2019 Ford Escape

My 2019 Ford Escape 2.0 Titanium has a KNOWN coolant intrusion issue where it is leaking into the engine. This began as my car shook on startup, then the check engine light would come on. Drove it a little ways, check engine turned off. Took my car into the repair shop and they looked up the stored code and it was P0301 cylinder #1 misfire detected and P0316 misfire detected on start up first 1,000 revolutions. Car seemed ok, so took it back. Happened again, 2x, check engine light on, off, then on again when I brought it back in. Same codes again. Mechanic said coolant low, removed cylinder #1 spark plug and sent camera into cylinder, found coolant leaking into cylinder. They said I need an entirely new engine, as this has been occurring a LOT with these EcoBoost vehicles. Ford had an open recall but only acknowledged a small amount of vehicles, mine not one of them, and there is currently a lawsuit against Ford because this has been happening to so many people. We are getting nowhere with Ford, they won't acknowledge the issue on the EcoBoost and now we have to come up with nearly $10k to replace an entire engine when the car isn't even worth $8k. PLEASE LOOK INTO THIS! Some people are having this issue at 50K Miles!!! This is not ok!!

The contact owns a 2019 Ford Escape. The contact stated while driving 45 MPH, the vehicle stalled. The contact was able to pull over to the side of the road. The check engine warning light was illuminated, and the contact received a power train malfunction notification through the Mobile App. The vehicle was able to restart but failed to respond while depressing the accelerator pedal. The vehicle was towed to the dealer, where it was diagnosed with transmission failure. The dealer determined that the transmission needed to be replaced. The vehicle was repaired. Additionally, the contact stated that the vehicle was difficult to start but was started after several attempts. The vehicle was taken to Loganville Ford (3460 US-78, Loganville, GA 30052); where it was diagnosed and determined that the cam seals, the crankshaft sensor and harness, and the timing components needed to be replaced. The vehicle was not repaired. The contact stated that the engine was previously replaced in 2021, and the fuel pump was replaced in 2023 due to the stalling failure. The manufacturer was notified of the failure and a case was filed. The manufacturer referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 98,117.

at 96800 upon start up there was a cloud of white smoke and a check engine light. It was taken to the local ford dealer for diagnosis. Code was P303 and P316 indicating a misfire. the car was found to have coolant intrusion in cylinder 3 and would need a long block replacement. reference used was TSB 22-2229. This type of engine failure is know to ford due to design of coolant channels between cylinders. This could have cause sudden engine failure while drive resulting in an accident and injury or engine fire due to insufficient cooling causing loss of property and/or injury.

The vehicle is suffering from an engine failure. It has a check engine light DTC PO303 with a heavy misfire. This causes to engine to lose power at times preventing proper acceleration which could lead to an accident. Ford has a technical service bulletin [TSB 22-2229 ] that describes the failure and the required repair. The problem is a design issue, but Ford is not covering any out of warranty repairs.

The contact owns a 2019 Ford Escape. The contact stated that while driving at an undisclosed speed, the vehicle shuddered abnormally. The contact believed that a fuel cleaner needed to be added to the fuel tank. The contact stated that the engine revved abnormally. While at a stoplight, the vehicle failed to drive forward and stalled. The contact stated that the axle and turbocharger had been repaired prior to the failure. There were no warning lights illuminated. The contact called the local dealer, but the vehicle was not diagnosed or repaired. The manufacturer was contacted and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 104,000.