1999 Toyota 4RUNNER

I PURCHASED THIS VEHICLE FROM A NEIGHBOR WHO BOUGHT IT NEW. HE TOOK IMPECCABLE CARE OF HIS VEHICLES SO I WAS VERY CONFIDENT IN THE PURCHASE. LESS THAN 2 YEARS AFTER WE BOUGHT IT FROM HIM, ONE OF THE REAR STABILIZERS TORE LOOSE FROM THE FRAME RAIL. AFTER GOING UNDERNEATH TO INSPECT THE DAMAGE, THERE WAS A LOT OF HOLES AND MAJOR CORROSION THAT APPEARED TO HAVE STARTED FROM THE INSIDE OF THE FRAME. I THOUGHT TO MYSELF THAT WITH THIS SOLID BOX STYLE FRAME, WHY IS THERE NO MEANS FOR ANY WATER OR CONDENSATION THAT BUILDS UP INSIDE THE FRAME TO GET OUT. I WAS GOING TO HAVE IT REPAIRED UNTIL I INSPECTED IT FURTHER AND WHACKED A FEW PLACES WITH A HAMMER AND SENT IT RIGHT THROUGH THE FRAME! IT WAS A SHAME BECAUSE IT RAN EXCELLENT AND I'M CONFIDENT IT WOULD HAVE WENT ANOTHER 100,000 MILES. INSTEAD I WAS FORCED TO SELL IT FOR A PARTS VEHICLE AND LOST OVER $3000 ON THE DEAL. IF THIS CAN HAPPEN TO A VEHICLE THAT WAS TAKEN CARE OF LIKE A COLLECTOR CAR, I CAN'T IMAGINE HOW FAST THEY CAN FALL APART IF THEY'RE ACTUALLY NEGLECTED. IT'S TOO BAD THIS HAPPENS BECAUSE THEY ARE A FANTASTIC VEHICLE OTHER THAN THIS ISSUE.

THE FRAMES ON THESE TOYOTA 4RUNNERS (1996-2002) ARE CHEAPLY MADE AND ROT FROM THE INSIDE OUT EVEN IN STATES WITH LITTLE SALT, THEY USE THIN CHEAP STEEL, THE DIFFERENTIAL HOUSINGS ALSO LEAK DUE TO PROOUS THIN CHEAPLY MADE 'STEEL'. TOYOTA NEEDS TO STEP UP TO THE PLATE ON THIS ONE. MY VEHICLES FRAME IS ROTTING FROM THE INSIDE OUT ASWELL AS THE DIFFERENTIAL HOUSING. THEY DID A FRAME RECALL ON THE TACOMAS, SEQUOIAS, ETC, THIS IS NO DIFFERENT!

I HAVE A 1999 TOYOTA 4RUNNER. I AM THE ORIGINAL OWNER, AND THIS VEHICLE HAS BEEN GARAGE KEEP AND WELL MAINTAINED SINCE I HAVE OWNED IT. WHILE DRIVING ON THE HIGHWAY AT ABOUT 55MPH ON 10/18/16, WITHOUT WARNING - THE 4RUNNER BEGAN TO SHAKE VIOLENTLY FROM SIDE TO SIDE... I ALMOST LOST CONTROL OF THE 4RUNNER AND COULD HAVE BEEN INVOLVED IN A SERIOUS ACCIDENT. THE REASON I LOST CONTROL OF THE 4RUNNER IS BECAUSE OF A SERIOUS RUSTING ISSUE IN THE FRAME (THIS ISSUE HAS BEEN WELL DOCUMENTED ON THE NHTSA, AND ALSO MANY OTHER WEBSITES). THE REASON THIS RUSTING ISSUE IS SO DANGEROUS IS WHERE THE RUSTING HAS OCCURRED. THE FRAME IS RUSTING RIGHT AT THE SECTION THAT THE LOWER CONTROL ARM BRACKET IS WELDED TO THE FRAME. THE LOWER CONTROL ARM BRACKET IS ATTACHED TO THE LINK/BAR THAT HOLDS THE REAR AXLE IN PLACE. THE RUST ON MY 4RUNNER FRAME CAUSED THE LOWER CONTROL ARM BRACKET ON THE DRIVERS SIDE TO COMPLETELY SEPARATE FROM THE FRAME, CAUSING A LOSS OF CONTROL OF THE VEHICLE (SEE ATTACHED PHOTOS). I CHECK THE CONTROL ARM BRACKET ON THE PASSENGER SIDE, AND IT ALSO SHOWS THE SAME SEVERE RUSTING AT THE FRAME WHERE THE CONTROL ARM BRACKET IS ATTACHED. THERE ARE STILL MANY 3RD GENERATION 4RUNNERS ON THE ROAD, AND I FEEL THIS RUSTING SITUATION IS PUTTING MANY LIVES IN DANGER. THERE IS NO WARNING, YOU JUST LOSE CONTROL. I UNDERSTAND THAT MY 4RUNNER IS 17 YEARS OLD... BUT AS I MENTIONED EARLIER, THE REST OF THE VEHICLE IS IN EXCELLENT SHAPE. A FRAME SHOULD NOT RUST THIS BADLY, ESPECIALLY IN A CRITICAL SECTION. PLEASE HOLD TOYOTA ACCOUNTABLE FOR A VEHICLE DEFECT THAT IS PUTTING LIVE IN DANGER. THANK YOU. *TR