The roof of the BMW started delaminating a few years back, and it is compromising the structural integrity of this vehicle. In an attempt to fix the roof, epoxy was applied after it was smoothed down and the roof looked aesthetically pleasing for about a year, until it started delaminating rapidly in the same spots. Now, the ro…
Read full complaint
The roof of the BMW started delaminating a few years back, and it is compromising the structural integrity of this vehicle. In an attempt to fix the roof, epoxy was applied after it was smoothed down and the roof looked aesthetically pleasing for about a year, until it started delaminating rapidly in the same spots. Now, the roof liner is starting to collapse, telling me that moisture is getting into the vehicle, further damaging the roof.
NHTSA ODI #11761765
Mileage unknown · Oct 7, 2024
Structure
The carbon fiber roof is delaminating and a portion of it came off and hit the front windshield of another car, causing them to partially lose control of their vehicle almost causing an accident. This is a known issue BMW has not taken an action to resolve it. I’m afraid that a larger chunk may hit somebody’s car and cause a sev…
Read full complaint
The carbon fiber roof is delaminating and a portion of it came off and hit the front windshield of another car, causing them to partially lose control of their vehicle almost causing an accident. This is a known issue BMW has not taken an action to resolve it. I’m afraid that a larger chunk may hit somebody’s car and cause a severe accident.
NHTSA ODI #11618578
Mileage unknown · Sep 10, 2024
Structure
A large portion of the car's hood (carbon laminate?) has ripped off and is surely to continue to tear and fly off while driving.
NHTSA ODI #11613788
Mileage unknown · Aug 19, 2023
Structure
Car roof is delaminating.
NHTSA ODI #11539536
Mileage unknown · Aug 17, 2023
Structure
Roof is bubbling showing signs of delamination. Structural integrity is in question. I believe it is due to the carbon fiber epoxy material degrading due to sunlight exposure.
NHTSA ODI #11539259
Mileage unknown · May 12, 2022
EngineStructureVehicle Speed Control
I purchased my 2014 BMW i3 from Canada in 2019. It was imported from the U.S and still is registered in the U.S. I brought it into the BMW dealership in Vancouver BC shortly after to do a vehicle inspection. At that time, the dealer printed out a list of defect codes/recalls. It also said that they were done and marked "yes" com…
Read full complaint
I purchased my 2014 BMW i3 from Canada in 2019. It was imported from the U.S and still is registered in the U.S. I brought it into the BMW dealership in Vancouver BC shortly after to do a vehicle inspection. At that time, the dealer printed out a list of defect codes/recalls. It also said that they were done and marked "yes" completed. Fast forward to 2022, I bring my car into the same dealer and they said there is a recall not completed to replace the convenience charging electronics KLE and that they would fix for free. My car was not starting and we thought it could have caused the issue. They also noted at that time that the engine mount screws are now split and need to be replaced. I then discovered it was part of an open recall but when I asked about this, they said the recall closed in 2016 and I would now be responsible to replace this part for $3400+ even though it was a known defective BMW part. Upon further research, the initial part replaced was deemed not good enough and the part was upgraded to aluminum (it is currently a plastic mount bracket). I have tried requesting again for them to complete the recall work but they said they told me: " Yes, there was a recall but it was completed in 2016 in san fran by the looks of it. (<--I don't think it was actually completed) "I can't claim it since its done unfortunately... there is no way for me to claim this to you either as the repairs done more than 2 years ago and the car is out of warrant for 4 years. So BMW will just see it as just wear and tear. I tried to see of any ways I could assist you but there isn't a way for me to claim this with BMW" So my issue, and why I am writing you is that they claim the part has been completed but it has not, it is still the original bracket and screw mount. Plus they admitted they still needed to replace the charging electronics when this was apparently also marked as completed. I suspect someone lied about the recall work being done in San Francisco.
NHTSA ODI #11464379
Mileage unknown · Jan 3, 2018
Structure
THE DRIVER'S DOOR DOES NOT CLOSE OR DOES NOT LATCH. THERE ARE TIMES WHEN IT UNLATCHES/OPENS WHILE I AM DRIVING AS WELL. BMW DEALERSHIP STATES THAT IT REQUIRED OIL ON THE LATCH BUT THAT HAS NOT FIXED THE ISSUE. THE PROBLEM HAPPENS WHEN I TRY TO CLOSE THE DOOR AND DRIVE AND WHILE DRIVING. THIS HAS HAPPENED MULTIPLE TIMES.
BMW of North America, LLC (BMW) is recalling certain 2014-2018 BMW i3 electric and hybrid electric vehicles. Unbelted, small adult, drivers may be at a higher risk of neck injury in the event of a frontal crash. These vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."
Consequence & remedy
Consequence: During a frontal impact, unbelted, small adult, drivers could be at a higher risk of neck injury.
Remedy: BMW will notify owners, and dealers will update the Driver air bag control unit software, free of charge. The recall is expected to begin January 8, 2018. Owners may contact BMW customer service at the dedicated i3 recall number 1-855-269-3361.
BMW of North America, LLC (BMW) is recalling certain 2014-2017 i3 REx hybrid electric vehicles. The fuel tank vent line may rub against the ribbed wire protection sleeve of the battery positive (B+) cable, creating a hole in the vent line and causing a fuel vapor leak.
Consequence & remedy
Consequence: A fuel vapor leak in the presence of an ignition source can increase the risk of a fire.
Remedy: BMW will notify owners, and dealers will inspect the fuel vent line, replacing it as necessary, and install a clip to prevent it from chafing, free of charge. The recall beganApril 3, 2017. Owners may contact BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling certain model year 2014-2016 MINI Cooper S and MINI Cooper two-door vehicles, 2015-2016 MINI John Cooper Works and MINI Cooper S and MINI Cooper four-door vehicles and 2014-2015 BMW i3 vehicles. Due to a manufacturing error, the passenger frontal air bag may not deploy properly in a low speed crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."
Consequence & remedy
Consequence: In the event of a vehicle crash, an air bag that does not deploy properly increases the risk of injury to the front seat passenger.
Remedy: MINI and BMW will notify owners, and dealers will replace the passenger frontal air bag module, free of charge. The recall began on November 25, 2015. Owners may contact MINI customer service at 1-866-825-1525 and BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling a certain model year BMW i3 vehicle manufactured March 31, 2014, and certain 2014 MINI Cooper Hardtop vehicles manufactured February 2, 2014 to May 30, 2014. The affected vehicles may have been manufactured with an air bag inflator that was not assembled correctly. This could cause the air bag to not deploy properly in the event of an accident.
Consequence & remedy
Consequence: If the air bag deploys improperly in the event of a crash necessitating deployment of the air bags, the seat occupant may be at an increased risk of injury.
Remedy: BMW will notify owners, and dealers will replace the front passenger side air bag, free of charge. The recall began in September 2014. Owners may contact BMW customer service at 1-800-525-7417.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
DP22005 · Pedestrian Alert Sounds
Opened Jan 27, 2023 · Closed Aug 7, 2023
Status: closed (inferred from source dates) · Electrical System:propulsion System
NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.
2014 BMW I3 Problems, Complaints & Recalls | Skip That Year
Illustration