IllustrationGAS TANK IS 10 INCHES FROM REAR BUMPER.CONTACTED MANUFACTURER. *AK
1980 Chevrolet Malibu
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Malibu years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 5 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Fuel System, Gasoline. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Tires. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports1 fire reports0 injury reports
What owners actually said
5 reportsDESIGN MATERIAL OF THE WINDSHIELD WIPER ASSEMBLY FAILED (APOXY BONDING).
U.S. ROYAL, STEEL BELTED RADIAL 195R75-14 TIRE SIDEWALL FAILED CAUSING BLOW OUT.
FUEL PROPANE TANK HAD HOLE.
WHILE VEHICLE WAS PARKED IT CAUGHT ON FIRE UNDER THE HOOD. OWNER HAD DRIVEN VEHCLE FOR ABOUT (20) MINUTES BEFORE FIRE HAPPENED. FIRE DEPARTMENT BELIEVED FIRE WAS ELECTRICAL OR CAUSED BY OVERHEATING. THE VEHICLE HAS BEEN TOTALLED. *AK
Official recalls
585V048000 · Service Brakes, Hydraulic:foundation Components:drum:wheel Cylinders
Apr 29, 1985
EXCESSIVE ENLARGEMENT OF THE WHEEL CYLINDER PILOT HOLE IN THE REAR BRAKE BACKING PLATE COULD ALLOW THE WHEEL CYLINDER TO ROTATE AND CAUSE LOSS OF BRAKE FLUID. CONSEQUENCE OF DEFECT: A LOSS OF BRAKE FLUID LEADS TO LOSS OF REAR BRAKE ACTION, CREATING THE POTENTIAL FOR AN ACCIDENT. FRONT BRAKES WOULD REMAIN OPERATIONAL.
Consequence & remedy
Consequence: Not supplied
Remedy: ADD A PART TO PREVENT WHEEL CYLINDER FROM ROTATING.
84V149000 · Power Train:axle Assembly:axle Shaft
Nov 24, 1984
REAR AXLE ASSEMBLY MAY HAVE AXLES THAT WERE IMPROPERLY MANUFACTURED. THIS CONDITION MAY RESULT IN SEPARATION OF THE AXLE SHAFT AND WHEEL ASSEMBLY FROM THE VEHICLE.
Consequence & remedy
Consequence: Not supplied
Remedy: THE DEALER WILL INSPECT THE REAR AXLE TO DETERMINE WHETHER IT WAS MANUFACTURED AT THE BUFFALO PLANT. IF SO, THEY WILL MAKE AXLE MEASUREMENTS AND IF NECESSARY REPLACE OR MODIFY AFFECTED AXLE COMPONENTS WITHOUT CHARGE.
83V077000 · Vehicle Speed Control:cables
Aug 19, 1983
ACCELERATOR PUMP LEVER RETAINING PIN MAY LOOSEN AFTER REPEATED HEAVY ACCELERATOR PEDAL APPLICATIONS. THIS COULD CAUSE THE THROTTLE TO BECOME STUCK IN THE OPEN POSITION.
Consequence & remedy
Consequence: Not supplied
Remedy: DEALER WILL INSTALL A SPECIAL COTTER PIN, TO RETAIN THE ACCELERATOR PUMP PIN, AND A SPRING CLIP THRUST WASHER ON THE ACCELERATOR PUMP LINK.
81V025000 · Suspension:rear
Feb 25, 1981
THE BOLTS THAT ATTACH THE LOWER REAR CONTROL ARM TO THE FRAME MAY FRACTURE. THE REAR CONTROL ARM SUPPORTS AND POSITIONS THE REAR AXLE. FRACTURE OF THE BOLTS WOULD ALLOW THE CONTROL ARM TO DROP FREE.
Consequence & remedy
Consequence: Not supplied
Remedy: BOTH REAR CONTROL ARM ATTACHMENT BOLTS WILL BE REPLACED WITHOUT CHARGE.
81V022000 · Visibility:glass, Side/rear
Feb 11, 1981
THE ELECTRO-CLEAR REAR WINDOW DEFOGGERS CONTAIN A DEFECT WHICH CAUSES THE GLASS TO SHATTER WITHOUT IMPACT DURING OR SOME TIME AFTER USE OF THE DEFOGGER. VERTICAL ELECTRICAL STRIPS MAY DETERIORATE AND CAUSE HOT SPOTS THAT CAN RESULT IN BREAKAGE OF THE REAR GLASS.
Consequence & remedy
Consequence: Not supplied
Remedy: VEHICLES WILL BE INSPECTED FOR PRESENCE OF A PARTICULAR WEATHERSTRIP. IF PRESENT, A LAYER OF A SPECIAL CONDUCTIVE EPOXY WILL BE ADDED TO THE VERTICAL BAR ON THE REAR WINDOW GLASS. THIS EPOXY IS A NEW CONDUCTIVE MATERIAL WHICH WILL NOT REACT WITH THE WEATHERSTRIP.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1EA86006 · Brake Backing Plate
Opened Nov 27, 1985 · Closed Nov 28, 1988
Status: closed (inferred from source dates) · Service Brakes, Hydraulic
SUMMARY:GM IS CONDUCTING A VOLUNTARY RECALL CAMPAIGN (85V-048)INVOLVING 2,136,826 VEHICLES. THE RECALL IS LIMITED TO VEHICLES BUILT ATCERTAIN ASSEMBLY PLANTS WHICH, ACCORDING TO GM, OVERTORQUED THE BRAKEPIPE NUT,THEREBY OVERSTRESSING THE WHEEL CYLINDER SUPPORT AREA OF THEBACKING PLATE.ANALYSIS:FRONT BRAKES PROVIDE SUFFICIENT BRAKING FOR PASSENGER CARSIN MOST NON-EMERGENCY SITUATIONS. ALL AFFECTED TRUCKS ARE INCLUDED INTHE CURRENT RECALL.IN MOST CASES THE PROBLEM IS DISCOVERED DURING BRAKEMAINTENANCE.THE RECALL APPEARS TO COVER THOSE GROUPS OF CARS WITH THEHIGHEST FAILURE RATES.STATUS:ANALYZING GM IR RESPONSE AND NEW COMPLAINT DATA. DRAFT CLOSINGREPORT BY 5/15/88.===