← New search

1990 Acura Legend

Owner reports · Recalls · Investigations

Similar to other model years

Owner complaints for the 1990 Acura Legend do not stand out strongly from the model-year median of 29.

About this comparison →

How this year compares

Owner complaints by model year

Other model years Selected year
Compare all Legend years →

Counts vary with age, sales and reporting. They are not failure rates.

What owners reported most

All reported categories

Tap a category to read its complaints. One report may name several components.

When problems were reported

Mileage at the reported incident

Limited mileage data: 2 of 36 reports include usable mileage. There isn’t enough coverage to show a useful chart.

NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.

What to inspect

Issues worth paying extra attention to based on owner reports.

  • Service Brakes, Hydraulic. Review the 11 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Structure. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Air Bags. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

8 crash reports1 fire reports4 injury reports

Structure complaints

5 reports
Clear category filter
Mileage unknown · Jun 25, 2014
Air BagsStructureUnknown Or OtherCrashInjury

I WAS INVOLVED IN A HIT AND RUN WHICH CAUSED MY DRIVER SIDE AIR BAG TO DEPLOY CAUSEING SWELLING TO MY FACE AND THE FUMES FROM THE AIR BAG ITSELF WAS VERY STRONG. *TR

NHTSA ODI #10605981

151,000 miles · Jan 15, 2004
EquipmentSteeringStructure

I HAVE HAD THE FRONT LOWER BALL JOINTS REPLACED IN 2001, 2002 AND 2003 WITH LESS THAN 10,000 MILES AND AROUND A YEAR OF WEAR. THE FIRST TIME THEY WERE REPLACED, THE DEALER DID THEM AND PUT IN DEFECTIVE PARTS. AND REFUSED TO REPLACE THEM EVEN AFTER ADMITTING THEIR DEFECTIVENESS-- OF COURSE THE SERVICE REP DENIES HAVING ADMITTED…

Read full complaint

I HAVE HAD THE FRONT LOWER BALL JOINTS REPLACED IN 2001, 2002 AND 2003 WITH LESS THAN 10,000 MILES AND AROUND A YEAR OF WEAR. THE FIRST TIME THEY WERE REPLACED, THE DEALER DID THEM AND PUT IN DEFECTIVE PARTS. AND REFUSED TO REPLACE THEM EVEN AFTER ADMITTING THEIR DEFECTIVENESS-- OF COURSE THE SERVICE REP DENIES HAVING ADMITTED THIS.

NHTSA ODI #10070923

Mileage unknown · Feb 6, 2003
StructureInjury

THE SPRINGS THAT ARE SUPPOSED TO HOLD MY TRUNK LID OPEN AREN'T STRONG ENOUGH AND THE LID CLOSES SUDDENLY WHEN THERE IS A BREEZE OR IT'S PARKED ON A INCLINE. IT PROBABLY HAPPENS AT LEAST 5 TIMES A MONTH, OR MORE FREQUENTLY DEPENDING UPON THE WEATHER OR WHERE I'M PARKING. I'VE BEEN THUMPED IN THE HEAD AND NECK.

NHTSA ODI #10005429

Mileage unknown · Sep 26, 1996
Structure

TRUNK SPRINGS NOT STRONG ENOUGH TO HOLD TRUNK LID OPEN WHEN PARKED ON SLIGHT GRADE.

NHTSA ODI #509172

Mileage unknown · Jun 21, 1996
Structure

DUE TO ELECTRICAL SHORT IN THE POWER LOCKS WHEN YOU LOCK THE DOORS FROM THE INSIDE, THE DOORS WILL NOT UNLOCK . *AK

NHTSA ODI #985989

Official recalls

1

95V103001 · Seat Belts:front:buckle Assembly

May 24, 1995

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence & remedy

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES. CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. CHECK THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUG ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, THEN PRESS THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS ANY SIGN OF BREAKAGE OR CRACKING, OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, PROMPTLY CONTACT YOUR AUTHORIZED HONDA/ACURA DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT THE FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

0

No exact-year investigations in this snapshot.