THERE'S A KNOWN ISSUE WITH 2015+ BMW F80 M3 S55 ENGINE. THE ISSUE IS THE CRANK HUB SPINNING OUT AND DAMAGING THE CAR. IT LEAVES THE VEHICLE IN A DANGEROUS STATE WHEN DRIVING ON THE ROAD AND TO OTHERS NEAR BY. THIS ISSUE HAPPENS TO STOCK VEHICLES AND MODDED ONES. IF THE CRANK HUB SPINS WHILE THE CAR IS MOVING, IT CAN LEAVE THE C…
Read full complaint
THERE'S A KNOWN ISSUE WITH 2015+ BMW F80 M3 S55 ENGINE. THE ISSUE IS THE CRANK HUB SPINNING OUT AND DAMAGING THE CAR. IT LEAVES THE VEHICLE IN A DANGEROUS STATE WHEN DRIVING ON THE ROAD AND TO OTHERS NEAR BY. THIS ISSUE HAPPENS TO STOCK VEHICLES AND MODDED ONES. IF THE CRANK HUB SPINS WHILE THE CAR IS MOVING, IT CAN LEAVE THE CAR IN A DANGEROUS STATE WITH NO POWER. LINKS ABOUT IT: HTTPS://WWW.YOUTUBE.COM/RESULTS... SPECIFIC VIDEO THAT EXPLAINS THE CRANK HUB ISSUE WITH THIS MODEL OF A CAR: HTTPS://YOUTU.BE/SJR3ZHEGS_U?T=160 THIS ISSUE HAS PERSONALLY HAPPENED ON MY M3. I WAS COASTING DOWN A HILL TOWARDS A GREEN STOPLIGHT, AND A DRIVETRAIN MALFUNCTION ERROR POPPED UP ON MY SCREEN. I IMMEDIATELY PUSHED IN THE CLUTCH, AND WITHIN 1 SECOND MY ENGINE TURNED OFF. MY CAR WAS LEFT WITH NO POWER, THE ENGINE WOULD NOT RESTART. I GOT THE CAR HOME BY TOWING IT, THEN USING A WINCH TO GET IT IN MY GARAGE. I USED MY OBD2 READER TO READ THE DTC'S AND ALL THE CODES THAT CAME UP WERE DIRECTLY RELATED TO THE CRANK HUB SPINNING. IT WAS DANGEROUS BECAUSE I WAS APPROACHING A BUSY INTERSECTION. I HAD TO PUSH MY CAR OUT OF THE INTERSECTION. I WAS NOT INJURED, I DID NOT CRASH, AND I DID NOT LOSE CONTROL. ALTHOUGH IF I WAS GOING AT A HIGHER RATE OF SPEED, IT WOULD BE EASY TO LOSE CONTROL FROM THIS ISSUE.
NHTSA ODI #11290215
20,000 miles · Dec 18, 2019
Engine
THERE'S A KNOWN ISSUE WITH 2015+ BMW F80 M3 S55 ENGINE. THE ISSUE IS THE CRANK HUB SPINNING OUT AND DAMAGING THE CAR. IT LEAVES THE VEHICLE IN A DANGEROUS STATE WHEN DRIVING ON THE ROAD AND TO OTHERS NEAR BY. THIS ISSUE HAPPENS TO STOCK VEHICLES AND MODDED ONES. IF THE CRANK HUB SPINS WHILE THE CAR IS MOVING, IT CAN LEAVE THE CA…
Read full complaint
THERE'S A KNOWN ISSUE WITH 2015+ BMW F80 M3 S55 ENGINE. THE ISSUE IS THE CRANK HUB SPINNING OUT AND DAMAGING THE CAR. IT LEAVES THE VEHICLE IN A DANGEROUS STATE WHEN DRIVING ON THE ROAD AND TO OTHERS NEAR BY. THIS ISSUE HAPPENS TO STOCK VEHICLES AND MODDED ONES. IF THE CRANK HUB SPINS WHILE THE CAR IS MOVING, IT CAN LEAVE THE CAR IN A DANGEROUS STATE WITH NO POWER. LINKS ABOUT IT: HTTPS://WWW.YOUTUBE.COM/RESULTS... SPECIFIC VIDEO THAT EXPLAINS THE CRANK HUB ISSUE WITH THIS MODEL OF A CAR: HTTPS://YOUTU.BE/SJR3ZHEGS_U?T=160
NHTSA ODI #11289964
28,000 miles · Dec 18, 2019
Engine
THE CRANKHUB ON THESE CARS ARE TICKING TIME BOMBS AND IS LIKELY TO FAIL JUST OUTSIDE OF WARRANTY FORCING HUGE REPAIR BILLS. IN SOME CASES, A "LUCKY" FEW JUST NEED TO BE RETIMED AND ONLY REQUIRE 18 HOURS OF LABOR. HOWEVER, OTHERS HAVE NOT BEEN SO LUCKY AND HAVE REQUIRED AN ALL-NEW ENGINE. THIS IS AN ISSUE BMW IS FULLY AWARE OF BU…
Read full complaint
THE CRANKHUB ON THESE CARS ARE TICKING TIME BOMBS AND IS LIKELY TO FAIL JUST OUTSIDE OF WARRANTY FORCING HUGE REPAIR BILLS. IN SOME CASES, A "LUCKY" FEW JUST NEED TO BE RETIMED AND ONLY REQUIRE 18 HOURS OF LABOR. HOWEVER, OTHERS HAVE NOT BEEN SO LUCKY AND HAVE REQUIRED AN ALL-NEW ENGINE. THIS IS AN ISSUE BMW IS FULLY AWARE OF BUT HAS NOT TAKEN RESPONSBILITY FOR THEIR INSUFFICIENT ENGINEERING.
BMW of North America, LLC (BMW) is recalling certain 2016-2017 BMW M3 Sedans, 2016-2017 BMW M4 and M4 GTS Coupes and 2017 BMW M4 Convertible vehicles. The connection between the driveshaft and the flange may fail resulting in a loss of propulsion.
Consequence & remedy
Consequence: A loss of vehicle propulsion can increase the risk of a crash.
Remedy: BMW will notify vehicle owners, and dealers will replace the driveshaft, free of charge. The recall began April 9, 2019. Owners may contact BMW customer service at 1-800-525-7417.
BMW North America, LLC (BMW) is recalling certain model year 2016 BMW M2 Coupe vehicles, 2015-2017 M3 Sedan vehicles and 2015-2016 M4 Coupe and M4 Convertible vehicles. During servicing of the rear differential for a prior service action, the rear sub-frame bolts may have been reused instead of being replaced. Reuse of the existing bolts may cause the bolts to loosen.
Consequence & remedy
Consequence: Loose rear sub-frame bolts may adversely affect vehicle handling and control, increasing the risk of a crash.
Remedy: BMW will notify owners, and dealers will replace the rear sub-frame bolts with new bolts, free of charge. The recall began on November 3, 2016. Owners may contact BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling certain model year 2015-2016 M3 Sedan vehicles manufactured May 30, 2015, to September 2, 2015, 2016 M4 Coupe vehicles manufactured July 3, 2015, to September 11, 2015, and 2015-2016 M4 Convertible vehicles manufactured May 29, 2015, to August 4, 2015. The affected vehicles have a driveshaft with a slip-joint that may not have been filled with grease. As a result, the slip-joint may fail over time.
Consequence & remedy
Consequence: If the slip-joint fails, there would be a loss of power to the rear axle and therefore the vehicle would stop moving, increasing the risk of a crash.
Remedy: BMW will notify owners, and dealers will inspect the driveshaft, replacing it as necessary, free of charge. The recall began on January 14, 2016. Owners may contact BMW customer service at 1-800-525-7417.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2016 BMW M3 Problems, Complaints & Recalls | Skip That Year
Illustration