2026 RAM 3500

Vehicle at dealership a third time for same issue relating to U1412 code associated with ABS system. First time it was towed on 1/19/2026 and second time I took it to the dealership before it required towing on 3/26/2026. This time the truck required towing again after not being able to go into gear or being able to turn it off. Multiple warning lights on the dash. Still waiting for diagnosis but service department knew this problem from other vehicles and said manufacturer isn’t sure of cause.

Second incident relating to U1412 code where ABS related warning lights coming on. On 1/19/26 it had the same issue but was towed due to undriveable and would turn off. This time I drove straight to Dodge dealership where they got the codes, unlike last time due to batteries dead. Ram performed two flash updates and felt issue was fixed. Car is currently at dealership for third incident of same nature and had to be towed exactly same as first time on 1/19/26. Towed in on 4/16/2026. Three times when new truck less than 6 months old and 10k miles. Unsafe as mentioned on other report.

This is related to the 2025/2026 Ram 3500 U1412 code relating to anti lock brake system. On this date I got an ABS warning light and check engine light. The vehicle would not turn off, was not sure if it was in gear or not, and multiple other lights came on the dash. Vehicle towed to dealership. They said they could not reproduce the error and that all the codes disappeared due to the batteries dying overnight. They replaced both batteries and returned vehicle. Have since had same problem twice more with one requiring towing again. If this problem happens on roadway while being operated it would be very dangerous on roadway.

The contact owns a 2026 Ram 3500. The contact received notification of NHTSA Campaign Number: 26V059000 (EXTERIOR LIGHTING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact called a dealer while traveling in Braunfels, Texas, and asked about parts availability. The dealer stated that the manufacturer was providing only one part per week to the dealer location, which was causing a long wait for the recall repair. A second dealer, Miller Motor Sales Chrysler Dodge Jeep Ram (1196 Milwaukee Ave, Burlington, WI 53105) was contacted and confirmed the limited part supply to the dealer. The manufacturer was not made aware of the issue. The contact had not experienced a failure.

Well this is 2 nd report , got truck in sept , 1 tire blew at 625 miles , did not waste time at dealer this time , came off the ranch got about 10 miles down road tire was losing air ,pulled over was leaking bad ,now remember this is a 1 ton dulley Tk with 6 , six tires , same set of Goodyear tires , feb 26, 4100 miles then , now ok after this I came home went to discount Tire bought 6 new tires have my 6 tires off new Tk in barn , I can't take the risk of killing somebody are myself with another blow out !!! 3 tires off new dealers again said these should not be on this truck

Shortly after purchasing a new 2026 Ram 3500 in January 2026, the vehicle began displaying multiple safety warnings simultaneously while driving. Warning indicators included Check Engine, ABS, Brake, Traction Control, Electronic Stability Control, Forward Collision Warning, and Automatic Emergency Braking, along with a “Service Electronic Stability Control” message. The vehicle had very low mileage when the issue first occurred. The vehicle was taken to the dealership for diagnosis and repair. The dealership indicated the concern involved rear wheel speed sensor(s) and the vehicle’s electronic control systems (including a Body Control Module software update). Multiple repair attempts were required, including sensor replacement(s) and software updates, with manufacturer engineering involvement. The dealership and engineering instructed extended test driving (hundreds of miles total) to verify the repair. A particularly concerning element is that a replacement sensor reportedly failed without producing a diagnostic code, meaning the driver may have no warning that a critical component failed until safety systems disable or the vehicle behaves erratically. When the issue occurs, multiple safety systems are impacted at the same time, including ABS braking, stability control, traction control, and AEB/forward collision systems. Multiple safety systems disabled simultaneously. Dealership personnel also indicated that these wheel speed sensors are experiencing widespread failures and that replacement sensors can fail again shortly after installation as they have a 67% failure rate, which raises concern that this may represent a broader manufacturing or component defect affecting multiple vehicles. This complaint is submitted to document a potential safety defect affecting braking, stability control, and driver assistance systems.

While driving, the instrument cluster/odometer intermittently flashed and became difficult to read for ~15 minutes. After parking, the odometer continued flashing for ~10 additional minutes. After the flashing stopped, the vehicle displayed “ParkSense Unavailable – Service Required.” On a separate date, with no trailer connected and without pressing steering wheel buttons, the cluster displayed a “Blind Spot Alert – Trailer Type (Conventional/Goose/5th) – Press OK to Select” prompt. These events were captured on video. Safety risk: driver information/warnings become unreliable while the vehicle is in motion, which is distracting and may reduce awareness of speed/vehicle status. No crash, injury, or fire occurred. A dealer inspected the vehicle and reviewed the customer video. The dealer documented stored electrical/communication/configuration faults consistent with the concern, including ECU configuration mismatch, lost communication with the trailer interface module, and communication bus off faults. The dealer performed software updates to related modules and road tested ~34 miles; the concern did not reproduce during the test drive. The vehicle also has an open safety recall (NHTSA 26V-059 / FCA 03D) for the trailer tow module with remedy/parts pending. Incidents occurred on 02/16/2026 and 02/18/2026 at ~3,000 miles, including after cold/rain conditions. One restart sequence did not immediately stop the flashing. Dealer scan recorded the following (stored) DTCs: TIPM B2204-87 (ECU configuration mismatch), TIPM U116B-00 (lost communication with trailer interface module), and ITCM U0077-00 (communication bus off). Dealer performed module software updates including CADM update per TSB 08-020-26 and PCM update per RRT-26-036. Recall remedy for 26V-059 / FCA 03D remains pending parts.

4 times in less than 4000 miles my 2026 trucks abs, cruise control, skid control, and check engine warnin07g lights have come on. I then have no anti-lock system, no cruise control, no 4-wheel drive, and no anti-skid system. Code reads-U1412. The dealer has replaced the rear speed sensors and it continues to happen. My truck is currently at the dealer in the service bay as I can't drive it. I've researched this and it's happened to many who have purchased this truck.