2016 Chevrolet Colorado

What component or system failed or malfunctioned, and is it available for inspection upon request? Water intrusion to the cab of the truck has structural failure in the roof causing it to leak inside the cab. Leak runs into dash and out of ignition causing electrical issues in the dash and ignition, along with pooling on the floorboards causing rusting; runs into the rear 3rd brake light and rear headliner causing electrical concerns to the rear brake light not alerting of braking and leaks into rear seats causing rusting under the seats where the seats can fall through the floorboards. How was your safety or the safety of others put at risk? rear brake light failure to alert surrounding drivers of braking. Possible electrocution in starting the vehicle with water in the ignition and dash; possible passenger/driver being dropped through the floorboards while driving. Has the problem been reproduced or confirmed by a dealer or independent service center? unknown Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? I have had it looked at by mechanics and told it was a body issue and needed to go to a body shop, not the dealership. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No

The body is defective in keeping water out of the cab. Water intrusion into cab causing moisture build-up and damaging interior and electrical components. My safety is at risk due to the electrical components in the cab that run the vehicle could cause electrocution or cause the vehicle to fail while in use. No they have not reproduced the problem. Yes, GM Collision center and service center (three separate times) have seen the vehicle and the video of the leak. I informed them of the TSB5396 of the known manufacturer defect issue. No warning, problem was first noticed in May 2023. I found my interior completely soaked one morning. I have waterproof marathon seat covers and they are soaked thru to the seats. Checked all windows to make sure they were up and the door seals were shut, everything was closed. Assumed that it was a fluke, followed up by checking the next morning and found the headliner dripping along with a soaked interior again. With the electrical seats and all the electronics in the dash I am concerned about that much water and moisture being in the cab might electrocute me or cause malfunction while driving. Besides the fact that moisture causes rust, mold and mildew that are dangerous to your health to breathe in.

THE REAR FENDERS ON TRUCK ARE BLISTERING. THERE ARE BUMPS ALL ALONG THE OUTSIDE OF THE REAR FENDER WELLS. THE PROBLEM IS ROAD DEBRIS AND SMALL STONES GETTING UP INSIDE THE INNER FENDER WELLS AND VIBRATING DOWN PUSHING DENTS THROUGH TO THE OUTSIDE OF VECHICLE. THIS IS GOING TO RESULT IN ACCELORATED RUST THROUGH OF THE REAR FENDERS AS THE FINISH IS DAMAGED ON BOTH SIDES OF THE PANELS. I HAVE WORKED WITH THE DEALER, WHO ATTEMPTED ONE REPAIR (WHICH FAILED) BUT I HAVE BEEN TOLD BY THEM AND GM CUSTOMER SERVICE THAT THEY WILL NOT FIX THE ISSUE. THE TRUCK HAD 16200 MILES ON IT WHEN THIS STARTED. I FOUND ONLINE THAT OTHER GM TRUCKS HAVE THIS ISSUE, CHEVROLET ISSUED A SERVICE BULLETIN ON SILVERADOS FOR THE SAME ISSUE AND OTHER PEOPLE ARE COMPLAINING ON THE COLORADO OWNERS SITES BUT GM IS REFUSING TO MAKE REPAIRS. THIS ISSUE IS GOING TO CAUSE RUST THROUGH AND JAGGED BODIES ON ALL OF THESE VECHICLES IN VERY SHORT ORDER IN NORTHERN AREAS.

TRUCK SITS UNEVEN FROM SIDE TO SIDE . 1" DIFFERENCE AT REAR WHEEL WELLS WHEN SITTING ON A LEVEL SURFACE WITH NO LOAD IN THE BED AND A 1/2 " DIFFERENCE IN THE FRONT SIDE TO SIDE . THE REAR OVERLOAD SPRING LEAF WITH RUBBER BUMPER TOUCHES UPPER ADJACENT SPRING LEAF WITH NO LOAD IN THE BED ON THE DRIVER SIDE . NOT SURE IF THIS COULD BE A SAFETY CONCERN IF THERE IS A LOAD PLACED IN THE BED CAUSING ISSUES IN HOW THE TRUCK HANDLES OR COULD BE CAUSING PREMATURE TIRE WEAR OR OTHER ISSUES WITH OTHER SUSPENSION PARTS .I HAVE BEEN INFORMED THAT THIS IS A KNOWN ISSUE WITH OTHER COLORADO TRUCKS BY THE DEALERSHIP I PURCHASED THE FROM . THIS TRUCK CAME OFF OF THE DEALERSHIP LOT WITH THIS PROBLEM AND GM TECH. ASSIST. IS AWARE . AFTER ALMOST 3 MONTHS NOTHING HAS BEEN DONE .

AT SPEEDS ABOVE 60 MPH THE SHEET METAL ON THE HOOD BEGINS TO RIPPLE, FLUTTER, AND DISTORT. THIS PROBLEM IS WELL KNOWN BY CHEVROLET. THE DEALER HAS APPLIED EXPANDING FOAM INSIDE THE HOOD UNDER WARRANTY, BUT THE METAL CONTINUES TO DISTORT AND RIPPLE AT HIGHWAY SPEED. I AM AFRAID THE HOOD SHEET METAL WILL FAIL AND THE HOOD WILL COME OFF THE VEHICLE WHILE DRIVING. CHEVROLET REFUSES TO DO ANYTHING FURTHER ABOUT IT.