BACK OVER PREVENTION); however, the part to do the recall repair was not yet available. The contact stated that the rearview camera displayed a distorted image or a white screen while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, which prevented the driver from safely operating the vehicle. The message "Rear Camera Unavailable" was displayed. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was unknown.

The contact owns a 2017 Ford Expedition. The contact stated that while driving approximately 15 MPH, the brake pedal was depressed, and there was an abnormal whining sound coming from the front driver's side wheel well. The contact had to depress the brake pedal sooner to allow more stopping distance while stopping the vehicle. The contact stated there was no warning light illuminated. The contact stated that the abnormal sound occurred at speeds between 15 and 20 MPH. Additionally, the contact stated that the rear-view camera was no longer functioning. The contact stated that the image from the rear-view camera was distorted. The contact had received notifications of NHTSA Campaign Number: 25V236000 (Service Brakes, Hydraulic) and 25V572000 (Back Over Prevention). The contact called a local dealer and the manufacturer and was advised that parts were not yet available. The contact stated that the manufacturer had advised that the recall for the brake master cylinder, parts were on a national back order, and that the remedy for the rear view camera was also not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 120,000.

The contact owns a 2017 Ford Expedition. The contact received notifications of NHTSA Campaign Numbers: 25V236000 (SERVICE BRAKES, HYDRAULIC) and 25V572000 (BACK OVER PREVENTION). However, the part to do the recall repair on the rearview camera was not yet available. The contact stated that the rearview camera displayed a distorted image while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, which prevented the driver from safely operating the vehicle. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 108,000.