2017 Chevrolet Volt

I am reporting a series of safety concerns regarding my 2017 Chevy Volt, which have persisted despite multiple attempts to address them with the dealership. These issues pose significant risks to my safety and that of others on the road. On January 18th, 2024, I brought my vehicle to the dealer after experiencing reduced propulsion power while driving on the highway, coupled with the illumination of the check engine light. The mechanic performed a quick inspection and used a GM scan tool to diagnose the issue, revealing the code P1E00 for the Hybrid Powertrain Control Module 2, which was cleared without a thorough investigation. I was advised to return if the issue reoccurred. Despite the reset, the problem persisted, and on February 9th, 2024, I scheduled another appointment due to my Chevy Volt's High Voltage battery charging only to 65% capacity despite indicating a full charge. Subsequently, on February 11th, 2024, the check engine light illuminated again, and on February 12th, 2024, November 25th, 2025, January 11th, 2026, and February 12, 2026 while driving to work, both times I experienced a loss of propulsion power on the highway, placing my safety at risk and lost all power in a traveling lane of traffic. These ongoing issues with propulsion power and the high-voltage battery charging system are not only inconvenient but also potentially dangerous. Despite multiple visits to the dealership and attempts to diagnose and resolve the problem, it persists, indicating a systemic issue that requires immediate attention. The reduced propulsion power while driving on the highway, coupled with the illumination, I urge the National Highway Traffic Safety Administration (NHTSA) to investigate this matter thoroughly to ensure the safety of Chevy Volt drivers and passengers. It is imperative that General Motors addresses these issues promptly and implements appropriate measures to prevent further incidents.

My 2017 Chevy Volt stalled, wont charge, safely concerns. safety-related special coverage is being denied by local Chevy dealer. Check Engine light codes U2603-06, U2623, well known issue in chevy volt community, that points to Chevy faulty BECM. Chevy replace these to some selected 2016-2018 vehicles, but they wont cover mine, while I have same exact issue. Please help to push on Chevy to cover all 2016-2018 Chevy Volt by recalls repairs with no cost to owner. thanks

I am reporting a series of safety concerns regarding my 2017 Chevy Volt, which have persisted despite multiple attempts to address them with the dealership. These issues pose significant risks to my safety and that of others on the road. On January 18th, 2024, I brought my vehicle to the dealer after experiencing reduced propulsion power while driving on the highway, coupled with the illumination of the check engine light. The mechanic performed a quick inspection and used a GM scan tool to diagnose the issue, revealing the code P1E00 for the Hybrid Powertrain Control Module 2, which was cleared without a thorough investigation. I was advised to return if the issue reoccurred. Despite the reset, the problem persisted, and on February 9th, 2024, I scheduled another appointment due to my Chevy Volt's High Voltage battery charging only to 65% capacity despite indicating a full charge. Subsequently, on February 11th, 2024, the check engine light illuminated again, and on February 12th, 2024, November 25th, 2025, and January 11th, 2026, while driving to work, both times I experienced a loss of propulsion power on the highway, placing my safety at risk and lost all power in a traveling lane of traffic. These ongoing issues with propulsion power and the high-voltage battery charging system are not only inconvenient but also potentially dangerous. Despite multiple visits to the dealership and attempts to diagnose and resolve the problem, it persists, indicating a systemic issue that requires immediate attention. The reduced propulsion power while driving on the highway, coupled with the illumination I urge the National Highway Traffic Safety Administration (NHTSA) to investigate this matter thoroughly to ensure the safety of Chevy Volt drivers and passengers. It is imperative that General Motors addresses these issues promptly and implements appropriate measures to prevent further incidents.

Following a day trip involving sub-freezing temperatures and full depletion of the traction battery, the vehicle was plugged in at home and appeared to be charging. The following morning, I enable the preheat via the remote before leaving the house for work, and notice the CEL/MIL before starting the car. Car was cold, charging indicator was flashing green as if it was accepting charge. I went to investigate and was met with the following list of codes: P1E00, U2603, U2604-U2606, U2617-U2624, P1FD2, P1FD3, P3042, C326C, P0096. Car turns on but seems to only be accessories; no power steering. Seems like the state of charge indication kept transitioning from empty to full. I unplugged the car to see if it could still drive, but no luck. getting "Shift to Park" when I put it in drive. Switching to HOLD does not engage the engine. After plugging it in again, the car no longer receives charge and simply holds the orange charge indicator light. In an attempt to get the car into limp mode, I tried clearing the codes, but no luck. After reading the codes again in the afternoon, the following codes posted: P1E00, U2622, U2623, P1FD4, P0AFA. These codes and behavior are consistent with the following NTSB service documents, which call for the replacement of the BECM: Special Coverage N232432680 Technical Service Bulletin 18-NA-261 However, the vehicle in question does not appear to be one of the 19,000 vehicles covered under the special coverage, per GM’s warranty look-up. The vehicle has not yet been serviced for the above events, but it is assumed the BECM is failing, which is available for inspection. My safety was not put at risk this time, but it is possible for the BECM to fail in an unsafe manner. Additionally, the associated repairs are costly since the BECM is not easily accessible, requiring lifting the car and removing the entire traction battery.

The BECM (Battery Energy Control Module) failed. The vehicle illuminated the MIL and the driver display to show a "Reduced power". When restarted, the display showed "shift to park", which I did several times. After a couple of restarts it displayed the "Reduced power" message, but would not go into drive. THE MIL was illuminated the entire time. Through numerous key cycles I got the VIN operable and took it to the dealer for repair. The BECM part is at the dealer or on its way back to GM as a core return. While this occurred while I was leaving my garage, it could have occurred in traffic, which would put me or others at risk. The problem was investigated by my local dealer (Currie Chevrolet in Forest Park, IL) and it was determined to be both a bad Battery Energy Control Module (BECM) and a bad shifter assembly. The shifter had been replaced (or repaired?) for an earlier Shift to Park failure per TSB 23-NA-119. The dealer kept the BECM as a core. I have pictures of the core. The dealer or GM should have that core. The above described warning lamps and messages and systems first appeared at the time of the event that lead me to take it other dealer ASAP. Note the condition and model year is described in GM special coverage letter "N232432680 Battery Energy Control Module Malfunction". NHTSA investigation PE23022 lead to this coverage letter. Per GM, while my vehicle experienced the conditions and is in the model year coverage of the letter, its VIN is not covered. I think NHTSA should re-open the investigation and consider a recall. There could be other VINS susceptible this failure condition. There could be operators of those VINs who cannot afford the expense (~$3000 or more) or downtime of the repair, and will keep operating the vehicle, putting people at risk again. If a recall is not supportable, I'd request that the VIN list be expanded to cover all possible defective BECMs.

On 10/14, I was driving the car to my job, when the car suddenly switched from its electric battery power to its internal combustion engine. The vehicle's information screen only showed that the battery was unavailable. I was able to operate the car on only the internal combustion engine to arrive at work. However, when I went to leave several hours later, the car would not start. The car was towed to a dealership and apparently repaired after about a week. However, the repair, a software reset, did not fixt the underlying issues, and on 10/27, after having the car for five days, the car again failed on my way to work, displaying a "Shift to Park" message and not starting. I towed the car to the same dealership, and they had it until 11/04. I recovered my car and drove it again to work that same day, but the car failed again due to the dealership not correctly diagnosing the issue, which appears to be the BECM, a failure related to bulletin N232432680. Due to this issue, I was left stranded on a busy highway for several hours on multiple occasions, and have not have a working vehicle since 10/14, meaning I have had to call off of work on multiple days, losing non-trivial amounts of income and undue economic hardship, due to this issue. Neither the dealership nor General Motors have offered any kind of help or support, and have generally attempted to avoid responding to my repeated phonecalls. Prior to this issue, there were no warnings or symptoms that I observed.

The engine light starts blinking and telling me propulsion power reduced, and then I cannot use the cruise control after that turns on, and it starts losing power, driving on I 70 after work all of a sudden it turned on and wet from going 76 miles an hour to 52 on highway I 70 where the speed limit was 75. This problem was a recall problem which was fixed and now is happening again on the same part and having the same problems.

The contact owns a 2017 Chevrolet Volt D2. The contact stated that while attempting to turn the vehicle on the vehicle did not start. The contact stated that vehicle restarted after an hour. The contact stated the during the second occasion the vehicle did not restart. The vehicle was towed to a dealer where it was diagnosed that the Battery energy control module needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure. The failure mileage was approximately 75,000.

The high-voltage heater control module (also known as the PTC coolant heater / K10 heater module) has failed. This component controls cabin heat and windshield defrost when the vehicle operates in electric mode. The authorized Chevrolet dealer diagnosed the issue, confirmed the failure, and attempted to order the correct GM part. GM informed the dealer that the part is no longer manufactured or available through GM channels. As a result, there is currently no GM-approved repair path. This failure prevents the vehicle from providing windshield defrost while operating in EV mode, which is required for safe winter visibility. I live in New Hampshire, where winter temperatures routinely require functioning cabin heat and defrost for safe operation and compliance with state visibility laws. Because this is a high-voltage thermal management component, there is no safe aftermarket repair option. The inability to obtain an OEM replacement part for a safety-related system prevents the vehicle from operating safely in intended EV mode.