DUE TO A MANUFACTURING PROBLEM WITH THE FUEL TANK FILLER PIPE, THE FUEL CAP MAY IMPROPERLY SEAL THE END OF THE FILLER PIPE. THIS FAILS TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY." IN THE EVENT OF A COLLISION, AN IMPROPERLY SEALED FILLER PIPE COULD ALLOW FUEL SPILLAGE.
Consequence & remedy
Consequence: Not supplied
Remedy: THE DEALER WILL INSPECT AND REPLACE FUEL CAPS ON ALL AFFECTED VEHICLES WITHOUT CHARGE.
PLASTIC PLUG LOCATED ON TOP OF THE FRONT AIR CONDITIONER WAS NOT REMOVED DURING ASSEMBLY. THIS DEFECT DISRUPTS NORMAL OPERATION OF EVAPORATOR BLOWER HOUSING.
Consequence & remedy
Consequence: Not supplied
Remedy: REAR A/C SYSTEM BLOWER WILL BE INSPECTED FOR DAMAGE SUCH AS MELTING OR BURNING. IF NO DAMAGE IS DETECTED, THE RESISTOR WILL BE REPLACED AND ANY REMAINING PIECES WILL BE REMOVED. IF DAMAGE IS DETECTED, THE RESISTOR AND THE A/C EVAPORATOR INLET CASE WILL BE REPLACED.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2
EA88007 · Lower Control Arm
Opened Nov 6, 1987 · Closed Oct 24, 1988
Status: closed (inferred from source dates) · Suspension
SUMMARY OF INFORMATION FROM MANUFACTURER:MANUFACTURER IS IN RECEIPT OFONE COMPLAINT AND FIVE FIELD REPORTS.PRODUCT REPORT ANALYSIS STATES THELOWER CONTROL ARM FROM WAGGONER CORPORATION APPEARS TO HAVE A SMALL RADIUSAT THE TRANSITION OF THE SIDE WALL TO THE BALL STUD NOSE.CURRENT STAMPINGSOURCE, S.K.D., ALSO HAS A SMALL RADIUS IN THE SAME AREA.S.K.D. HASCHANGED THE TRIM TO INCREASE THE RADIUS TO 1 INCH AND PROVIDE ADDITIONALSTRENGTH IN THE BALL STUD AREA.ANALYSIS:FAILURE DATA INDICATES THE LEFT CONTROL ARM AND DIESEL ENGINEAPPLICATION ARE OVER REPRESENTED.ALL KNOWN FAILURES HAVE OCCURRED AT LOWSPEEDS, OR HAVE BEEN LOCATED AS A RESULT OF AN INCREASE IN THE FREQUENCY OFMAINTENANCE INSPECTIONS.BALL JOINT SEPARATION COULD RESULT IN COLLAPSE OFFRONT WHEEL SUSPENSION AND LOSS OF VEHICLE CONTROL.ACTION: IR TO GM SENT 11/19/87 CONTACT FLEET OWNERS.===
Additional source detail variants (2)
Suspension
SUMMARY OF INFORMATION FROM MANUFACTURER:MANUFACTURER IS IN RECEIPT OFONE COMPLAINT AND FIVE FIELD REPORTS.PRODUCT REPORT ANALYSIS STATES THELOWER CONTROL ARM FROM WAGGONER CORPORATION APPEARS TO HAVE A SMALL RADIUSAT THE TRANSITION OF THE SIDE WALL TO THE BALL STUD NOSE.CURRENT STAMPINGSOURCE, S.K.D., ALSO HAS A SMALL RADIUS IN THE SAME AREA.S.K.D. HASCHANGED THE TRIM TO INCREASE THE RADIUS TO 1 INCH AND PROVIDE ADDITIONALSTRENGTH IN THE BALL STUD AREA.ANALYSIS:FAILURE DATA INDICATES THE LEFT CONTROL ARM AND DIESEL ENGINEAPPLICATION ARE OVER REPRESENTED.ALL KNOWN FAILURES HAVE OCCURRED AT LOWSPEEDS, OR HAVE BEEN LOCATED AS A RESULT OF AN INCREASE IN THE FREQUENCY OFMAINTENANCE INSPECTIONS.BALL JOINT SEPARATION COULD RESULT IN COLLAPSE OFFRONT WHEEL SUSPENSION AND LOSS OF VEHICLE CONTROL.ACTION: IR TO GM SENT 11/19/87 CONTACT FLEET OWNERS.===
Suspension
SUMMARY OF INFORMATION FROM MANUFACTURER:MANUFACTURER IS IN RECEIPT OFONE COMPLAINT AND FIVE FIELD REPORTS.PRODUCT REPORT ANALYSIS STATES THELOWER CONTROL ARM FROM WAGGONER CORPORATION APPEARS TO HAVE A SMALL RADIUSAT THE TRANSITION OF THE SIDE WALL TO THE BALL STUD NOSE.CURRENT STAMPINGSOURCE, S.K.D., ALSO HAS A SMALL RADIUS IN THE SAME AREA.S.K.D. HASCHANGED THE TRIM TO INCREASE THE RADIUS TO 1 INCH AND PROVIDE ADDITIONALSTRENGTH IN THE BALL STUD AREA.ANALYSIS:FAILURE DATA INDICATES THE LEFT CONTROL ARM AND DIESEL ENGINEAPPLICATION ARE OVER REPRESENTED.ALL KNOWN FAILURES HAVE OCCURRED AT LOWSPEEDS, OR HAVE BEEN LOCATED AS A RESULT OF AN INCREASE IN THE FREQUENCY OFMAINTENANCE INSPECTIONS.BALL JOINT SEPARATION COULD RESULT IN COLLAPSE OFFRONT WHEEL SUSPENSION AND LOSS OF VEHICLE CONTROL.ACTION: IR TO GM SENT 11/19/87 CONTACT FLEET OWNERS.===
PE87056 · Lower Control Arm Failure
Opened Sep 8, 1987 · Closed Nov 6, 1987
Status: closed (inferred from source dates) · Suspension
SUMMARY OF INFORMATION FROM MANUFACTURER:MANUFACTURER IS IN RECEIPT OFONE COMPLAINT AND FIVE FIELD REPORTS.PRODUCT REPORT ANALYSIS STATES THELOWER CONTROL ARM FROM WAGGONER CORPORATION APPEARS TO HAVE A SMALL RADIUSAT THE TRANSITION OF THE SIDE WALL TO THE BALL STUD NOSE.CURRENT STAMPINGSOURCE, S.K.D., ALSO HAS A SMALL RADIUS IN THE SAME AREA.S.K.D. HASCHANGED THE TRIM TO INCREASE THE RADIUS TO 1 INCH AND PROVIDE ADDITIONALSTRENGTH IN THE BALL STUD AREA.ANALYSIS:DATA INDICATES 38 OF 40 FAILURES INVOLVE THE LEFT CONTROL ARM,39 OF THE VEHICLES ARE POWERED BY THE DIESEL ENGINE.ALL FAILURES HAVEOCCURRED AT LOW SPEEDS, OR HAVE BEEN LOCATED DURING INCREASED FREQUENCYMAINTENANCE INSPECTIONS.SEPARATION OF THE BALL JOINT FROM THE CONTROLARM COULD CAUSE ONE SIDE OF THE FRONT WHEEL SUSPENSION TO COLLAPSE,POSSIBLY RESULTING IN LOSS OF VEHICLE CONTROL.PROPOSED ACTION:UPGRADE THIS PE TO AN EA.===
1984 Chevrolet G30 Problems, Complaints & Recalls | Skip That Year
Illustration