Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 2 of 2 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
Air Bags. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
What owners actually said
2 reports
21,000 miles · Jul 23, 2018
Unknown Or Other
THIS PARTICULAR CAR (APPROX. 3800 MANUFACTURED) UTILIZES A SEAT POSITION SWITCH (POTENTIOMETER #64978300) THAT MAKES SURE THAT THE SEAT IS CLEAR OF THE FOLDING CONVERTIBLE TOP FRAME WHEN IT FOLDS INTO THE PASSENGER COMPARTMENT. THERE IS ONE SWITCH ON EACH SEAT. WHEN LOWERING MY CONVERTIBLE TOP, THE SWITCH FAILED AND THE CONVER…
Read full complaint
THIS PARTICULAR CAR (APPROX. 3800 MANUFACTURED) UTILIZES A SEAT POSITION SWITCH (POTENTIOMETER #64978300) THAT MAKES SURE THAT THE SEAT IS CLEAR OF THE FOLDING CONVERTIBLE TOP FRAME WHEN IT FOLDS INTO THE PASSENGER COMPARTMENT. THERE IS ONE SWITCH ON EACH SEAT. WHEN LOWERING MY CONVERTIBLE TOP, THE SWITCH FAILED AND THE CONVERTIBLE TOP FOLDED ONTO A SEAT MOUNTED SEAT BELT BRACKET AS THE SEAT FAILED TO CLEAR OUT OF THE WAY. THE CONVERTIBLE ROOF FRAME BEGAN TO BUCKLE UNDER HYDRAULIC PRESSURE AS IT SCISSORED THE BRACKET. FORTUNATELY I CAUGHT IT IN TIME. THIS ACTIVITY OCCURRED INCHES FROM THE LEFT SIDE OF MY HEAD AND I CAN ONLY SPECULATE THAT EITHER THE ROOF FRAME WOULD HAVE JUMPED OFF THE BELT BRACKET OR THE PIVOT PIN ON THE FRAME COULD HAVE POTENTIALLY BROKEN POSSIBLY CAUSING A HEAD INJURY. I WILL NEVER KNOW THE EXACT OUTCOME AS LETTING THIS PROCESS CONTINUE COULD DO WELL OVER $10,000 IN DAMAGE TO THE VEHICLE. IN MY OPINION, THIS PART IS OVER-ENGINEERED AND UNDER-MANUFACTURED. THEY ARE PRONE TO FAIL AND THE PREVIOUS OWNER OF MY CAR HAD TO REPLACE THE PASSENGER SIDE SWITCH AT ELEVEN YEARS. UNFORTUNATELY, THIS PART IS NO LONGER AVAILABLE ANYWHERE ON THIS PLANET AND IF YOU CONSULT THE INTERNET, YOU WILL DISCOVER A COMMUNITY OF OWNERS WHO ARE ATTEMPTING "MAKE-SHIFT" REPAIRS OR DEFEATING THE SYSTEM ENTIRELY. THIS IS FAR FROM SAFE. I INITIATED CONTACT WITH FERRARI ON 9/1/2017 AND MY LAST CONTACT WAS 11/7/17. I DID NOT ASK THEM TO ACCEPT FINANCIAL RESPONSIBILITY FOR REPAIRING THIS HAZARD, I MERELY SUGGESTED THEY FIND A WAY TO SOURCE THE PART. I BELIEVE A REPAIR COULD BE AS SIMPLE AS 3D PRINTING AN INTERNAL PART. THEIR INITIAL INTEREST HAS TURNED TO NINE MONTHS OF SILENCE. NOW I TURN TO YOU TO HOLD FERRARI RESPONSIBLE. AS IT WAS THEIR ENGINEERS THAT DECIDED TO INCORPORATE A SEAT MEMORY SWITCH INTO A SAFETY SYSTEM, LET THEM FIND A SOLUTION. A HAZARD EXISTS.
NHTSA ODI #11113132
41,025 miles · Feb 22, 2010
Air Bags
AIRBAG ECU FAILURE IN 1995 FERRARI F355GTS. AIRBAG ECU FAILED DURING A NORMAL START CYCLE. CONVERSATIONS WITH OTHER F355 AND OTHER MODEL FERRARI OWNERS CONFIRM THIS IS COMMON FAILURE. SUSPICION IS THAT THE AIRBAG ECU FAILS WHEN SYSTEM VOLTAGE DROPS DURING CRANKING. AIRBAG ECU SHOULD BE ROBUST TO SURVIVE NORMAL USE AND OPER…
Read full complaint
AIRBAG ECU FAILURE IN 1995 FERRARI F355GTS. AIRBAG ECU FAILED DURING A NORMAL START CYCLE. CONVERSATIONS WITH OTHER F355 AND OTHER MODEL FERRARI OWNERS CONFIRM THIS IS COMMON FAILURE. SUSPICION IS THAT THE AIRBAG ECU FAILS WHEN SYSTEM VOLTAGE DROPS DURING CRANKING. AIRBAG ECU SHOULD BE ROBUST TO SURVIVE NORMAL USE AND OPERATION. *TR
FERRARI IS RECALLING CERTAIN MODEL YEAR 1995 THROUGH 1999 FERRARI 355 AND 355 F1 VEHICLES. INDEPENDENT AUTOMOBILE REPAIR FACILITIES MAY HAVE IMPROPERLY INSTALLED CERTAIN SCREW CLAMPS THAT ARE LOCATED IN CLOSE PROXIMITY TO THE FUEL LINES AND THAT FASTEN THE WATER SLEEVE TO THE THERMOSTAT CONNECTION. THE IMPROPER INSTALLATION OF THESE SCREW CLAMPS MAY DAMAGE THE FUEL SUPPLY PIPES.
Consequence & remedy
Consequence: FLUID COULD LEAK INTO THE ENGINE COMPARTMENT, CAUSING SMOKE AND, IN SOME CIRCUMSTANCES, A FIRE, RENDERING THE VEHICLE INOPERABLE AND POSSIBLY RESULTING IN A CRASH.
Remedy: DEALERS WILL INSTALL A NEW FUEL DIVIDER BLOCK, WHICH WILL SERVE TO PROVIDE A GREATER DISTANCE BETWEEN THESE SCREW CLAMPS AND THE FUEL LINES. THIS WILL ELIMINATE THE POSSIBILITY OF ANY DAMAGE TO THE FUEL SUPPLY PIPES WHICH COULD CAUSE FLUID LEAKAGE. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 16, 2009. OWNERS MAY CONTACT FERRARI AT 1-201-816-2600.
VEHICLE DESCRIPTION: PASSENGER VEHICLES FITTED WITH DUAL FUEL PUMPS. THE FUEL INJECTION LINE FITTING CAN FRACTURE IF THE ALUMINUM NUT ATTACHING THE LINES IS TIGHTENED EXCESSIVELY.
Consequence & remedy
Consequence: IF THE FUEL LINE FRACTURES, FUEL LEAKAGE CAN OCCUR. IF AN IGNITION SOURCE IS PRESENT, A FIRE COULD OCCUR.
Remedy: DEALERS WILL REMOVE THE FUEL INJECTION LINES THAT HAVE ALUMINUM NUTS AND REPLACE WITH NEW LINES CONTAINING STEEL ATTACHING NUTS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES FITTED WITH SINGLE FUEL PUMPS. THE FUEL INJECTION LINE FITTING CAN FRACTURE IF THE ALUMINUM NUT ATTACHING THE LINES IS TIGHTENED EXCESSIVELY.
Consequence & remedy
Consequence: IF THE FUEL LINE FRACTURES, FUEL LEAKAGE CAN OCCUR. IF AN IGNITION SOURCE IS PRESENT, A FIRE COULD OCCUR.
Remedy: DEALERS WILL REMOVE THE FUEL INJECTION LINES THAT HAVE ALUMINUM NUTS AND REPLACE WITH NEW LINES CONTAINING STEEL ATTACHING NUTS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH DUAL FUEL PUMPS. THE FUEL SUPPLY LINE FITTING CAN FRACTURE IF THE ALUMINUM NUT ATTTACHING THE LINES IS TIGHTENED EXCESSIVELY. HAIRLINE CRACKS ON THE FUEL INJECTOR RAIL ALSO EXISTS.
Consequence & remedy
Consequence: THIS CONDITION CAN RESULT IN LEAKAGE OF FUEL FROM THE FRACTURED LINE. IF AN IGNITION SOURCE WAS PRESENT, A FIRE COULD OCCUR.
Remedy: DEALERS WILL REMOVE THE FUEL FUEL INJECTION LINES AND TWO RAILS THAT US ALUMINUM NUTS AND REPLACE THE LINES AND RAILS WITH STEEL NUTS.
THE PASSENGER SIDE SEAT BELT MECHANISM WHICH IS FITTED WITH THE CHILD SAFETY SEAT LOCKING MECHANISM WAS FITTED ON THE DRIVER SIDE AND THE DRIVER'S SIDE SEAT BELT MECHANISM WITHOUT THE LOCKING MECHANISM FITTED ON THE PASSENGER SIDE.
Consequence & remedy
Consequence: THE SEAT BELT MECHANISM (WITHOUT THE LOCKING DEVICE) MAY NOT LOCK FAST ENOUGH AND COULD ALLOW EXCESSIVE MOVEMENT OF THE CHILD SAFETY SEAT IN THE EVENT OF AN ACCIDENT.
Remedy: DEALERS WILL INSPECT THE SEAT BELT MECHANISMS TO DETERMINE WHETHER THEY HAVE BEEN INSTALLED ON THE PROPER SIDE OF THE VEHICLE AND, IF NECESSARY, DISMOUNT AND REMOUNT THE MECHANISMS ON THE CORRECT SIDE.
Illustration