2022 Toyota Tundra

On September 1, 2026, my 2022 Toyota Tundra experienced a serious loss of accelerator response while I was leaving a gas station and entering traffic. I pressed the accelerator, but the truck provided effectively no acceleration, leaving me partially in the roadway. An approaching vehicle had to swerve into the opposing traffic lane to avoid a collision. I had experienced a similar low-speed loss of accelerator response within the prior two weeks. On September 2, while traveling on I-70 at approximately 70 mph, the truck experienced a separate loss-of-power event. Engine RPM dropped considerably and the vehicle felt as though it were coasting. I pressed the accelerator firmly, but it did not respond normally for approximately 5-10 seconds before power returned. Radar/adaptive cruise control was not engaged. I immediately took the truck to Western Slope Toyota. Technicians checked for codes, performed multiple road tests and recorded vehicle data but could not reproduce the intermittent failure. The issue was escalated to Toyota technical assistance under TAS Case 262460664. This problem has been documented by Western Slope Toyota since 2023. Toyota's applicable TSB repairs were performed on prior occasions in an attempt to correct the throttle/hesitation problem, but they did not resolve it. In 2025, the dealer again documented the condition after the earlier TSB had already been performed. According to the September 2026 repair documentation and my discussion with the Western Slope Toyota service manager, Toyota's specialist technical team is aware that the condition can remain despite the TSB work. The repair order states that Toyota identified a known hesitation concern that remains under investigation and that there was no repair to be made at that time. The condition is intermittent and unpredictable and can cause loss of accelerator response or motive power at low and highway speeds. I believe it creates a serious crash risk. Current mileage: 58,735.

Manufacturer Recall Number25TB06 NHTSA Recall Number25V322 In regards to the above mentioned recalls. The vehicle's reverse camera began flashing while driving forward. The R light on the gearshift was also flashing. While driving forward about 15 mph out of a parking lot, the vehicle suddenly went into reverse on it's own, locked up and would not move. I had to have the vehicle towed to the dealership. This happened around the week of June 8. The dealership says that they reset the electrical recall, we picked up the truck and it ran fine for about a week. The reverse camera and R light on the gearshift began flashing again on June 17. It did not shift itself into reverse, but the dealership requested that we bring the vehicle back. The dealership stated that Toyota has "grounded" the vehicle and does not have a fix for the recall to date and continuing to drive it is a safety hazzard. It has been sitting at the dealership since June 18 with no end in sight. The dealership and Toyota Corporate continues to tell me every few days that they do not have a fix for the issues/recalls.

I have not had an actual vehicle accident as of yet but the vehicle has a serious hesitation issue during acceleration from a quick stop or rolling situation whereas if you were making a left turn at a traffic light and were waiting for traffic while execrating to clear the next on coming vehicle there is sometimes a 3 second or more delay before the vehicle will accelerate which could cause an accident. Toyota has recognized this issue and came out with a technical service bulletin (T-SB-0032-26) with an update program for the TCU but has not included my vin or several others that have this same issue. I have been told by my dealer that they could do the update but since my vin is not included they would have to charge me. This is a major safety issue and needs to be addressed at no cost to the consumers. I have contacted Toyota brand engagement and they were no help at all acting like they had no idea what I was talking about. It happens every, everywhere. Major safety issue. Making complaints before accidents or fatalities happen because of this!

I've been experiencing throttle lag on my 2022 Tundra in certain situations during rolling stops (I've also had it occur from a dead stop, though more frequent in rolling stops). Sometimes there is a significant delay in throttle response, and the other day while pulling out into traffic the delay was perhaps 2-3 seconds. This nearly created an accident as the engine had zero response and greatly affected my ability to accelerate quickly enough. Please consider this as a possible recall, as the danger level is very high for this known issue. Thank you for your time.

In this vehicle, I regularly experience a "delay" in gas pedal response. I drive a non-hybrid V6 twin turbo variant engine 2022 Toyota Tundra, and for a long time I thought this was just related to turbo spooling delays. But Toyota's recent TSB-0032-26 publishing last month confirmed that it is actually a TCM logic issue requiring a re-flash. I spoke to the dealership and this is not covered outside of the standard 3-year bumper to bumper warranty, and they wouldn't cover it under the powertrain warranty which lasts longer, even though this is technically a power train issue. This concern has left me challenged with timing gas pedaling from a full stop, often with a noticeable 1-2 second lag before the truck responds. I have had a couple of close calls because this behavior inhibits safe judgement calls for acceleration. Especially from full stops this is most noticeable, but also when you are trying to accelerate suddenly, there's always a brief delay.

The vehicle was purchased brand new from an authorized franchised dealership, sold and contracted as being equipped with a dealer-installed 2.5-inch suspension lift. At approximately 20,000 miles, a severe front-end squeaking symptom developed. The vehicle was brought to a separate authorized Toyota dealership service center for inspection. An authorized Toyota Master Technician formally inspected the vehicle and documented that the selling dealership did not install an engineered suspension lift. Instead, they installed unauthorized, budget aftermarket spacer pucks and non-certified upper control arms. The Master Technician documented in writing that the vehicle "isn't even lifted properly" and a factory front strut has failed prematurely. SAFETY RISK: The unauthorized spacer modification has severely altered and compromised the factory steering and suspension geometry. Because the front suspension, upper control arms, ball joints, struts, and steering rack are forced to operate continuously at unsafe, extreme, out-of-spec angles, the components are subjected to premature, destructive stress. The Master Technician confirmed that this improper configuration creates an imminent highway life-safety hazard, presenting an extreme risk of the front CV axles binding or snapping at highway speeds, which would result in an immediate, catastrophic loss of steering control. The vehicle is available for inspection upon request. The safety defect has been explicitly reproduced and confirmed in writing by an authorized Toyota Master Technician. The selling dealership management has been formally notified of this safety diagnosis but has actively refused to remediate the unsafe components, leaving a structurally compromised and highly dangerous vehicle operating on public highways.

Multiple times in my almost 3 year ownership I have experienced a “dead pedal” while pulling out into traffic from a stop. It has almost caused a t bone accident on a few occasions. It’s been to the dealer and had a software update TSB 0111-22. After the update I didn’t have the issue for a little while, but it has come back and it now happens almost every time I drive it. Online search shows that there are multiple people having this problem. Toyota needs to come up with a fix for this before it causes a bad accident.

The issue is a dangerous hesitation during low-speed rolling acceleration. In real-world driving, when I slow down but do not come to a full stop — such as when merging, changing lanes, entering traffic, crossing an intersection, or rolling through a turn — the gasoline engine can shut off while the truck is still moving. When I then press the accelerator to re-enter traffic or move quickly out of the way, there is a noticeable delay before meaningful propulsion is delivered.This hesitation is not a minor comfort issue. It creates a real safety risk.In a small hybrid passenger car, electric-only rolling behavior may be acceptable because the electric motor can often move the vehicle adequately on its own. But this is a full-size half-ton pickup. In my experience, the electric motor alone does not always provide sufficient immediate response for the weight and use case of the vehicle. The result is a dangerous dead zone where the driver is asking for acceleration, the vehicle is rolling, traffic conditions are changing, and the truck does not respond quickly enough.If a Toyota hybrid half-ton pickup is moving, the gasoline engine should not shut down in a way that prevents immediate acceleration when the driver presses the accelerator. This behavior has created multiple close calls for me. The most concerning scenario is a rolling slowdown followed by the need for immediate acceleration — for example, pulling into traffic, changing lanes, or clearing an intersection. In those moments, a 2–4 second delay is not merely annoying. It can be the difference between safely completing a maneuver and being exposed to a collision.

While at a 2-way stop sign, when attempting to accelerate while turning right, the truck hesitated and did not move. Pressing the accelerator further down did nothing for what felt like 1-3 seconds and then all of a sudden it rushed forward. This is incredibly dangerous as there were vehicles heading towards me. This is not the first time this has happened. It happens nearly daily, while the engine is warm, while the engine is cold, in Eco, Normal and Sport modes. The only time I had zero issues was when the computer was reset after having service done to the truck. It ran incredibly well and shifted and ran as expected.