IllustrationWHEN BRAKES WERE DEPRESSED THERE WAS A HESITATION IN BRAKING THAT RESULTED IN EXTENDED STOPPING DISTANCE. *PH
1995 Pontiac Grand Am
Owner reports · Recalls · Investigations
More warning signs than most Grand Am years
Owner complaints for the 1995 Pontiac Grand Am are substantially higher than the model-year median of 82.
About this comparison →How this year compares
Owner complaints by model year
Compare all Grand Am years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 33 of 409 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Electrical System. Review the 120 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 75 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 60 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
59 crash reports41 fire reports45 injury reports
What owners actually said
409 reportsCONSUMER STATES THAT THERE WAS A PROBLEM STARING THE VEHICLE. TOOK VEHICLE TO DEALER, AND THE DEALER REPLACED THE STARTER. *AK
WOULD HAVE KNOCKING UNDER THE VEHICLE WHEN CHANGING GEARS. ALSO, THERE WOULD BE SOME LOOSE WIRES THAT WOULD NEED TO BE PLACED ON THE BATTERY TO GET VEHICLE TO START. THE BRAKE LIGHTS COME ON AT THE WRONG TIME. VEHICLE ALSO WILL BE SQUEAKING. THE LIGHTS FAIL TO WORK PROPERLY BECAUSE THE ELECTRICAL SYSTEM IS NOT WORKING. HAVE TAK…
Read full complaint
WOULD HAVE KNOCKING UNDER THE VEHICLE WHEN CHANGING GEARS. ALSO, THERE WOULD BE SOME LOOSE WIRES THAT WOULD NEED TO BE PLACED ON THE BATTERY TO GET VEHICLE TO START. THE BRAKE LIGHTS COME ON AT THE WRONG TIME. VEHICLE ALSO WILL BE SQUEAKING. THE LIGHTS FAIL TO WORK PROPERLY BECAUSE THE ELECTRICAL SYSTEM IS NOT WORKING. HAVE TAKEN VEHICLE TO ARBITRATION. THE DEALERSHIP WAS SUPPOSE TO DO REPAIRS ON THE PROBLEMS, BUT FAILED TO DO SO. PROBLEMS STILL EXIST.*AK
CONSUMER STATED THAT WHILE DRIVING AT ANY SPEED AND WITHOUT WARNING THE FUEL PUMP FAILED. DEALER NOTIFIED. *AK
ERLS FUSE BLOWS, WHICH CAUSES THE CRUISE CONTROL TO STOP WORKING ALONG WITH THE A/C, ALSO THE REVERSE LIGHTS STOP WORKING, AND WHEN DRIVING AT 70 MPH INSTEAD OF THE RPM'S RUNNING ABOUT 2500 THEY ARE AT 3500 WHEN THE FUSE BLOWS. BROUGHT IT TO DEALER TO BE FIXED, THEY PUT A 25 AMP FUSE IN IT WHEN IT ONLY TAKES A 15 AMP FUSE AND SA…
Read full complaint
ERLS FUSE BLOWS, WHICH CAUSES THE CRUISE CONTROL TO STOP WORKING ALONG WITH THE A/C, ALSO THE REVERSE LIGHTS STOP WORKING, AND WHEN DRIVING AT 70 MPH INSTEAD OF THE RPM'S RUNNING ABOUT 2500 THEY ARE AT 3500 WHEN THE FUSE BLOWS. BROUGHT IT TO DEALER TO BE FIXED, THEY PUT A 25 AMP FUSE IN IT WHEN IT ONLY TAKES A 15 AMP FUSE AND SAID THEY COULDN'T FIND ANYTHING WRONG WITH IT. OF COURSE THAT BLEW EVENTUALLY ALONG WITH SOME SMOKE FROM THE FUSE PANEL. *AK
VEHICLE KEEPS OVER HEATING EVEN AFTER BEING IN A REPAIR SHOP OVER 6 TIMES. *AK
INTAKE MANIFOLD GASKET LEAK. CAR HAD 55,000 ORIGINAL MILES. PISTON SLAP ALSO BEGUN TO OCCUR. TRANSMISSION HAD PROBLEMS, ONLY REVS TO 4K RPM, WILL NOT GO HIGHER THAN 4K RPM. *TT
NAR 6-03-2003 *MR IGNITION SWITCH FIRE HAZARD. *CB
ABS BRAKES. *NLM
THE ENGINE LIGHT ILLUMINATED AND THE TEMPERATURE GAUGE READ THE VEHICLE OVER HEATED. THE VEHICLE WAS TAKEN TO THE DEALER ON 1/21/03 WHO STATED THERE A BLOCKAGE IN THE ENGINE, AND THE ENGINE NEEDED TO BE REPLACED. *JB
Official recalls
100V287000 · Electrical System:starter Assembly
Oct 2, 2000
VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE ENGINE STARTER FAILS TO ENGAGE AND THE DRIVER HOLD THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, PRODUCING HEAT THAT CAN MELT SWITCH PARTS.
Consequence & remedy
Consequence: A FIRE COULD OCCUR IN THE STEERING COLUMN AND SPREAD TO THE INTERIOR OF THE CAR.
Remedy: DEALERS WILL INSTALL A RELAY KIT AND VERIFY THAT THE VEHICLE WILL START WITH A PROPERLY CHARGED BATTERY IN GOOD OPERATING CONDITION (ADEQUATE RESERVE CAPACITY, OR COLD CRANKING AMPS). THIS CAMPAIGN DOES NOT COVER BATTERY REPLACEMENT OR UNRELATED STARTING SYSTEM OR ELECTRICAL SYSTEM REPAIRS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2EA00007 · Steering Column Fires
Opened Mar 3, 2000 · Closed Feb 7, 2001
Status: closed (inferred from source dates) · Electrical System
There is no summary currently available
PE99063 · Steering Column Fire
Opened Oct 7, 1999 · Closed Mar 3, 2000
Status: closed (inferred from source dates) · Steering
ODI HAS EXPANDED THE SCOPE OF ITS INVESTIGATION OF STEERING COLUMN FIRES TO INCLUDE ALL MODELS BUILT ON THE N-PLATFORM.GM HAS INDICATED IN ITS RESPONSE THAT THE SUBJECT VEHICLES ARE EQUIPPED WITH A ROTARY IGNITION SWITCH THAT HAS BEEN IN USE IN A NUMBER OF VEHICLE MODELS SINCE 1991 ON BOTH THE N AND J-PLATFORMS.HOWEVER, THE 1994-1995 N-PLATFORM IS OVER REPRESENTED ACCOUNTING FOR 83 (81%) OF THE COMBINDED TOTAL OF 102 REPORTS DESPITE BEING ONLY 14.2% OF THE COMBINED POPULATION. OF THE 10 NEW REPORTS RECEIVED SINCE OPENING EA99-063, 7 INCLUDE ALLEGATIONS OF A NO START CONDITION WHEN ATTEMPTING TO ENGAGE THE STARTER.A FIRE IS CLAIMED TO HAVE ENSUED IN THE STEERING COLUMN IMMEDIATELY THERAFTER.GM ISSUED A TECHNICAL SERVICE BULLETIN (TSB) (NO. 433203) JULY 1994 WHIICH ADDRESSED OWNER COMPLAINTS THAT THE IGNITION SWITCH MAY NOT RETURN TO THE RUN POSITION AFTER THE VEHICLE HAS STARTED.THE TSB ADVISES THAT THE IGNITION SWITCH MOUNTING SCREWS MAY BE EXCESSIVELY TORQUED RESULTING IN DISTORTION OF THE SWITCH HOUSING.AN ENGINEERING ANALYSIS IS WARRANTED TO DETERMINE THE ROOT CAUSE(S) AND TO DETERMIN IF A SAFETY DEFECT EXISTS.