IllustrationTHE RIMS ON THESE WHEELS ARE VERY SOFT. THE CALIFORNIA HIGHWAY PATROL NOW SPECIFIES A 'HARDENED' RIM ON THESE WHEELS FOR THEIR MOTORCYCLES. A KNOWN ISSUE.
1995 BMW R1100
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all R1100 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 2 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Wheels. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Suspension. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
What owners actually said
2 reportsTHE SPOKE RIMS ARE TOO SOFT, CAUSING TIRES TO LOSE AIR.
Official recalls
197V237000 · Electrical System:wiring
Dec 31, 1997
VEHICLE DESCRIPTION: MOTORCYCLES. A SHEET METAL PLATE MOUNTED TO THE FRONT OF THE FRAME BELOW THE INSTRUMENT CLUSTER CAN CAUSE THE WIRING HARNESS TO BE STRETCHED TOO TIGHT AS THE HANDLEBARS ARE TURNED FULLY TO ONE SIDE. IN ADDITION, THE WIRING HARNESS IS ATTACHED TO ANOTHER HARNESS WITH A CABLE TIE THAT IS PLACED TOO FAR FORWARD LIMITING THE HANDLEBAR MOVEMENT.
Consequence & remedy
Consequence: THE HARNESS WIRES CAN BE DAMAGED OR COULD BREAK OR PULL OUT OF THE IGNITION SWITCH. IF THE HARNESS WIRES WERE DAMAGED BUT NOT BROKEN OR DISCONNECTED, THE ELECTRICAL SYSTEM COULD BE AFFECTED WHILE THE MOTORCYCLE IS BEING DRIVEN. HESITATION, MISFIRING, OR "CUTTING OUT" COULD OCCUR INCREASING THE RISK OF A VEHICLE CRASH.
Remedy: DEALERS WILL RELOCATE THE WIRE TIE CONNECTING THE TWO WIRING HARNESSES TO A POINT FURTHER BACK FROM THE ORIGINAL LOCATION SO THAT THE IGNITION SWITCH WIRING HARNESS HAS SUFFICIENT FREEDOM OF MOVEMENT. ALSO IF THE WIRING HARNESS IS FOUND TO BE DAMAGED, THE IGNITION SWITCH (WITH HARNESS) WILL BE REPLACED.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1SQ97022 · Steering Lock/ignition Switch Wiring
Opened Nov 14, 1997 · Closed Dec 31, 1997
Status: closed (inferred from source dates) · Steering
BMW WILL CONDUCT A SAFETY RECALL TO REMOVE THE SHEET METAL PLATE AND RELOCATE TWO WIRING HARNESSES SO THAT THE IGNITION WIRING HARNESS HAS SUFFICIENT FREEDOM OF MOVEMENT THROUGHOUT THE RANGE OF MOTION OF THE HANDLEBARS.WIRING HARNESSES FOUND DAMAGED, WILL BE REPLACED.NO FURTHER ACTION IS NECESSARY.THIS INVESTIGATION IS CLOSED.