ABS pump issue, very likely clogged valves, lead to rear brake pedal locked up in disengaged position while riding - no rear brakes. When I was riding at moderate speed, the ABS module engaged after the rear wheel slid a little on a patch of grass. Immediately afterwards I found the rear brake pedal became stiff, and one more t…
Read full complaint
ABS pump issue, very likely clogged valves, lead to rear brake pedal locked up in disengaged position while riding - no rear brakes. When I was riding at moderate speed, the ABS module engaged after the rear wheel slid a little on a patch of grass. Immediately afterwards I found the rear brake pedal became stiff, and one more test brake later the rear brake pedal became rock solid, and I cannot engage the rear brake anymore while riding. Upon further investigation with mechanics, what happened was the valves on the ABS module were clogged during the movement of fluid when ABS was engaged, therefore locking up the rear brake pedal. This seems to be a common problem for 2012 VStrom DL650A model by Suzuki: [XXX] [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Suzuki Motor of America, Inc. (Suzuki) is recalling certain model year 2012-2016 DL650 motorcycles manufactured August 30, 2011, to October 12, 2015. In the affected motorcycles, the alternator stator may have insufficient heat resistance, resulting in a short circuit of the stator wires.
Consequence & remedy
Consequence: A short circuit of the stator wires may prevent the battery from properly charging, causing an engine stall and increasing the risk of a crash.
Remedy: Suzuki will notify owners, and dealers will replace the stator, free of charge. The recall began on January 6, 2017. Owners may contact Suzuki customer service at 1-714-572-1490. Suzuki's number for this recall is 2A67.
Suzuki Motor of America, Inc. (Suzuki) is recalling certain model year 2013-2014 SFV650 and AN650A, and 2012-2014 DL650A motorcycles. Contamination from component production and storage combined with manufacturing variations may result in excessive tappet and camshaft wear within the engines of the affected motorcycles.
Consequence & remedy
Consequence: The excessive wear may result in an engine stall, increasing the risk of a crash.
Remedy: Suzuki will notify owners, and dealers will inspect the tappet clearance, replacing the tappets and camshafts, as necessary. All motorcycles that have less than 2500 miles will have their tappets and camshafts replaced since wear may not be evident. These repairs will be performed free of charge. The recall began on February 5, 2016. Owners may contact Suzuki customer service at 1-714-996-7040. Suzuki's number for this recall is 2A50, 2A51, and 2A52.
SUZUKI IS RECALLING CERTAIN MODEL YEAR 2012 AN400, AN650, AND DL650 SCOOTERS AND MOTORCYCLES MANUFACTURED PRIOR TO DECEMBER 17, 2011, BECAUSE THE LEVER-MOUNTED BRAKE LIGHT ACTUATING SWITCH(ES) MAY FAIL.
Consequence & remedy
Consequence: ON THE AN400 AND AN650 MODELS, FAILURE OF THE SWITCHES WILL PREVENT THE SCOOTERS FROM STARTING. ON ALL OF THE AFFECTED MODELS, FAILURE OF THE BRAKE LIGHT SWITCH(ES) MAY CAUSE THE BRAKE LIGHTS TO NOT ILLUMINATE WHEN A SCOOTER OR MOTORCYCLE IS BRAKING, THEREBY INCREASING THE RISK OF A CRASH WITH A TRAILING VEHICLE.
Remedy: SUZUKI WILL NOTIFY OWNERS, AND SUZUKI DISTRIBUTORS WILL REPLACE THE BRAKE LIGHT ACTUATING SWITCH, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON FEBRUARY 13, 2011. OWNERS MAY CONTACT SUZUKI AT 1-714-996-7040.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2012 Suzuki DL650 Problems, Complaints & Recalls | Skip That Year
Illustration