Both rear calipers have become frozen or stuck, causing the brakes to seize and not work correctly. This happened around 53,000 miles. There was a burning rubber smell as well as the tire/brake temp was 5 times the normal. This created a severe driving hazard.
2021 Chevrolet Colorado
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 2021 Chevrolet Colorado do not stand out strongly from the model-year median of 84.
About this comparison →How this year compares
Owner complaints by model year
Compare all Colorado years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 16 of 75 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Engine. Review the 18 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes. Review the 17 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 11 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
What owners actually said
75 reportsBrake boost vacuum pump failure. While approaching a traffic light that was red, I applied the brakes. The pedal was very hard to press and required me using both feet to bring the vehicle to a stop. Stopping distance was much longer than normal. I removed the vacuum pump and found it had seized and broke apart.
My 2021 Chevy Colorado experienced a distinct bucking and shuddering sensation under slow acceleration at lower RPMs, specifically when shifting between 2nd and 3rd gear. There were no dashboard warning lights or malfunction codes prior to the issue. The defect was officially reproduced, inspected, and confirmed by a GM technic…
Read full complaint
My 2021 Chevy Colorado experienced a distinct bucking and shuddering sensation under slow acceleration at lower RPMs, specifically when shifting between 2nd and 3rd gear. There were no dashboard warning lights or malfunction codes prior to the issue. The defect was officially reproduced, inspected, and confirmed by a GM technician at a certified Chevrolet dealership on October 28, 2025, at 46,437 miles. Diagnostic scanning using GM’s GDS software explicitly confirmed that the Torque Converter Clutch (TCC) slip speed was exceeding 100 RPM when the low-speed shudder occurred. The dealership determined the component was failing and replaced the entire torque converter assembly under warranty. This documentation is submitted to prove that the TCC defect remains uncorrected in post-2019 vehicles. My sister’s identical 2021 Colorado is now experiencing the same defect at 59,000 miles, but her symptoms have progressed significantly worse to include a severe high-speed drivetrain shudder alongside the low-speed acceleration bucking.
Iba sobre el freeway a 60 millas y de la nada el freno se puso duro no respondían me pasé a los carril de la orilla y fui metiendo freno de mano poco a poco bendito Dios me puse a salvo! La agencia me dijo que fue el booster ahora tienen que verificar que no halla fragmentos de metal en el motor!
The contact owns a 2021 Chevrolet Colorado. The contact stated that while driving approximately 75 MPH, the engine revved without the accelerator pedal being depressed. The contact stated that while turning onto an exit ramp, the brake pedal was depressed to slow the vehicle; however, there was resistance to the brake pedal, and…
Read full complaint
The contact owns a 2021 Chevrolet Colorado. The contact stated that while driving approximately 75 MPH, the engine revved without the accelerator pedal being depressed. The contact stated that while turning onto an exit ramp, the brake pedal was depressed to slow the vehicle; however, there was resistance to the brake pedal, and an excessive amount of pressure was needed to depress brake pedal to stop the vehicle. There were no warning lights illuminated. The vehicle was not taken to be diagnosed or repaired. The dealer was informed of the failure. The dealer informed the contact that failure might cause the complete engine failure. The manufacturer was not made aware of the failure. The failure mileage was approximately 106,000.
We bought this truck from a dealer (used) and before delivery the driver seat belt recall was repaired as it was still open. Now, months later, the airbag light is on with a warning and it appears that the airbags are disabled. This started as an intermittent issue and now remains constant. Not only does the warning chime when t…
Read full complaint
We bought this truck from a dealer (used) and before delivery the driver seat belt recall was repaired as it was still open. Now, months later, the airbag light is on with a warning and it appears that the airbags are disabled. This started as an intermittent issue and now remains constant. Not only does the warning chime when the truck is started, it will chime at random while driving which is a distraction and a significant safety concern for our young adult driver. Our local Chevy dealer will not assess the issue for less than $300. Our mechanic told us that replacing the airbag is a minimum of $800 depending on the extent of the work. Given the prior airbag recalls impacting Chevy/GMC, I thought this is important to report in case others are seeing airbag warning issues in a more widespread issue. As airbags are such a large part of automotive safety these days, I truly believe that these issues should be checked out at no cost to the consumer. Airbags should not be something that breaks down with normal wear and tear and should be a longstanding safety feature of the vehicle. Malfunction is likely a defect, not a result of normal use.
Brake vacum pump experienced a catastrophic failure. I was unable to step on the break because the break pedal was hard. I ran thru a red light. I was told the brake vacume pump shattered & pieces of metal went into my engine
While driving downhill nearing a stop sign my wife went to apply the brakes to stop and all she had was an extremely hard brake pedal. She panicked that she “no brakes.” She was only going about 20 MPH, and was able to stop the vehicle but it took an extraordinary amount of effort to do so. Had she had to make a sudden stop fo…
Read full complaint
While driving downhill nearing a stop sign my wife went to apply the brakes to stop and all she had was an extremely hard brake pedal. She panicked that she “no brakes.” She was only going about 20 MPH, and was able to stop the vehicle but it took an extraordinary amount of effort to do so. Had she had to make a sudden stop for a child, another person, or something else, she would not have been able to stop without negative consequences including possible death. There were no warning signs, vehicle pulled out of driveway and brakes were normal. Less than 10 seconds later no more power brakes. The vehicle had the vacuum pump seize which eliminated the power boost and the pump is operated by the exhaust camshaft which also got damaged and needs replaced. Chevy dealership estimated the repair at $2,600. Upon researching the vacuum pump, this is a common failure on multiple GM vehicles resulting in sudden brake loss. The vacuum pump should have been designed with a shear pin, so that if it fails the camshaft does not get damaged. Had the vacuum pump been properly designed and it was the only failing part, the repair cost would be $500 versus $2,600. Also, there should have been a temporary backup system so you would not lose power boost.
While driving on the parkway, the engine revved, and then the brakes became hard as a brick. The truck was unable to be stopped. There were no warning lamps or indications there was a problem, it happened suddenly and immediately. Other drivers' and my own safety was at risk because I could not stop the truck. Here is the diagno…
Read full complaint
While driving on the parkway, the engine revved, and then the brakes became hard as a brick. The truck was unable to be stopped. There were no warning lamps or indications there was a problem, it happened suddenly and immediately. Other drivers' and my own safety was at risk because I could not stop the truck. Here is the diagnosis from the GM service center where it was towed to: "After the removal of the valve cover, the tech found the pump in pieces, and the end of the exhaust camshaft was damaged, as presented in the photos. The quote attached depicts all that is being replaced with this repair." The is a know and acknowledged GM defect that has affected well over 3 million vehicles to date. There was a recall issued for some models, but not the Chevrolet Colorado. There are many reports online of other Colorado owners having the exact brake vacuum pump failure, resulting in damage to the camshaft.There is also a class action lawsuit filed in Michigan in early 2026, involving the same brake vacuum pump failure, for some of the models that were not included in the recall. This is an extremely dangerous mechanical failure that GM is aware of.
The contact owns a 2021 Chevrolet Colorado. The contact stated that while driving at 30 MPH, the check engine warning light illuminated. A dealer was contacted. The vehicle was taken to the dealer, where it was diagnosed, and it was determined that the camshaft actuator valve needed to be replaced. The vehicle was not repaired. …
Read full complaint
The contact owns a 2021 Chevrolet Colorado. The contact stated that while driving at 30 MPH, the check engine warning light illuminated. A dealer was contacted. The vehicle was taken to the dealer, where it was diagnosed, and it was determined that the camshaft actuator valve needed to be replaced. The vehicle was not repaired. The contact associated the failure with Special Coverage Program: N232430470 (Camshaft Position Actuator Valve Solenoid - Bank 2 (Left Side) Exhaust ); however, the VIN was not included in the program. The manufacturer was notified of the failure and informed the contact to call the NHTSA Hotline for assistance. The failure mileage was 43,500.
Official recalls
120V811000 · Seat Belts; Seat Belts:critical Fasteners
Dec 23, 2020
General Motors, LLC (GM) is recalling certain 2020 Chevrolet Bolt EV and 2021 GMC Canyon and Sierra 1500, 2500 and 3500, Yukon, Yukon XL, Cadillac Escalade and Escalade ESV and Chevrolet Blazer, Camaro, Colorado, Equinox, Silverado 1500, 2500 and 3500, Suburban and Tahoe vehicles. Incorrect bolts may have been used at one or more fastening locations to secure the seat belts to the vehicle. If an incorrect bolt was used, the seat belt may not be properly attached to the vehicle.
Consequence & remedy
Consequence: If a seat belt assembly is not properly attached to the vehicle, the seat belt may not properly restrain an occupant in the event of a crash, increasing the risk of injury.
Remedy: GM will notify owners, and dealers will replace the suspect bolts, free of charge. The recall began January 29, 2021. Owners may contact GMC customer service at 1-800-462-8785, Cadillac customer service at 1-800-458-8006, or Chevrolet customer service at 1-800-222-1020. GM's number for this recall is N202322230.
Additional source detail variants (2)
Seat Belts:critical Fasteners
General Motors, LLC (GM) is recalling certain 2020 Chevrolet Bolt EV and 2021 GMC Canyon and Sierra 1500, 2500 and 3500, Yukon, Yukon XL, Cadillac Escalade and Escalade ESV and Chevrolet Blazer, Camaro, Colorado, Equinox, Silverado 1500, 2500 and 3500, Suburban and Tahoe vehicles. Incorrect bolts may have been used at one or more fastening locations to secure the seat belts to the vehicle. If an incorrect bolt was used, the seat belt may not be properly attached to the vehicle.
Consequence: If a seat belt assembly is not properly attached to the vehicle, the seat belt may not properly restrain an occupant in the event of a crash, increasing the risk of injury.
Remedy: GM will notify owners, and dealers will replace the suspect bolts, free of charge. The recall began January 29, 2021. Owners may contact GMC customer service at 1-800-462-8785, Cadillac customer service at 1-800-458-8006, or Chevrolet customer service at 1-800-222-1020. GM's number for this recall is N202322230.
Seat Belts
General Motors, LLC (GM) is recalling certain 2020 Chevrolet Bolt EV and 2021 GMC Canyon and Sierra 1500, 2500 and 3500, Yukon, Yukon XL, Cadillac Escalade and Escalade ESV and Chevrolet Blazer, Camaro, Colorado, Equinox, Silverado 1500, 2500 and 3500, Suburban and Tahoe vehicles. Incorrect bolts may have been used at one or more fastening locations to secure the seat belts to the vehicle. If an incorrect bolt was used, the seat belt may not be properly attached to the vehicle.
Consequence: If a seat belt assembly is not properly attached to the vehicle, the seat belt may not properly restrain an occupant in the event of a crash, increasing the risk of injury.
Remedy: GM will notify owners, and dealers will replace the suspect bolts, free of charge. The recall began January 29, 2021. Owners may contact GMC customer service at 1-800-462-8785, Cadillac customer service at 1-800-458-8006, or Chevrolet customer service at 1-800-222-1020. GM's number for this recall is N202322230.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.
Illustration